Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 7 de 7
Filtrar
Mais filtros











Base de dados
Intervalo de ano de publicação
1.
Polymers (Basel) ; 13(20)2021 Oct 14.
Artigo em Inglês | MEDLINE | ID: mdl-34685289

RESUMO

In this study, a novel cellulose/Ag/TiO2 nanocomposite was successfully synthesized via the hydrothermal method. The cellulose extracted from oil palm empty fruit bunch (OPEFB) could address the disposal issue created by OPEFB biomass. Characterization studies such as FESEM, EDX, HRTEM, XRD, FTIR, UV-Vis DRS, PL, XPS, and surface analysis were conducted. It was observed that the incorporation of cellulose could hinder the agglomeration, reduce the band gap energy to 3 eV, increase the specific surface area to 150.22 m3/g, and lower the recombination rate of the generated electron-hole pairs compared to Ag/TiO2 nanoparticles. The excellent properties enhance the sonocatalytic degradation efficiency of 10 mg/L Congo red (up to 81.3% after 10 min ultrasonic irradiation) in the presence of 0.5 g/L cellulose/Ag/TiO2 at 24 kHz and 280 W. The improvement of catalytic activity was due to the surface plasmon resonance effect of Ag and numerous hydroxyl groups on cellulose that capture the holes, which delay the recombination rate of the charge carriers in TiO2. This study demonstrated an alternative approach in the development of an efficient sonocatalyst for the sonocatalytic degradation of Congo red.

2.
Chemosphere ; 272: 129588, 2021 Jun.
Artigo em Inglês | MEDLINE | ID: mdl-33482519

RESUMO

Iron-doped titanium dioxide loaded on activated carbon (Fe-TiO2/AC) was successfully synthesized from oil palm empty fruit bunch (OPEFB) using sol-gel method. The properties of the synthesized pure TiO2, Fe-doped TiO2, AC, TiO2/AC and Fe-TiO2/AC were examined by various techniques such as field emission scanning electron microscopy (FE-SEM), Fourier-transform infrared spectroscopy (FT-IR), UV-Vis diffuse reflectance spectroscopy (UV-Vis DRS) and nitrogen adsorption-desorption analyses at 77 K. FE-SEM revealed that Fe-doped TiO2 particles were dispersed homogeneously on the AC surface. FT-IR demonstrated high surface hydroxylation after Fe doping on TiO2 and UV-Vis DRS showed that Fe-TiO2/AC had the lowest band gap energy. Catalytic performance results proved that Fe dopants could restrict the recombination rate of hole and electron pairs, whereas AC support improved the Malachite Green (MG) adsorption sites and active sites of the hybrid catalyst. Photocatalytic degradation of 100 mg/L MG in the presence of 1.0 g/L 15 wt% Fe-TiO2 incorporated with 25 wt% AC, initial solution pH of 4 and 3 mM H2O2 could achieve the highest removal efficiency of 97% after 45 min light irradiation. This work demonstrates a promising approach to synthesis an inexpensive and efficient Fe-TiO2/AC for the photocatalytic degradation of organic dye.


Assuntos
Carvão Vegetal , Ferro , Catálise , Frutas , Peróxido de Hidrogênio , Luz , Corantes de Rosanilina , Espectroscopia de Infravermelho com Transformada de Fourier , Titânio
3.
Data Brief ; 30: 105431, 2020 Jun.
Artigo em Inglês | MEDLINE | ID: mdl-32258286

RESUMO

Lignocellulosic biomass can provide a consistent and sustainable source of bioenergy. Degraded empty fruit bunch (DEFB) from oil palm is a suitable candidate for biofuels and biochemicals production by using alkaline ethylene glycol pretreatment and two-staged acid hydrolysis. This paper provided several important physical and chemical properties of treated DEFB after alkaline ethylene glycol pretreatment. The dataset for analysis methods which were used in two-staged acid hydrolysis for the determination of reducing sugars, phenolic compounds, furfural and hydroxymethyfurfural (HMF) in the acid hydrolysate was also provided. The key information and dataset provided in this article can be useful for researchers to determine the product compositions from lignocellulosic biomass after the pretreatment and acid hydrolysis processes in the future.

4.
Sci Total Environ ; 727: 138534, 2020 Jul 20.
Artigo em Inglês | MEDLINE | ID: mdl-32334218

RESUMO

Interest in biodiesel research has escalated over the years due to dwindling fossil fuel reserves. The implementation of a carbon-based solid acid catalyst in biodiesel production eradicates the separation problems associated with homogeneous catalysis. However, its application in the glycerol-free interesterification process for biodiesel production is still rarely being studied in the literature. In this study, novel environmentally benign catalysts were prepared from oil palm empty fruit bunch (OPEFB) derived activated carbon (AC) which is sustainable and low cost via direct sulfonation using concentrated sulfuric acid. The effects of synthesizing variables such as carbonization and sulfonation temperatures with different holding times towards the fatty acid methyl ester (FAME) yield in interesterification reaction with oleic acid and methyl acetate were investigated in detail. It was found that the optimum carbonization temperature and duration together with sulfonation temperature and duration were 600 °C, 3 h, 100 °C and 6 h, respectively. The catalyst possessed an amorphous structure with a high total acid density of 9.0 mmol NaOH g-1 due to the well-developed porous framework structure of the carbon support. Under these optimum conditions, the OPEFB derived solid acid catalyst recorded an excellent catalytic activity of 50.5% methyl oleate yield at 100 °C after 8 h with 50:1 methyl acetate to oleic acid molar ratio and 10 wt% catalyst dosage. The heterogeneous acid catalyst derived from OPEFB had shown promising properties that made them highly suitable for cost-effective and environmental-friendly glycerol-free biodiesel production.


