Microwave-induced combustion for further determination of potentially toxic elements in honey by ICP-MS.

Microwave-induced combustion (MIC) was proposed in this study for honey decomposition aiming for As, Cd, Hg, and Pb determination by inductively coupled plasma mass spectrometry (ICP-MS). Sample mass (up to 1.0 g), absorbing solution (0.5 to 14.4 mol L-1 HNO3, and H2O), heating program, and combustion aids were evaluated. The Eurachem guidelines were used for method validation. The proposed method enabled combustion of a high sample mass (0.8 g of honey, with 0.4 g of microcrystalline cellulose and 100 µL of 6 mol L-1 NH4NO3) using 6 mL of an absorbing solution consisting of 1 mol L-1 HNO3, which resulted in low residual carbon in solution (< 25 mg L-1). Honey samples from different geographical origins were analyzed. Results showed no significant difference in comparison to other two microwave decomposition methods, based on microwave-assisted wet digestion with single reaction chamber (MAWD-SRC) and microwave-assisted wet digestion (MAWD). Standard addition experiments resulted in recoveries higher than 98%. The limits of detection ranged from 1.10 (As) to 4.60 ng g-1 (Pb). In addition to using only diluted reagents and resulting in digests virtually free of interferences, the proposed method was faster (< 30 min) than most of those presented in the literature.

Low cost sample preparation method using ultrasound for the determination of environmentally critical elements in seaweed.

In this study, ultrasound (US) was evaluated for As, Cd, Pb, Mn, Sr and V extraction from seaweed samples. The following parameters of ultrasound-assisted extraction (UAE) using an US bath were: frequency (25 to 130 kHz), amplitude (30 to 100%), temperature (30 to 80 °C), sample mass (50 to 200 mg), extractant concentration (1 to 3 mol L-1 of HNO3) and treatment time (5 to 30 min). Acoustic density and power density distribution were calculated using the calorimetric method and mapping of the acoustic pressure distribution was also evaluated. The optimized UAE conditions were 200 mg of sample in 10 mL of 2 mol L-1 HNO3 and 30 min of sonication in a 25 kHz US bath (37.2 ± 4.0 W L-1) at 70% of amplitude and 70 °C. Analytes were quantified using inductively coupled plasma mass spectrometry and results were compared with values obtained using "silent" conditions (magnetic or mechanical stirring at 500 rpm, and without stirring), and a reference method based on microwave-assisted wet digestion (MAWD). The UAE method demonstrated the best extraction efficiency (higher than 95%) for all analytes, especially for As, Cd and V, with lower standard deviations (up to 5%) and lower blank values in comparison with the silent conditions. The proposed UAE method was more advantageous than the reference method, being faster, simpler, safer, more environmentally friendly, and with higher detectability (lower limits of quantification, from 0.0033 to 1.34 µg g-1). In addition, negligible blank values were obtained for UAE and no interference were observed in the determination step. Furthermore, the optimized UAE method was applied for Antarctic seaweed samples and comparison with results obtained by MAWD was satisfactory. In this sense, UAE is demonstrated to be a suitable option for sample preparation of seaweed samples and further determination of environmentally critical elements avoiding the use of concentrated reagents as in the MAWD reference method.

A single step ultrasound-assisted nitrocellulose synthesis from microcrystalline cellulose.

Nitrocellulose is a nitrated cellulose polymer with a broad application in industry. Depending on the nitrogen content, this polymer can be used for manufacturing explosives, varnishes, clothes, and films, being considered a product of high value-added. In this work, the use of ultrasound was investigated for the intensification of nitrocellulose synthesis from microcrystalline cellulose. The ultrasound-assisted nitrocellulose synthesis (UANS) was carried out using several ultrasound systems, such as baths and cup horns, allowing the evaluation of the frequency (from 20 to 130 kHz) and delivered power (from 23 to 134 W dm-3) to the reaction medium. The following parameters were evaluated: acid mixture (H2SO4, H3PO4, CH2O2 or CH3COOH with HNO3, 2 to 14.4 mol L-1), ultrasound amplitude (10 to 70%) and reaction time (5 to 50 min). Better nitrocellulose yield (nitrogen content of 12.5% was obtained from 1 g of microcrystalline cellulose employing a cup horn system operating at 20 kHz, 750 W of nominal power with 60% of amplitude, 25 mL of acid solution (13.6 mL of 18.4 mol L-1 H2SO4 + 9.2 mL of 14.4 mol L-1 HNO3 + 2.2 mL H2O), at 30 °C for 30 min. At silent conditions (mechanical stirring ranging from 100 to 500 rpm), the nitrogen content was lower than 11.8% which demonstrate the ultrasound effects for nitrocellulose synthesis.

