Synchrotron X-ray micro-tomography imaging and analysis of wood degraded by Physisporinus vitreus and Xylaria longipes.

Incubation of Norway spruce with Physisporinus vitreus and sycamore with Xylaria longipes results in reduction in density of these wood species that are traditionally used for the top and bottom plate of a violin, which follows by enhanced acoustic properties. We used Synchrotron X-ray micro-tomography, to study the three-dimensional structure of wood at the micro-scale level and the alterations of the density distribution after incubation with two white-rot fungi. Micro-tomography data from wood treated at different incubation periods are analyzed and compared with untreated (control) specimens to determine the wood density map and changes at the cell-wall level. Differences between the density of early- and latewood, xylem ray and around bordered pits in both Norway spruce and sycamore are studied. Three-dimensional hyphal networks of the P.vitreus and Xylaria longipes hyphae are visualized inside the cell lumina and their significance on the density of the early- and latewood cells after different incubation periods are discussed. The study illustrates the utility of X-ray micro-tomography for both qualitative and quantitative studies of a wide variety of biological systems and due to its high sensitivity, small structural changes can be quantified.

Biomechanical evaluation of porous biodegradable scaffolds for revision knee arthroplasty.

Tibial bone defect is a critical problem for revision knee arthroplasty. Instead of using metallic spacer or cement, biodegradable scaffolds could be an alternative solution. A numerical model of a revision knee arthroplasty was thus developed to estimate the mechanical resistance of the scaffold in this demanding situation. The tibia, scaffold, and prosthesis were represented by simplified parameterised geometries. The maximal gait cycle force was applied asymmetrically to simulate a critical loading. Several parameters were analysed: 1) inter-individual variability, 2) cortical bone stiffness, 3) cortical bone thickness, 4) prosthesis fixation quality, and 5) scaffold thickness. The calculated scaffold strain was compared to its experimental ultimate strain. Among the tested parameters, failure was only predicted with scaffold thickness below 5 mm. This study suggests that biodegradable bone scaffolds could be used to fill bone defects in revision knee arthroplasty, but scaffold size seems to be the limiting factor.