Atomically synergistic Zn-Cr catalyst for iso-stoichiometric co-conversion of ethane and CO2 to ethylene and CO.

Developing atomically synergistic bifunctional catalysts relies on the creation of colocalized active atoms to facilitate distinct elementary steps in catalytic cycles. Herein, we show that the atomically-synergistic binuclear-site catalyst (ABC) consisting of [Formula: see text]-O-Cr6+ on zeolite SSZ-13 displays unique catalytic properties for iso-stoichiometric co-conversion of ethane and CO2. Ethylene selectivity and utilization of converted CO2 can reach 100 % and 99.0% under 500 °C at ethane conversion of 9.6%, respectively. In-situ/ex-situ spectroscopic studies and DFT calculations reveal atomic synergies between acidic Zn and redox Cr sites. [Formula: see text] ([Formula: see text]) sites facilitate ß-C-H bond cleavage in ethane and the formation of Zn-Hδ- hydride, thereby the enhanced basicity promotes CO2 adsorption/activation and prevents ethane C-C bond scission. The redox Cr site accelerates CO2 dissociation by replenishing lattice oxygen and facilitates H2O formation/desorption. This study presents the advantages of the ABC concept, paving the way for the rational design of novel advanced catalysts.

Ultrathin Free-Standing Oxide Membranes for Electron and Photon Spectroscopy Studies of Solid-Gas and Solid-Liquid Interfaces.

Free-standing ultrathin (∼2 nm) films of several oxides (Al2O3,TiO2, and others) have been developed, which are mechanically robust and transparent to electrons with Ekin ≥ 200 eV and to photons. We demonstrate their applicability in environmental X-ray photoelectron and infrared spectroscopy for molecular level studies of solid-gas (≥1 bar) and solid-liquid interfaces. These films act as membranes closing a reaction cell and as substrates and electrodes for electrochemical reactions. The remarkable properties of such ultrathin oxides membranes enable atomic/molecular level studies of interfacial phenomena, such as corrosion, catalysis, electrochemical reactions, energy storage, geochemistry, and biology, in a broad range of environmental conditions.

Structure of Copper-Cobalt Surface Alloys in Equilibrium with Carbon Monoxide Gas.

We studied the structure of the copper-cobalt (CuCo) surface alloy, formed by Co deposition on Cu(110), in dynamic equilibrium with CO. Using scanning tunneling microscopy (STM), we found that, in vacuum at room temperature and at low Co coverage, clusters of a few Co atoms substituting Cu atoms form at the surface. At CO pressures in the Torr range, we found that up to 2.5 CO molecules can bind on a single Co atom, in carbonyl-like configurations. Based on high-resolution STM images, together with density functional theory calculations, we determined the most stable CuCo cluster structures formed with bound CO. Such carbonyl-like formation manifests in shifts in the binding energy of the Co core-level peaks in X-ray photoelectron spectra, as well as shifts in the vibrational modes of adsorbed CO in infrared reflection absorption spectra. The multiple CO adsorption on a Co site weakens the Co-CO bond and thus reduces the C-O bond scission probability. Our results may explain the different product distribution, including higher selectivity toward alcohol formation, when bimetallic CuCo catalysts are used compared to pure Co.

Environment-Dependent Radiation Damage in Atmospheric Pressure X-ray Spectroscopy.

Atmospheric pressure X-ray spectroscopy techniques based on soft X-ray excitation can provide powerful interface-sensitive chemical information about a solid surface immersed in a gas or liquid environment. However, X-ray illumination of such dense phases can lead to the generation of considerable quantities of radical species by radiolysis. Soft X-ray absorption measurements of Cu films in both air and aqueous alkali halide solutions reveal that this can cause significant evolution of the Cu oxidation state. In air and NaOH (0.1 M) solutions, the Cu is oxidized toward CuO, while the addition of small amounts of CH3OH to the solution leads to reduction toward Cu2O. For Ni films in NaHCO3 solutions, the oxidation state of the surface is found to remain stable under X-ray illumination and can be electrochemically cycled between a reduced and oxidized state. We provide a consistent explanation for this behavior based on the products of X-ray-induced radiolysis in these different environments and highlight a number of general approaches that can mitigate radiolysis effects when performing operando X-ray measurements.

