Nanocrystalline TiO2/SnO2 heterostructures for gas sensing.

The aim of this research is to study the role of nanocrystalline TiO2/SnO2 n-n heterojunctions for hydrogen sensing. Nanopowders of pure SnO2, 90 mol % SnO2/10 mol % TiO2, 10 mol % SnO2/90 mol % TiO2 and pure TiO2 have been obtained using flame spray synthesis (FSS). The samples have been characterized by BET, XRD, SEM, HR-TEM, Mössbauer effect and impedance spectroscopy. Gas-sensing experiments have been performed for H2 concentrations of 1-3000 ppm at 200-400 °C. The nanomaterials are well-crystallized, anatase TiO2, rutile TiO2 and cassiterite SnO2 polymorphic forms are present depending on the chemical composition of the powders. The crystallite sizes from XRD peak analysis are within the range of 3-27 nm. Tin exhibits only the oxidation state 4+. The H2 detection threshold for the studied TiO2/SnO2 heterostructures is lower than 1 ppm especially in the case of SnO2-rich samples. The recovery time of SnO2-based heterostructures, despite their large responses over the whole measuring range, is much longer than that of TiO2-rich samples at higher H2 flows. TiO2/SnO2 heterostructures can be intentionally modified for the improved H2 detection within both the small (1-50 ppm) and the large (50-3000 ppm) concentration range. The temperature Tmax at which the semiconducting behavior begins to prevail upon water desorption/oxygen adsorption depends on the TiO2/SnO2 composition. The electrical resistance of sensing materials exhibits a power-law dependence on the H2 partial pressure. This allows us to draw a conclusion about the first step in the gas sensing mechanism related to the adsorption of oxygen ions at the surface of nanomaterials.

Biopolymeric hydrogels - nanostructured TiO2 hybrid materials as potential injectable scaffolds for bone regeneration.

The present work aims at development of novel hybrid materials from genipin crosslinked collagen or collagen/chitosan hydrogels containing various types of TiO2 nanoparticles characterized with different anatase/rutile ratios. Collagen and chitosan were selected as hydrogel components since they are biopolymers being, like collagen, the major compound present in extracellular matrix or exhibit structural similarity to glycosaminoglycans, like chitosan. TiO2 nanoparticles were introduced to the hydrogel matrices to improve their mechanical properties as well as bioactivity. A series of twelve novel hybrid materials were prepared and their physicochemical, mechanical and biological properties were evaluated. It was found that TiO2 nanostructures introduced to the hydrogels have significant influence on the swelling properties of the synthesized hybrids and their impact is strongly dependent on the type of matrices. The surfaces of hybrid materials were found to be more hydrophilic than these of corresponding hydrogel matrix. It was also observed that, the storage modulus values of the hybrids based on collagen-chitosan hydrogel are comparable to these for plain hydrogels what indicates that the mechanical properties of the materials obtained are satisfactory for possible biomedical application. The in vitro cell culture studies have shown that prepared materials are biocompatible as they can support mitochondrial activity of MEFs as well as MG-63 cells. In vitro experiments performed under simulated body fluid (SBF) conditions have revealed that all studied TiO2 nanoparticles present in hydrogel matrices, regardless of anatase/rutile ratio, successfully induced formation of apatite-like structures. The hybrid materials developed here are promising candidates for preparation of bioactive, injectable scaffolds for tissue engineering.

Nanostructured TiO2-based gas sensors with enhanced sensitivity to reducing gases.

2D TiO2 thin films and 3D flower-like TiO2-based nanostructures, also decorated with SnO2, were prepared by chemical and thermal oxidation of Ti substrates, respectively. The crystal structure, morphology and gas sensing properties of the TiO2-based sensing materials were investigated. 2D TiO2 thin films crystallized mainly in the form of rutile, while the flower-like 3D nanostructures as anatase. The sensor based on the 2D TiO2 showed the best performance for H2 detection, while the flower-like 3D nanostructures exhibited enhanced selectivity to CO(CH3)2 after sensitization by SnO2 nanoparticles. The sensor response time was of the order of several seconds. Their fast response, high sensitivity to selected gas species, improved selectivity and stability suggest that the SnO2-decorated flower-like 3D nanostructures are a promising material for application as an acetone sensor.