Evaluation of laboratory and environmental exposure systems for protein modification upon gas pollutants and environmental factors.

Chemical modifications of proteins induced by ambient ozone (O3) and nitrogen oxides (NOx) are of public health concerns due to their potential to trigger respiratory diseases. The laboratory and environmental exposure systems have been widely used to investigate their relevant mechanism in the atmosphere. Using bovine serum albumin (BSA) as a model protein, we evaluated the two systems and aimed to reduce the uncertainties of both the reactants and products in the corresponding kinetic study. In the laboratory simulation system, the generated gaseous pollutants showed negligible losses. Ten layers of BSA were coated on the flow tube with protein extraction recovery of 87.4%. For environmental exposure experiment, quartz fiber filter was selected as the upper filter with low gaseous O3 (8.0%) and NO2 (1.7%) losses, and cellulose acetate filter was appropriate for the lower filter with protein extraction efficiency of 95.2%. The protein degradation process was observed without the exposure to atmospheric oxidants and contributed to the loss of protein monomer mass fractions, while environmental factors (e.g., molecular oxygen and ultraviolet) may cause greater protein monomer losses. Based on the evaluation, the study exemplarily applied the two systems to protein modification and both showed that O3 promotes the protein oligomerization and nitration, while increased temperature can accelerate the oligomerization and increased relative humidity can inhibit the nitration in the environmental exposure samples. The developed laboratory and environmental systems are suitable for studying protein modifications formed under different atmospheric conditions. A combination of the two will further reveal the actual mechanism of protein modifications.

Multiphase reactions of proteins in the air: Oligomerization, nitration and degradation of bovine serum albumin upon ambient exposure.

Proteins in atmospheric aerosol can react with atmospheric pollutants such as ozone (O3) and nitrogen dioxide (NO2) in the atmosphere via the reactions of oxidation, nitration, and cross-linking etc. Currently, the reactions have been more thoroughly studied in the laboratory but rarely investigated in the ambient environment. In this study, we used bovine serum albumin (BSA) as the model protein to conduct the exposure experiment in the ambient environment in southern China, an area with increasing oxidative capacity, to investigate the reactions of proteins in the atmosphere. We observed the occurrence of oligomerization, nitration and degradation of BSA upon exposure. The mass fraction of BSA monomer decreased by 5.86 ± 1.61% after exposure and those of dimers, trimers and higher oligomers increased by 1.04 ± 0.49%, 1.37 ± 0.74% and 3.40 ± 1.06%, respectively. Simultaneously, the nitration degrees of monomers, dimers, trimers and higher oligomers increased by 0.42 ± 0.15%, 0.53 ± 0.15%, 0.55 ± 0.28% and 2.15 ± 1.01%, respectively. The results show that oligomerization was significantly affected by O3 and temperature and nitration was jointly affected by O3, temperature and relative humidity, indicating the important role of atmospheric oxidants in the atmospheric reactions of protein. Atmospheric degradation of BSA was observed with the release of free amino acids (FAAs) such as glycine, alanine, serine and methionine. Glycine was the dominant FAA with a molar yield ranging from ∼8% to 33% for BSA. The estimated stoichiometric coefficient (α) of glycine is 10-7-10-6 for the degradation of BSA upon O3. Our observation suggests the occurrence of protein reactions in the oxidative ambient environment, leading to the production of nitrated products, oligomers and low molecular weight products such as peptides and FAAs. This study may deepen the current understanding of the atmospheric reaction mechanisms and reveal the influence of environmental factors in the atmosphere.

Emission factors and source profiles of volatile organic compounds from typical industrial sources in Guangzhou, China.

Volatile organic compounds (VOCs) are important precursors of ozone (O3) and fine particulate matter (PM2.5). An accurate depiction of the emission characteristics of VOCs is the key to formulating VOC control strategies. In this study, the VOC emission factors and source profiles in five industrial sectors were developed using large-scale field measurements conducted in Guangzhou, China (100 samples for the emission factors and 434 samples for the source profile measurements). The emission factors based on the actual measurement method and the material balance method were 1.6-152.4 kg of VOCs per ton of raw materials (kg/t) and 3.1-242.2 kg/t, respectively. The similarities between the emission factors obtained using these two methods were examined, which showed a coefficient of divergence (CD) of 0.34-0.72. Among the 33 subdivided VOC source profiles developed in this study, sources including light guide plate (LGP), photoresist mask, and plastic products were the first time developed in China. Due to regional diversities in terms of production technologies, materials, and products, the emission characteristics of the VOCs varied, even in the same sector, thereby demonstrating the importance of developing localized source profiles of VOCs. The ozone formation potential (OFP) of the shipbuilding and repair sector from fugitive emissions was the highest value among all the industrial sectors. Controlling the emissions of aromatics and OVOCs was critical to reducing the O3 growth momentum in industrial sectors. In addition, 1,2-dibromoethane showed high carcinogenic risk potentials (CRPs) during most of the industrial sectors and should be prioritized for controlling.

[Vertical Distribution of Surface Formaldehyde in the Pearl River Delta Urban Area Based on Observations at the Canton Tower].

To investigate the vertical distribution of atmospheric formaldehyde in the Pearl River Delta (PRD) urban area, simultaneous measurements were performed at three heights on Canton Tower for the first time. Carbonyls including formaldehyde were sampled with 2,4-dinitrophenylhydrazin (DNPH) at noon for 32 days in autumn of 2018, and then analyzed using high-performance liquid chromatography (HPLC). Average mass concentrations of formaldehyde at ground level, 118 m, and 488 m sites at Canton Tower were (5.10±1.93), (6.61±2.84), and (5.33±2.55) µg·m-3, respectively. The measured formaldehyde was positively correlated with atmospheric oxidant Ox at the three sites (R 0.65-0.75), indicating that photochemical formation is an important source for urban formaldehyde in PRD. Three different profiles were found for formaldehyde vertical distribution during the measurements. The most frequently observed one showed a higher value at 118 m while lower ones at ground level and 488 m, occurring when the boundary layer is in moderate convection state with high photochemical reactivity. The 118 m layer may be also influenced by transported high-chimney emissions from industries in suburban areas. Vertical columns of formaldehyde were also calculated according to its vertical profile. The average value was (11.23±4.80)×1015 molecules·cm-2, 19% lower than that from satellite retrieval, while in the same magnitude as values reported in reference papers.