Decommissioning of a Medical Cyclotron Vault: The Case Study of the National Cancer Institute of Milano.

ABSTRACT: In the widespread use of medical cyclotrons for isotope production, radiological and economic consequences related to the decommissioning of particle accelerators are often neglected. However, decommissioning regulation and its related procedures always demand efforts and costs that can unexpectedly impact on budgets. The magnitude of this impact depends strongly on the residual radioactivity of the accelerator and of the vault, and more specifically on the kind and activity concentration of residual radionuclides. This work reports and discusses a case study that analyzes in detail the characterization activities needed for optimized management of the decommissioning of a medical cyclotron vault. In particular, this paper presents the activities carried out for assessing the activity concentrations and for guiding the disposal of the cyclotron vault of the Italian National Cancer Institute of Milano (INT). An unshielded 17 MeV cyclotron vault was characterized by high resolution gamma-ray spectrometry both in-situ and in-laboratory on extracted samples. Monte Carlo simulations were also carried out to assess the overall distribution of activation in the vault. After a few months from the final shutdown of the accelerator, activity concentrations in the concrete walls due to neutron activation exceeded the clearance levels in many regions, especially close to the cyclotron target. Due to the relatively long half-lives of some radionuclides, a time interval of about 20 y after the end of bombardment is necessary for achieving clearance in some critical positions. Far from the target or in positions shielded by the cyclotron, activation levels were below the clearance level. The comparison between Monte Carlo simulations and experimental results shows a good agreement. The in-situ measurements, simpler and economically advantageous, cannot completely replace the destructive measurements, but they may limit the number of required samples and consequently the decommissioning costs. The methodology described and the results obtained demonstrated that it is possible to obtain accurate estimations of activity concentrations with cheap and quick in-situ measurements if the concentration profile in-depth inside the wall is well known. This profile can be obtained either experimentally or numerically through suitably validated Monte Carlo simulations.

Silicon microdosimetry.

Silicon detectors are being studied as microdosemeters since they can provide sensitive volumes of micrometric dimensions. They can be applied for assessing single-event effects in electronic instrumentation exposed to complex fields around high-energy accelerators or in space missions. When coupled to tissue-equivalent converters, they can be used for measuring the quality of radiation therapy beams or for dosimetry. The use of micrometric volumes avoids the contribution of wall effects to the measured spectra. Further advantages of such detectors are their compactness, cheapness, transportability and a low sensitivity to vibrations. The following problems need to be solved when silicon devices are used for microdosimetry: (i) the sensitive volume has to be confined in a region of well-known dimensions; (ii) the electric noise limits the minimum detectable energy; (iii) corrections for tissue-equivalency should be made; (iv) corrections for shape equivalency should be made when referring to a spherical simulated site of tissue; (v) the angular response should be evaluated carefully; (vi) the efficiency of a single detector of micrometric dimensions is very poor and detector arrays should be considered. Several devices have been proposed as silicon microdosemeters, based on different technologies (telescope detectors, silicon on insulator detectors and arrays of cylindrical p-n junctions with internal amplification), in order to satisfy the issues mentioned above.

RBE estimation of proton radiation fields using a DeltaE-E telescope.

A new monolithic silicon DeltaE-E telescope was evaluated in unmodulated and modulated 100 MeV proton beams used for hadron therapy. Compared to a classical microdosimetry detector, which provides one-dimensional information on lineal energy of charged particles, this detector system provides two-dimensional information on lineal energy and particle energy based on energy depositions, collected in coincidence, within the DeltaE and E stages of the detector. The authors investigated the possibility to use the information obtained with the DeltaE-E telescope to determine the relative biological effectiveness (RBE) at defined locations within the proton Bragg peak and spread-out Bragg peak (SOBP). An RBE matrix based on the established in vitro V79 cell survival data was developed to link the output of the device directly to RBE(alpha), the RBE in the low-dose limit, at various depths in a homogeneous polystyrene phantom. In the SOBP of a 100 MeV proton beam, the RBE(alpha) increased from 4.04 proximal to the SOBP to a maximum value of 5.4 at the distal edge. The DeltaE-E telescope, with its high spatial resolution, has potential applications to biologically weighted hadron treatment planning as it provides a compact and portable means for estimating the RBE in rapidly changing hadron radiation fields within phantoms.

Analysis of computational problems expressing the overall uncertainties: photons, neutrons and electrons.

In the frame of the EU Coordination Action CONRAD (coordinated network for radiation dosimetry), WP4 was dedicated to work on computational dosimetry with an action entitled 'Uncertainty assessment in computational dosimetry: an intercomparison of approaches'. Participants attempted one or more of eight problems. This paper presents the results from problems 4-8-dealing with the overall uncertainty budget estimate; a short overview of each problem is presented together with a discussion of the most significant results and conclusions. The scope of the problems discussed here are: the study of a (137)Cs calibration irradiator; the manganese bath technique; the iron sphere experiment using neutron time-of-flight technique; the energy response of a RADFET detector and finally the sensitivity and uncertainty analysis for the recoil-proton telescope discussed in the companion paper.