A selective volatilization method for determination of chloride and sulfate in calcium carbonate pharmaceutical raw material and commercial tablets.

In this work a feasible method for chloride and sulfate determination in calcium carbonate pharmaceutical raw material and commercial tablets by ion chromatography after microwave-induced combustion was developed. The analytes were released from matrix by combustion in closed system pressurized with oxygen. Starch as volatilization aid, 100mmolL-1 HNO3 as absorbing solution and 5min of microwave irradiation time were used. Recovery tests using standard solutions were performed for the accuracy evaluation. A mixture of calcium carbonate pharmaceutical raw material or commercial tablets, starch and a certified reference material was also used as a type of recovery test. Recoveries ranging from 88% to 103% were obtained in both spike tests. Limits of detection (Cl-: 40µgg-1 and SO42-: 140µgg-1) were up to eighteen times lower than the maximum limits established for the analytes by Brazilian, British, European and Indian Pharmacopoeias. The limit tests recommended by the European Pharmacopoeia for Cl- and SO42- in CaCO3 were carried out to compare the results. Chloride and SO42- concentrations in the samples analyzed by proposed method were in agreement with those results obtained using the tests recommended by the European Pharmacopoeia. However, the proposed method presents several advantages for the routine analysis when compared to pharmacopoeial methods, such as the quantitative simultaneous determination, high sample preparation throughput (up to eight samples per run in less than 30min), reduced volume of reagents and waste generation. Thus, the proposed method is indicated as an excellent alternative for Cl- and SO42- determination in CaCO3 pharmaceutical raw material and commercial tablets.

Intensification of ultrasonic-assisted crude oil demulsification based on acoustic field distribution data.

Water removal is an essential step during crude oil production due to several problems such as increased transportation costs and high corrosion rate due to dissolved salts. Indirect low frequency ultrasonic energy (US), using baths, has been recently proposed as an effective alternative for crude oil demulsification. However, the reactor position during sonication and its influence on the demulsification efficiency for crude oil has not been evaluated. In this sense, the aim of this study was to develop an automated system based on an open source hardware for mapping the acoustic field distribution in an US bath operating at 35kHz using a hydrophone. Data acquired with this system provided information to evaluate the demulsification efficiency in the different positions of the US bath and correlate it with the acoustic intensity distribution. The automated 3D-mapping system revealed a higher acoustic intensity in the regions immediately above the transducers (ca. 0.6Wcm-2), while the other regions presented a relatively lower intensity (ca. 0.1Wcm-2). Experimental data demonstrated that reactors positioned in the most intense acoustic regions provided a much higher efficiency of demulsification in comparison with the ones positioned in the less intense acoustic field regions. Demulsification efficiency up to 93% was obtained with 15min of sonication (100% amplitude) using few amount of chemical demulsifier. Hence, this work demonstrated that the information acquired with the developed mapping system could be used for inducing a higher efficiency of demulsification only by finding the more suitable position of reactor in the US bath, which certainly will help development of appropriate reactors design when looking for such approach.

Sample preparation methods for subsequent determination of metals and non-metals in crude oil--a review.

In this review sample preparation strategies used for crude oil digestion in last ten years are discussed focusing on further metals and non-metals determination. One of the main challenges of proposed methods has been to overcome the difficulty to bring crude oil samples into solution, which should be compatible with analytical techniques used for element determination. On this aspect, this review summarizes the sample preparation methods for metals and non metals determination in crude oil including those based on wet digestion, combustion, emulsification, extraction, sample dilution with organic solvents, among others. Conventional methods related to wet digestion with concentrated acids or combustion are also covered, with special emphasis to closed systems. Trends in sample digestion, such as microwave-assisted digestion using diluted acids combined with high-efficiency decomposition systems are discussed. On the other hand, strategies based on sample dilution in organic solvents and procedures recommended for speciation analysis are reported as well as the use of direct analysis in view of the recent importance for crude oil field. A compilation concerning sample preparation for crude oil provided by official methods as well as certified reference materials available for accuracy evaluation is also presented and discussed.