Synthesis and Structural Evolution of Nickel-Cobalt Nanoparticles Under H2 and CO2.

Bimetallic nanoparticle (NP) catalysts are interesting for the development of selective catalysts in reactions such as the reduction of CO2 by H2 to form hydrocarbons. Here the synthesis of Ni-Co NPs is studied, and the morphological and structural changes resulting from their activation (via oxidation/reduction cycles), and from their operation under reaction conditions, are presented. Using ambient-pressure X-ray photoelectron spectroscopy, X-ray absorption spectroscopy, and transmission electron microscopy, it is found that the initial core-shell structure evolves to form a surface alloy due to nickel migration from the core. Interestingly, the core consists of a Ni-rich single crystal and a void with sharp interfaces. Residual phosphorous species, coming from the ligands used for synthesis, are found initially concentrated in the NP core, which later diffuse to the surface.

Influence of Step Geometry on the Reconstruction of Stepped Platinum Surfaces under Coadsorption of Ethylene and CO.

We demonstrate the critical role of the specific atomic arrangement at step sites in the restructuring processes of low-coordinated surface atoms at high adsorbate coverage. By using high-pressure scanning tunneling microscopy (HP-STM) and ambient-pressure X-ray photoelectron spectroscopy (AP-XPS), we have investigated the reconstruction of Pt(332) (with (111)-oriented triangular steps) and Pt(557) surfaces (with (100)-oriented square steps) in the mixture of CO and C2H4 in the Torr pressure range at room temperature. CO creates Pt clusters at the step edges on both surfaces, although the clusters have different shapes and densities. A subsequent exposure to a similar partial pressure of C2H4 partially reverts the clusters on Pt(332). In contrast, the cluster structure is barely changed on Pt(557). These different reconstruction phenomena are attributed to the fact that the 3-fold (111)-step sites on Pt(332) allows for adsorption of ethylidyne-a strong adsorbate formed from ethylene-that does not form on the 4-fold (100)-step sites on Pt(557).

Mobility on the reconstructed Pt(100)-hex surface in ethylene and in its mixture with hydrogen and carbon monoxide.

By using high-pressure scanning tunneling microscopy and ambient-pressure X-ray photoelectron spectroscopy, we studied the mobility along with composition, structure and reactivity on the Pt(100)-hex surface. Adsorbates are mobile under 1 Torr of C2H4 and C2H4-H2 mixtures, but adding 3 mTorr of CO quenches the mobility. Ethylene-related adsorbates can also weaken Pt-Pt bonds and thus facilitate displacements in the hexagonal layer.

In situ spectroscopic detection of SMSI effect in a Ni/CeO2 system: hydrogen-induced burial and dig out of metallic nickel.

In situ APPES technique demonstrates that the strong metal support interaction effect (SMSI) in the Ni-ceria system is associated with the decoration and burial of metallic particles by the partially reduced support, a phenomenon reversible by evacuation at high temperature of the previously absorbed hydrogen.

Restructuring of hex-Pt(100) under CO gas environments: formation of 2-D nanoclusters.

The atomic-scale restructuring of hex-Pt(100) induced by carbon monoxide with a wide pressure range was studied with a newly designed chamber-in-chamber high-pressure STM and theoretical calculations. Both experimental and DFT calculation results show that CO molecules are bound to Pt nanoclusters through a tilted on-top configuration with a separation of approximately 3.7-4.1 A. The phenomenon of restructuring of metal catalyst surfaces induced by adsorption and, in particular, the formation of small metallic clusters suggests the importance of studying structures of catalyst surfaces under high-pressure conditions for understanding catalytic mechanisms.