RESUMO
OBJECTIVE: The aim of this study was to determine the effect of different concentrations of resveratrol in protecting enamel against initial dental erosion in vitro. METHODS: Ninety bovine enamel samples (4 × 4 mm) were divided into six groups: Phosphate buffered saline (negative control; PBS), Commercial solution (Elmex Erosion Protection™; positive control) and resveratrol at 4 different concentrations (1, 10, 100 or 400 µg/mL). Initially, the samples were incubated in saliva for the formation of the acquired pellicle (250 µL, 1 h, 37 °C, 250 rpm). Afterward, the samples were incubated in the respective treatments (250 µL, 1 min, 37 °C, 250 rpm) and then reincubated in saliva (250 µL, 1 h, 37 °C, 250 rpm). Finally, the samples were subjected to an erosive challenge by incubating in 1 % citric acid (1 mL, pH 3.5, 1 min, 25 °C, 250 rpm). The percentage surface microhardness change (% SMC) was assessed using a microhardness tester. Data were analyzed by Kruskal-Wallis and Dunn's tests (p < 0.05). RESULTS: The treatments with Elmex™ and resveratrol (1, 10 and 100 µg/mL) significantly protected enamel compared to the negative control, without significant differences among them. However, the group treated with the highest resveratrol concentration (400 µg/mL) did not show a significant difference from the negative control. CONCLUSIONS: Resveratrol at concentrations ranging from 1 to 100 µg/ml was effective in preventing loss of enamel surface microhardness. CLINICAL SIGNIFICANCE: This result suggests a potential new direction for the development of dental products based on resveratrol for the prevention of dental erosion.