Assuntos
Biocombustíveis , Glicerol , Catálise , Esterificação , Frutas , Óleos de Plantas
5.
Environ Sci Pollut Res Int ; 27(28): 34638-34652, 2020 Oct.
Artigo em Inglês | MEDLINE | ID: mdl-31102214

RESUMO

A novel titanium dioxide/activated carbon (TiO2/AC) composite where AC derived from oil palm empty fruit bunch (EFB) was synthesised by using sol-gel method. All the samples were characterised by using X-ray diffraction (XRD), scanning electron microscopy-energy dispersive X-ray (SEM-EDX), Fourier transformed infrared (FTIR), thermogravimetric analysis (TGA) and surface analyser. SEM analysis showed that TiO2 particles were successfully embedded and well distributed on the AC surface. The elemental composition analysis found that the TiO2/AC composite contained titanium (Ti), oxygen (O) and carbon (C) atoms. Meanwhile, the appearance of new band at about 960 cm-1 which assigned to the Ti-O stretching was observed in the FTIR spectra when the AC was incorporated into TiO2. TGA analysis showed that the weight loss of 32 wt.% from 150 to 550 °C was due to the decomposition of amorphous carbon layers and loss of hydroxyl groups on TiO2. It was found that the TiO2/AC composite had better performance in the sonocatalytic degradation of malachite green as compared to the individual AC and TiO2 because the TiO2/AC composite had dual functionality and huge number of active sites which could promote the mass transfer of dye molecules towards catalyst surface. By using 1.5 g/L of TiO2/AC composite which calcined at 700 °C on 100 mL of 200 mg/L of malachite green at solution pH of 7, a degradation efficiency of 87.11% had been achieved after 30 min of ultrasonic irradiation. A lower chemical oxygen demand (COD) removal (81.75%) was observed because the structured dye molecules underwent mineralisation process during the sonocatalytic degradation to generate intermediate compounds. The TiO2/AC composite was able to be recycled and still achieved a high degradation efficiency of 76.78% after second catalytic cycle as compared to the fresh TiO2/AC composite with degradation efficiency of 87.11%. In conclusion, the TiO2/AC composite had high reusability and promising for practical applications in textile industry.


Assuntos
Carvão Vegetal , Titânio , Catálise , Corantes , Frutas
6.
J Hazard Mater ; 390: 121532, 2020 05 15.
Artigo em Inglês | MEDLINE | ID: mdl-31843399

RESUMO

In this research, biomass from oil palm empty fruit bunch was used as the carbon precursor and sulfonated by 4-benzenediazonium sulfonate (4-BDS) to produce solid acid catalyst. The as-synthesized catalysts were characterized and the performances were tested in esterification of palm fatty acid distillate (PFAD) for biodiesel production. Scanning Electron Microscopy (SEM) showed that clear porous and rough carbon surface was successfully developed after calcination which favored the attachment of sulfonic groups. Thermogravimetric Analysis (TGA) result showed that the catalyst was thermally stable up to 600 °C. Fourier Transform Infrared Spectroscopy (FTIR) proved that SO and SO3H sulfonic groups were successfully attached to the carbon catalyst. From the catalytic activity tests, the results showed that the catalyst which was calcined at 200 °C and sulfonated with 15:1 sulfanilic acid to AC ratio was the optimum catalyst as it provided the highest biodiesel yield. Further investigation showed that the reaction time of 7 h and 20 wt.% of catalyst loading were reported as optimum esterification conditions which provided the highest biodiesel yield at 98.1 %.


Assuntos
Arecaceae , Biocombustíveis , Carvão Vegetal , Frutas , Catálise , Compostos de Diazônio/química
7.
Bioresour Technol ; 292: 121967, 2019 Nov.
Artigo em Inglês | MEDLINE | ID: mdl-31450064

RESUMO

Ethylene glycol in the presence of sodium hydroxide was utilised as pretreatment for effective delignification and reduced the recalcitrance of lignocellulosic biomass which ramified the exposure of cellulose. Two-staged acid hydrolysis was also investigated which demonstrated its synergistic efficiency by minimising the deficiency of single stage acid hydrolysis. The operating parameters including acid concentration, temperature, residence time and cellulose loading for two-staged acid hydrolysis were studied by using ethylene glycol delignified degraded oil palm empty fruit bunch (DEFB) to recover the sugar based substrates for potential biofuels and other bio-chemicals production. In this study, stage I 45 wt% acid at 65 °C for 30 min coupled with high cellulose loading 21.25 w/v% and 12 wt% acid at 100 °C for 120 min was able to release a total of 89.8% optimum sugar yield with minimal formation of degradation products including 0.058 g/L furfural, 0.0251 g/L hydroxymethylfurfural and 0.200 g/L phenolic compounds.


Assuntos
Arecaceae , Frutas , Etilenoglicol , Hidrólise , Óleo de Palmeira , Açúcares
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA