Polyaniline-silica doped with oxalic acid as a novel extractor phase in thin film solid-phase microextraction for determination of hormones in urine.

In this study, different polyanilines were synthesized and evaluated for the determination of three hormones, including 17-ß-estradiol, 17-α-ethinylestradiol, and estrone, in urine using a novel methodology based on thin film solid-phase microextraction technique, employing the sampling well plate system. The extractor phases, designated as polyaniline doped with hydrochloric acid, polyaniline doped with oxalic acid, polyaniline-silica doped with hydrochloric acid, and polyaniline-silica doped with oxalic acid, were characterized by electrical conductivity measurements, scanning electron microscopy, and Fourier transform infrared spectroscopy. The optimized extraction conditions were composed of 1.5 mL of urine and pH adjusted to 10, with no need to dilute sample and the desorption step, 300 µL of acetonitrile was used. The calibration curves were performed in the sample matrix, with detection and quantification limits ranged from 0.30 to 3.03 µg L-1 and from 1.0 to 10.0 µg L-1 , respectively, with r ≥ 0.9969. The relative recoveries ranged from 71% to 115%, and intraday precision showed values ≤12% and interday ≤20%. The applicability of the method was successfully evaluated, and six urine samples from female volunteers were analyzed. The analytes were not detected or were below the limits of quantification in these samples.

Determination of hormones in urine by hollow fiber microporous membrane liquid-liquid extraction associated with 96-well plate system and HPLC-FLD detection.

In this work, hollow-fiber microporous membrane liquid-liquid extraction (HF-MMLLE) was associated with a 96-well plate system for the determination of estrone, 17-ß-estradiol, estriol and 17-α-ethinylestradiol in urine samples. This method exhibited some advantages, such as low cost, easy application, high-throughput and environmentally-friendly aspects. The type of organic solvent to fill the membrane, ionic strength effect, sample dilution, extraction and desorption time, and desorption solvent were examined. After the optimizations, the conditions were comprised of 45 min of extraction, 1-octanol as organic solvent and 15% (w/v) of NaCl; methanol was used as desorption solvent, and the desorption time was fixed at 10 min. The dilution of the sample increased the sensitivity due to the reduction of matrix effects; thus, urine samples were diluted 40-fold. The limits of detection ranged from 0.03 µg L-1 for 17-ß-estradiol to 15 µg L-1 for estrone, and the limits of quantification ranged from 0.1 µg L-1 for 17-ß-estradiol to 10 µg L-1 for estrone. The intra-day precision varied from 1.0% for estriol to 13.3% for 17-α-ethinylestradiol, and inter-day precision varied from 7.3% for estrone to 18.1% for estriol. The relative recoveries varied from 82 to 118%.

Multiclass determination of endocrine disruptors in urine by hollow fiber microporous membrane and liquid chromatography.

A simple and rapid methodology was developed using hollow fiber membrane microporous and a 96-well plate system for a high throughput multiclass determination of endocrine disruptors in human urine (diclofenac, diazepam, carbamazepine, ibuprofen, naproxen, carbofuran, methyl parathion, 17-α-ethynyl estradiol, bisphenol A and benzophenone). The quantification and detection of the chemicals were carried out by an HPLC-diode array detector. The fixed conditions for carrying out the method optimization were 1.5 mL of sample and 300 µL of solvent desorption. Multivariate and univariate models were applied to optimize the parameters of the method, achieving the following conditions: 20% diluted urine, 1-octanol of extraction solvent impregnated in the microporous membrane, 70 min extraction in pH 3.0 and 30 min with a mixture of 75% methanol and 25% acetonitrile (v/v) for the desorption. The R2 were ≤ 0.9973 for ibuprofen. The LOD ranged from 3.3 to 16.7 ng mL-1 and the LOQ from 10 to 50 ng mL-1. Relative recoveries ranged from 71% to 126%. The repeatability (n = 3) ranged from 0.22% to 12.01%, and the intermediate precision (n = 9) ranged from 0.13% to 17.76%. The method presents a good alternative for the determination of different classes of compounds in human urine.

Exploring the use of cork pellets in bar adsorptive microextraction for the determination of organochloride pesticides in water samples with gas chromatography/electron capture detection quantification.

