Arsenic species in mesopelagic organisms and their fate during aquafeed processing.

A responsible harvest of mesopelagic species as aquafeed ingredients has the potential to address the United Nations Sustainable Development Goal 14, which calls for sustainable use of marine resources. Prior to utilization, the levels of undesirable substances need to be examined, and earlier studies on mesopelagic species have reported on total arsenic (As) content. However, the total As content does not give a complete basis for risk assessment since As can occur in different chemical species with varying toxicity. In this work, As speciation was conducted in single-species samples of the five most abundant mesopelagic organisms in Norwegian fjords. In addition, As species were studied in mesopelagic mixed biomass and in the resulting oil and meal feed ingredients after lab-scale feed processing. Water-soluble As species were determined based on ion-exchange high-performance liquid chromatography coupled to inductively coupled plasma mass spectrometry (HPLC-ICP-MS). This was supplemented by extracting arsenolipids (AsLipids) and determining total As in this fraction. The non-toxic arsenobetaine (AB) was the dominant form in mesopelagic crustaceans and fish species, accounting for approximately 70% and 50% of total As, respectively. Other water-soluble species were present in minor fractions, including carcinogenic inorganic As, which, in most samples, was below limit of quantification. The fish species had a higher proportion of AsLipids, approximately 35% of total As, compared to crustaceans which contained 20% on average. The feed processing simulation revealed generally low levels of water-soluble As species besides AB, but considerable fractions of potentially toxic AsLipids were found in the biomass, and transferred to the mesopelagic meal and oil. This study is the first to report occurrence data of at least 12 As species in mesopelagic organisms, thereby providing valuable information for future risk assessments on the feasibility of harnessing mesopelagic biomass as feed ingredients.

Ultra-trace speciation analysis of Cr(III) and Cr(VI) in rice using species-specific isotope dilution and HPLC-ICP-MS.

The study aims to clarify the current controversy related to conflicting reports on whether presence of Cr(VI) in rice is possible or not. For this purpose, a method was employed for the single run speciation analysis of Cr(III) and Cr(VI) in rice samples using species-specific isotope dilution (SS-ID) and high performance liquid chromatography coupled to inductively coupled mass-spectrometry (HPLC-ICP-MS) and selective single run species complexation/derivatisation. The quantification limits (LOQs) were 0.014 µg kg-1 for Cr(III) and 0.047 µg kg-1 for Cr(VI), while the detection limits (LODs) were 0.004 and 0.014 µg kg-1 for Cr(III) and Cr(VI), respectively. A total of 10 rice samples of different origin and colour (depending on the type of industrial processing) were analysed in this study. The content of Cr(VI) was below the limit of quantification in all of the rice samples analysed, while the Cr(III) levels ranged between 0.59 (whole grain rice) up to 104 µg kg-1 (brown rice). All samples were also analysed for their total Cr (Crtotal) content by ICP-MS solely and the results were in all cases comparable with the Cr(III) levels determined in the same samples. To assess the stability of Cr(III) and Cr(VI) in rice, one sample was spiked with Cr(III) and Cr(VI) (individually) at different levels (5.0, 10, 15 and 20 µg kg-1), held for 2 h, and then analysed by SS-ID HPLC-ICP-MS. The results showed a complete reduction of Cr(VI) to Cr(III), while Cr(III) remained stable at all spiking levels. These findings support the general statement from the European Food Safety Authority related to the complete absence of Cr(VI) in foods and confirms that Cr in rice is found solely as Cr(III) species.

Speciation analysis of organoarsenic species in marine samples: method optimization using fractional factorial design and method validation.

