Sustentaculum tali in Chinese population: anatomy and clinical significance.

BACKGROUND: Previous studies lacked adequate quantitative data on sustentaculum tali (ST), especially in Chinese population. The aims of this study are to explore the quantitative morphology of ST in dried bone specimens, and to discuss its implications related to ST screw fixation, talar articular facet variation, as well as subtalar coalitions. METHODS: A total of 965 dried intact calcanei from Chinese adult donors were evaluated. All linear parameters were measured by two observers with a digital sliding vernier caliper. RESULTS: Most parts of ST body can accommodate a commonly-used 4-mm-diameter screw, but the minimum height of anterior ST is only 4.02 mm. The shapes of the STs are slightly affected by left-right, subtalar facet, but the subtalar coalition may potentially increase the sizes of STs. The incidence of tarsal coalition is 14.09%. Among the osseous connection, there are 58.8% of type A articular surface and 76.5% of middle and posterior talar facet (MTF and PTF) involvement. ROC curve shows that subtalar coalition will be detected when ST length is greater than 16.815 mm. CONCLUSIONS: Theoretically, all the STs can accommodate 4 mm diameter screw, but a 3.5 mm diameter screw is recommended to be placed in the middle or posterior of the small ST for safety. The shapes of the STs are greatly influenced by the subtalar coalition, while they are less affected by left-right, subtalar facet. The osseous connection is common in type A articular surface and always involved in the MTF and PTF. The cut-off value of the length of STs was confirmed as 16.815 mm for predicting subtalar coalition.

Anatomical parameters of sustentaculum Tali screw placement in the Asian population: A retrospective radio-anatomical study.

Purpose: This study aimed to determine the anatomical parameters of successful Sustentaculum Tali (ST) screw placement in the Asian population. Method: CT scans of unilateral feet of 110 participants were reviewed, retrospectively. The 3 D reconstruction of the calcaneus and morphometric measurements were performed by Mimics Research 19.0 and 3-Matic Research 11.0. Finally, six cadaveric feet were used for verification of the accuracy of the measurements. Results: We discovered a method to help place ST screw successfully: (1) The entry point located at the middle section of the lateral wall of posterior talar articular surface (PTAS), and the perpendicular distance from the entry point to the lateral edge of PTAS (PDEL) was 10.78 mm, (2) Screw was perpendicular to the z-axis, 66.98° to the y-axis (the longitudinal axis of the foot), (3) The length of the ST screw should be approximately 44.74 mm in male and 41.14 mm in female, and (4) The diameter of the ST screw should be approximately 4.0 mm in male and 3.5 mm in female. With this new method, all screws in six cadaveric feet were placed successfully into the middle of ST. Conclusions: In this study, we discovered a general approach to safely place ST screws in the Asian population, which may potentially help surgeons improve their success rate in surgical practice.

Classification and Morphological Parameters of the Scapular Spine: Implications for Surgery.

Incidence of scapular spine (SS) fractures as a result of complications of reverse total shoulder arthroplasty is relatively high leading to inferior clinical outcomes and an increased risk of revision and dislocation. Fractures of SS because of trauma, including the acromion, constitute 6% to 23% of scapula fractures. The purpose of this study was to classify the SS and present specific geometrical parameters according to osteologic features. A total of 319 intact dry scapulae were collected and classified based on morphological characteristics and shape of the SS. Nine bony landmarks were also chosen and described for their relevance to regions of interest for scapular fixation. Five specific types of SS were noted and the most prevalent groups were Type 1 (Fusiform shape) (47.17%) and Type 5 (Horizontal S-shape) (19.18%). Overall, Types 3, 4, and 1 showed thicker landmark values compared to Type 5, with Type 2 having smaller values. Our classification into 5 distinct types allowed appreciation of the anatomical variance of SSs. The contours of Types 5 and 1 presented a more complex morphology and may lead to a worse surgical approach due to a fracture. As Types 2 and 5 were much thinner than the other types, these may be more susceptible to fractures.

A cadaveric study on sacroiliac joint injection.

The scope of this study was to explore the possibility as well as the feasibility of sacroiliac joint injection following simple X-ray clip location. For the cadaveric study, 10 fixed sacroiliac joint (SIJ) sectional specimens, 4 dried cadaveric pelvises and 21 embalmed adult cadaveric pelvises were dissected, followed by an injection of contrast agent into the joint. The irrigation of the agent was observed through CT scanning. For the radiologic study, 188 CT scans of ankylosing spondylitis patients (143 male, 45 female) were collected from 2010 to 2012, in Nanfang Hospital. What was measured was (1) Distance between the posterior midline and sagittal synovium; (2) Length of the sagittal synovium; (3) Distance between the midpoint of the sagittal synovium and posterior superior iliac spine; and (4) Distance between the superficial skin vertical to the sagittal synovium point were measured. For the practice-based study: 20 patients (17 males and 3 females) with early ankylosing spondylitis, from Nanfang Hospital affiliated with Southern Medical University were recruited, and sacroiliac joint unguided injections were done on the basis of the cadaveric and radiologic study. Only the inferior 1/3(rd) portion parallel to the posterior midline could be injected into since the superior 2/3(rd) portion were filled with interosseous ligaments. Thirteen of the 20 patients received successful injections as identified by CT scan using the contrast agent. Sacroiliac joint injection following simple X-ray clip location is possible and feasible if the operation is performed by trained physicians familiar with the sacroiliac joint and its surrounding anatomic structures.