In this study, a biosorbent material with characteristics for the adsorption of organic compounds was used for a cork pellet-based bar adsorptive microextraction technique, as a new greener alternative for the determination of organochlorine compounds. Aldrin, chlordane, dieldrin, endrin, lindane, 4,4-DDD, 4,4-DDE, 4,4-DDT, α-endosulfan and ß-endosulfan were analyzed in water samples (drinking water, stream water and river water) with separation/detection by gas chromatography and electron capture detection (GC/ECD). The parameters that can affect the sample preparation efficiency such as desorption solvent and time as well as extraction time and ionic strength were evaluated by multivariate and univariate designs. Cork pellets (10  ×  Ø 3 mm) were used for the extraction of 15 mL of sample in the optimal conditions: 60 min of agitation with no salt added to the sample, followed by desorption of the cork pellet with 120 µL of ethyl acetate for 30 min. The bar-to-bar RSD out with five different bars showed good results with RSD ≤ 15.6%, allowing the use of simultaneous extractions. LOD and LOQ values ranged from 3 to 15 ng L-1 and 10 to 50 ng L-1 respectively, and the determination coefficients were greater than 0.9869. The target analytes were not detected in the three analyzed samples. Therefore, the recovery study was performed fortifying the water samples. Analyte recovery ranged from 48.7 - 138.2% for drinking water, 40.2 - 128.2% for stream water and 67.5 - 128.7% for river water.

A green - high throughput -extraction method based on hydrophobic natural deep eutectic solvent for the determination of emerging contaminants in water by high performance liquid chromatography - diode array detection.

This study reports the use ofa natural deep eutectic solvent (NADES) with hollow fiber-microporous membrane liquid-liquid microextraction (HF-MMLLE) for the multiclass determination of 11 compounds classified as emerging contaminantsin water. Different deep eutectic solvents were synthetized and Thymol: Camphor (1:1 molar fraction) wasused as extraction solvent. The Thymol:Camphor was impregnated into the polypropylene membrane porous for 10 min, replacing commonly used solvents (ex. hexane and octanol). The optimized parameters were obtained by multi and univariate models. Extractions were carried out for 50 min using 1.5 mL of water sample at pH 6 and without addition of salt while desorption was made in a mixture of acetone: methanol (3:1, v/v) for 15 min. Separation/quantification was conducted by HPLC with a diode array detection (DAD)and calibration curves were obtained for each analyte. Determination coefficients higher than 0.9906 and limits of detection ranged from 0.3 to 6.1 µg L-1. Intraday precision (n = 3) ranged from 1.6 to 18.4% and inter day from 5.0 to 21.3%. Relative recoveries were performed in tap and stream water and ranged from 64 to 123%.

Evaluation of volatile profiles obtained for minimally-processed pineapple fruit samples during storage by headspace-solid phase microextraction gas chromatography-mass spectrometry

Abstract This paper describes the application of the solid-phase microextraction (SPME) technique for the determination and monitoring of the volatile profile of minimally-processed pineapple fruit stored at various temperatures (-12 °C, 4 °C and 25 °C) for different periods (1, 4 and 10 days). The SPME fiber coating composed of Car/PDMS presented the best performance. The optimal extraction conditions obtained through a Doehlert design were 60 min at 35 °C. The profiles for the volatile compounds content of the fruit at each stage of storage were determined by gas chromatography-mass spectrometry (GC-MS). The variation in the volatile profile over time was greater when the fruit samples were stored at 25 °C and at -12 °C compared to 4 °C. Thus, according to the volatile profiles associated with the storage conditions evaluated in this study, packaged pineapple retains best its fresh fruit aroma when stored at 4 °C.

A new configuration for bar adsorptive microextraction (BAµE) for the quantification of biomarkers (hexanal and heptanal) in human urine by HPLC providing an alternative for early lung cancer diagnosis.

In this paper, a remodeling of the bar adsorptive microextraction (BAµE) technique is proposed with impregnation of the derivatization reagent on the surface of the adsorptive bar containing a biosorbent material. The derivatization reagent was 2,4-dinitrophenylhydrazine (DNPH), which was adsorbed on the surface of the bar containing cork powder as the extractor phase for the determination of two aldehydes (hexanal and heptanal) which are known as lung cancer biomarkers in human urine samples. The derivatization reaction and the extraction occurred simultaneously on the surface of the bar (length 7.5 mm) under acidic conditions. The method optimization was carried out by univariate and multivariate analysis. The optimal conditions for the method were a DNPH to aldehydes ratio of 40:1, buffer solution of pH 4.0, extraction time of 60 min and liquid desorption of 10 min in 100 µL of acetonitrile. The aldehydes were analyzed by HPLC-DAD with a simple and fast (6 min) chromatographic run. The limits of detection (LODs) for hexanal and heptanal were 1.00 and 0.73 µmol L-1, respectively. The relative recoveries in urine samples ranged from 88 to 111% with relative standard deviations (RSDs) being less than 7%. The method developed is of low cost and can be successfully used for the quantification of these two lung cancer biomarkers in human urine samples, potentially providing an early diagnosis of lung cancer.