Organoarsenic species in marine matrices have been studied for many years but knowledge gaps still exist. Most literature focuses on monitoring of arsenic (As) species using previously published methods based on anion- and cation-exchange high-performance liquid chromatography-inductively coupled plasma mass spectrometry (HPLC-ICP-MS). These studies are often limited to few As species and/or only specific method performance characteristics are described. Most marine certified reference materials (CRMs) are only certified for arsenobetaine (AB) and dimethylarsinate (DMA), making it difficult to evaluate the accuracy of analytical methods for other organoarsenic species. To address these gaps, the main objective of this work was to develop and validate a method for speciation analysis of a broad range of organoarsenic species in marine matrices. Optimum extraction conditions were identified through a 27-3 fractional factorial design using blue mussel as test sample. The effects of sample weight, type and volume of extraction solution, addition of H2O2 to the extraction solution, extraction time and temperature, and use of ultrasonication were investigated. The highest As recoveries were obtained by using 0.2 g as sample weight, 5 mL of aqueous methanol (MeOH:H2O, 50% v/v) as extractant, extraction carried out at 90 °C for 30 min, and without ultrasonication. Anion- and cation-exchange HPLC-ICP-MS settings were subsequently optimized. The method detected a total of 33 known and unknown As species within a run time of 23 and 20 min for cation-exchange and anion-exchange, respectively. A single-laboratory validation was conducted using several marine CRMs: BCR 627 (tuna fish tissue), ERM-CE278k (mussel tissue), DORM-4 (fish protein), DOLT-5 (dogfish liver), SQID-1 (cuttlefish), TORT-3 (lobster hepatopancreas), and CRM 7405-b (hijiki seaweed). Method performance characteristics were evaluated based on selectivity, limits of detection and quantification, linearity, trueness, precision, and measurement uncertainty. This work proposes an extraction procedure which allowed satisfactory quantification of As species with low solvent and energy consumption, supporting "Green Chemistry" principles. The study also presents a new set of As speciation data, including methylated arsenic species and arsenosugars, in recently issued marine CRMs, which will be valuable for future speciation studies on As. This work is the first to report a total of 33 different As species in marine CRMs.

Physical Stability of Oil-In-Water Emulsion Stabilized by Gelatin from Saithe (Pollachius virens) Skin.

The objective of the present study was to investigate the physical stability of an oil-in-water (O/W) emulsion stabilized with gelatin from saithe (Pollachius virens) skin obtained with three different extraction protocols compared to two commercial fish skin gelatins. We first investigated the gelatin powder composition, and then produced the O/W emulsions at pH 3 by mechanical dispersion followed by an ultrasonication process. Sodium dodecyl sulfate (SDS) profiles for commercial samples indicated that extensive and unspecific hydrolysis of collagen occurred during the production process, whereas gelatin extracted from saithe fish skin showed typical electrophoresis patterns of type I collagen, with the presence of γ- and ß-chains. Emulsions obtained with commercial samples presented high physical stability over 7 days, with particle size of ~200 nm. However, emulsions obtained with saithe fish skin presented particle size between 300 and 450 nm. Slight differences were observed in viscosity, with values between ~1 and ~4 mPa·s. Interfacial tension measurements presented values between 13 and 17 mN·m-1 with three different regimes for all the systems.

Cytokine Profile in Patients with Aseptic Loosening of Total Hip Replacements and Its Relation to Metal Release and Metal Allergy.

Metal release from total hip replacements (THRs) is associated with aseptic loosening (AL). It has been proposed that the underlying immunological response is caused by a delayed type IV hypersensitivity-like reaction to metals, i.e., metal allergy. The purpose of this study was to investigate the immunological response in patients with AL in relation to metal release and the prevalence of metal allergy. THR patients undergoing revision surgery due to AL or mechanical implant failures were included in the study along with a control group consisting of primary THR patients. Comprehensive cytokine analyses were performed on serum and periimplant tissue samples along with metal analysis using inductive coupled plasma mass spectrometry (ICP-MS). Patient patch testing was done with a series of metals related to orthopedic implant. A distinct cytokine profile was found in the periimplant tissue of patients with AL. Significantly increased levels of the proinflammatory cytokines IL-1ß, IL-2, IL-8, IFN-γ and TNF-α, but also the anti-inflammatory IL-10 were detected. A general increase of metal concentrations in the periimplant tissue was observed in both revision groups, while Cr was significantly increased in patient serum with AL. No difference in the prevalence of metal sensitivity was established by patch testing. Increased levels of IL-1ß, IL-8, and TNF-α point to an innate immune response. However, the presence of IL-2 and IFN-γ indicates additional involvement of T cell-mediated response in patients with AL, although this could not be detected by patch testing.

Mice with epidermal filaggrin deficiency show increased immune reactivity to nickel.

