The Maxillary Nerve Block in Cleft Palate Care: A Review of the Literature and Expert's Opinion on the Preferred Technique of Administration.

INTRODUCTION: Although the maxillary nerve block (MNB) provides adequate pain relief in cleft palate surgery, it is not routinely used globally, and reported techniques are heterogeneous. This study aims to describe relevant anatomy and to present the preferred technique of MNB administration based on the current literature and the expert opinion of the authors. METHOD AND MATERIALS: First, a survey was sent to 432 registrants of the International Cleft Palate Master Course Amsterdam 2023. Second, MEDLINE (PubMed interface) was searched for relevant literature on maxillary artery (MA) anatomy and MNB administration in pediatric patients. RESULTS: Survey response rate was 18% (n=78). Thirty-five respondents (44.9%) used MNB for cleft palate surgery before the course. A suprazygomatic approach with needle reorientation towards the ipsilateral commissure before incision was most frequently reported, mostly without the use of ultrasound. Ten and 20 articles were included on, respectively, MA anatomy and MNB administration. A 47.5% to 69.4% of the MA's run superficial to the lateral pterygoid muscle and 32% to 52.5% medially. The most frequently described technique for MNB administration is the suprazygomatic approach. Reorientation of the needle towards the anterior aspect of the contralateral tragus appears optimal. Needle reorientation angles do not have to be adjusted for age, unlike needle depth. The preferred anesthetics are either ropivacaine or (levo)bupivacaine, with dexmedetomidine as an adjuvant. CONCLUSION: Described MNB techniques are heterogeneous throughout the literature and among survey respondents and not routinely used. Further research is required comparing different techniques regarding efficacy and safety.

A three-dimensional algorithm for precise measurement of human auricle parameters.

Measurement of auricle parameters for planning and post-operative evaluation presents substantial challenges due to the complex 3D structure of the human auricle. Traditional measurement methods rely on manual techniques, resulting in limited precision. This study introduces a novel automated surface-based three-dimensional measurement method for quantifying human auricle parameters. The method was applied to virtual auricles reconstructed from Computed Tomography (CT) scans of a cadaver head and subsequent measurement of important clinically relevant aesthetical auricular parameters (length, width, protrusion, position, auriculocephalic angle, and inclination angle). Reference measurements were done manually (using a caliper and using a 3D landmarking method) and measurement precision was compared to the automated method. The CT scans were performed using both a contemporary high-end and a low-end CT scanner. Scans were conducted at a standard scanning dose, and at half the dose. The automatic method demonstrated significantly higher precision in measuring auricle parameters compared to manual methods. Compared to traditional manual measurements, precision improved for auricle length (9×), width (5×), protrusion (5×), Auriculocephalic Angle (5-54×) and posteroanterior position (23×). Concerning parameters without comparison with a manual method, the precision level of supero-inferior position was 0.489 mm; and the precisions of the inclination angle measurements were 1.365 mm and 0.237 mm for the two automated methods investigated. Improved precision of measuring auricle parameters was associated with using the high-end scanner. A higher dose was only associated with a higher precision for the left auricle length. The findings of this study emphasize the advantage of automated surface-based auricle measurements, showcasing improved precision compared to traditional methods. This novel algorithm has the potential to enhance auricle reconstruction and other applications in plastic surgery, offering a promising avenue for future research and clinical application.

The Intrarater and Interrater Reliability of the OMT Classification Among Physicians With a Different Background.

BACKGROUND: The Oberg-Manske-Tonkin (OMT) classification established excellent reliability scores in several validation studies. However, one study published in 2022 found much lower scores in a subanalysis of their sample when very simple anomalies were excluded. Our study assessed the reliability of the OMT among physicians with a different background, all involved in congenital hand anomaly care, and analyzed codes with less agreement. Time required for classification was recorded to give an indication on its usability. METHODS: One hundred digital cases were classified twice with a minimal 1-month time interval, with the use of the 2020 version of the OMT. Two pediatric hand surgeons, 2 rehabilitation specialists, and 2 plastic surgery residents participated in this reliability analysis. The use of multiple codes was allowed. The intra- and interrater reliability was assessed for all 15 possible rater couples by calculating percentage of agreement. Cohen's kappa was calculated along with a 95% confidence interval. For the analysis of individual codes with less agreement, we calculated positive agreement with the use of a summed agreement table. Time necessary for classification was documented in seconds. RESULTS: The inter- and intrarater agreement was moderate with a mean Cohen's kappa of 0.45 and 0.60 retrospectively. On average, 39 seconds per case were necessary for the first and 24 seconds for the second rating. Background did not influence the level of agreement. Lowest agreement levels (ie, lowest positive agreement) were observed with all the arthrogryposis multiplex congenita subgroups, the "other" subgroups of isolated congenital contractures, syndromic syndactyly, and synpolydactyly. Codes commonly used interchangeably were symbrachydactyly and transverse deficiency and the distinction between these anomalies of only the hand or the entire upper limb; symbrachydactyly and brachydactyly; and camptodactyly and distal arthrogryposis. CONCLUSIONS: Our study showed a moderate reliability, emphasizing the complexity of this heterogeneous patient population. Despite its imperfections, the OMT remains the best and most versatile classification tool at hand. Its main purpose may lie in contributing to a universal language for research. LEVEL OF EVIDENCE: I.

Improving patient care by virtual case discussion between plastic surgeons and residents of Uganda and the Netherlands.

INTRODUCTION: Traditional on-site missions of plastic surgeons from "high-income countries" in "low- and middle-income countries" are often limited in time and lack proper follow-up. Regular digital collaboration could lead to a more impactful and durable exchange of knowledge for plastic surgeons and residents in both settings. AIMS: The aim of this study was to evaluate the satisfaction of the first twelve months of weekly digital meetings, explore advantages/disadvantages, and to provide tools for similar initiatives. METHODS: Weekly meetings started from August 2021. An encrypted digital connection allowed residents and plastic surgeons from Uganda and the Netherlands to discuss cases for educational purposes, where treatment options were considered. After twelve months, a survey was sent to participants from both countries to indicate the meetings' strengths, weaknesses, and possible improvements. RESULTS: A total of 18 participants responded to the questionnaire (ten plastic surgeons, six residents, and two researchers). The strengths of the meetings were the accessibility of the meetings, knowledge exchange and practice for residents' final exams. Possible improvements included having a clear format for patient discussion, a session moderator and better internet connectivity. Moreover, a database to assess the impact of the given intervention on the patient cases by evaluating postoperatively (e.g. three months), could further improve clinical care. CONCLUSIONS: Virtual patient discussions subjectively contributed to medical education at both locations. Improved digital infrastructure and a collaborative database could further maximize learning capacity. Furthermore, digital proctoring is a promising way to establish sustainable collaborations between high- and low-resource countries.