Algae of economic importance that accumulate cadmium and lead: a review

Currently, algae and algae products are extensively applied in the pharmaceutical, cosmetic and food industries. Algae are the main organisms that take up and store heavy metals. Therefore, the use of compounds derived from algae by the pharmaceutical industry should be closely monitored for possible contamination. The pollution generated by heavy metals released by industrial and domestic sources causes serious changes in the aquatic ecosystem, resulting in a loss of biological diversity and a magnification and bioaccumulation of toxic agents in the food chain. Since algae are at the bottom of the aquatic food chain, they are the most important vector for transfer of pollution to upper levels of the trophic chain in aquatic environments. Moreover, microalgae are also used for the bioremediation of wastewater, a process that does not produce secondary pollution, that enables efficient recycling of nutrients and that generates biomass useful for the production of bioactive compounds and biofuel.

Bioaccumulation and oxidative stress parameters in silver catfish (Rhamdia quelen) exposed to different thorium concentrations.

The objective of this study was to evaluate the effect of chronic thorium (Th) exposure on bioaccumulation, metabolism (through biochemical parameters of the muscle) and oxidative parameters (lipidic peroxidation levels and antioxidant enzymes in the gills and in the hepatic and muscular tissues) of silver catfish (Rhamdia quelen). Silver catfish juveniles were exposed to different waterborne Th levels (in microg L(-1)): 0 (control), 25.3+/-3.2, 80.6+/-12.0, 242.4+/-35.6, and 747.2+/-59.1 for 30 d. The gills and skin were the organs that accumulated the highest Th levels. The increase in the waterborne Th concentration corresponded to a progressive increase in the Th levels in the gills and kidney. Chronic Th exposure causes alterations in the oxidative parameters of silver catfish gills, which are correlated with the Th accumulation in this organ. The levels of GST decreased in the gills of fish exposed to 747.2 microg L(-1) Th and SOD activity decreased in silver catfish exposed to 242.4 and 747.2 microg L(-1) Th. In addition, the increase in the LPO in the gills exposed to 242.4 and 747.2 microg L(-1) Th suggests that higher oxidative damage occurred in the gills. However, in the liver and muscle, these alterations occurred mainly in the lowest waterborne Th level. Metabolic intermediates in the muscle were altered by Th exposure, but no clear relationship was found.

Protective effect of high alkalinity against the deleterious effects of chronic waterborne cadmium exposure on the detection of alarm cues by juvenile silver catfish (Rhamdia quelen).

The objective of the present study was to analyze the effect of chronic cadmium (Cd) exposure at two alkalinity levels (63 and 92 mg l(-1) CaCO(3)) on the antipredatory behavior of juvenile silver catfish (Rhamdia quelen) exposed to conspecific skin extract and predator odor. At an alkalinity of 63 mg l(-1) CaCO(3), 30 days of exposure to either 4.5 or 8.0 microg l(-1) Cd impaired the catfish's antipredatory response to alarm cues. However, silver catfish exposed to 4.5 microg l(-1) Cd at an alkalinity of 92 mg l(-1) CaCO(3) responded to skin extract and predator odor. In catfish exposed to 8.0 microg l(-1) Cd at the same alkalinity, only the number of feeding bites decreased, and this occurred only for specimens exposed to predator odor. Our results show that higher alkalinity protected against the deleterious effects of Cd on alarm cue detection but only in the larvae exposed to the lowest waterborne Cd level.

Biochemistry, cytogenetics and bioaccumulation in silver catfish (Rhamdia quelen) exposed to different thorium concentrations.

The objective of this study was to evaluate the effect of thorium (Th) bioaccumulation on the metabolism of silver catfish (Rhamdia quelen) through biochemical parameters of the muscle (glycogen, glucose, lactate, protein, and ammonia). In addition, lipidic peroxidation levels (TBARS), catalase (CAT) and glutathione-S-transferase (GST) in the gills and in hepatic and muscular tissues were also analyzed. Cytogenetic parameters were studied through the evaluation of nuclear abnormalities in red blood cells. Silver catfish juveniles were exposed to different waterborne Th levels (in microg L(-1)): 0 (control), 25.3+/-3.2, 69.2+/-2.73, 209.5+/-17.6, and 608.7+/-61.1 for 15 days. The organs that accumulated the highest Th levels were the gills and skin. The increase of waterborne Th concentration corresponded to a progressive increase of Th levels in the gills, liver, skin and kidneys, with the highest accumulation in the gills and skin. Metabolic intermediates in the muscle were altered by Th exposure, but no clear relationship was found. CAT and GST activities in the hepatic and muscular tissues of this species suggest that the enzymatic activities can be stimulated at the lowest Th levels and inhibited at the higher levels (mainly in 608.7 microg L(-1)). The results of the cytogenetic assay contribute to this hypothesis because the higher toxicity in blood samples was found in juveniles exposed to 69.2 and 209.5 microg L(-1) Th.