BACKGROUND: Nickel allergy and dermatitis have been associated with filaggrin gene mutations in epidemiological studies, but the mechanisms mediating these associations are unknown. OBJECTIVES: To investigate whether filaggrin-deficient flaky tail (ft/ft) mice show increased immune reactivity to nickel and elucidate the mechanisms mediating this. METHODS: The immune responses to nickel, 2,4-dinitrofluorobenzene (DNFB), cinnamal and p-phenylenediamine were assessed in ft/ft and wild-type (WT) mice. The amounts of nickel in the skin of ft/ft and WT mice were determined 20 hours after nickel exposure. The effect of blocking either the interleukin (IL)-17A pathway or the IL-1 pathway on the response to nickel in ft/ft mice was evaluated. RESULTS: Increased responsiveness to nickel, DNFB and cinnamal was observed in ft/ft mice as compared with controls. A reduced amount of nickel was found in the skin of ft/ft mice as compared with WT mice, suggesting increased nickel absorption by the skin of ft/ft mice. Blocking either the IL-17A pathway or the IL-1 pathway reduced nickel responsiveness in ft/ft mice. CONCLUSIONS: These findings suggest that the increased nickel responsiveness associated with epidermal filaggrin deficiency is mediated by a combination of increased nickel penetration and the steady-state inflammation found in the skin of filaggrin-deficient mice.

Effects of steaming on contaminants of emerging concern levels in seafood.

Seafood consumption is a major route for human exposure to environmental contaminants of emerging concern (CeCs). However, toxicological information about the presence of CeCs in seafood is still insufficient, especially considering the effect of cooking procedures on contaminant levels. This study is one among a few who evaluated the effect of steaming on the levels of different CeCs (toxic elements, PFCs, PAHs, musk fragrances and UV-filters) in commercially relevant seafood in Europe, and estimate the potential risks associated with its consumption for consumers. In most cases, an increase in contaminant levels was observed after steaming, though varying according to contaminant and seafood species (e.g. iAs, perfluorobutanoate, dibenzo(ah)anthracene in Mytilus edulis, HHCB-Lactone in Solea sp., 2-Ethylhexyl salicylate in Lophius piscatorius). Furthermore, the increase in some CeCs, like Pb, MeHg, iAs, Cd and carcinogenic PAHs, in seafood after steaming reveals that adverse health effects can never be excluded, regardless contaminants concentration. However, the risk of adverse effects can vary. The drastic changes induced by steaming suggest that the effect of cooking should be integrated in food risk assessment, as well as accounted in CeCs regulations and recommendations issued by food safety authorities, in order to avoid over/underestimation of risks for consumer health.

Exploration of the phycoremediation potential of Laminaria digitata towards diflubenzuron, lindane, copper and cadmium in a multitrophic pilot-scale experiment.

The presence of contaminants in aquatic ecosystems can cause serious problems to the environment and marine organisms. This study aims to evaluate the phycoremediation capacity of macroalgae Laminaria digitata for pesticides (diflubenzuron and lindane) and toxic elements (cadmium and copper) in seawater in the presence or absence of mussels. The photosynthetic activity was monitored in the macroalgae to assess its "physiological status". The results showed that the presence of algae decreased diflubenzuron concentration in mussels by 70% after 120 h of exposure. Additionally, this macroalgae was efficient to reduce lindane, Cu and Cd in seawater; even though it not was able to reduce these contaminants in mussels. The studied pollutants did not affect the physiological status of macroalgae. This study reveals that the application of phycoremediation with macroalgae can be an useful and effective mitigation strategy to remove/decrease contaminant levels from the aquatic environment.

Total and inorganic arsenic in dietary supplements based on herbs, other botanicals and algae--a possible contributor to inorganic arsenic exposure.

The content of total and inorganic arsenic was determined in 16 dietary supplements based on herbs, other botanicals and algae purchased on the Danish market. The dietary supplements originated from various regions, including Asia, Europe and USA. The contents of total and inorganic arsenic was determined by inductively coupled plasma mass spectrometry (ICP-MS) and anion exchange HPLC-ICP-MS, respectively, were in the range of 0.58 to 5.0 mgkg(-1) and 0.03 to 3.2 mg kg(-1), respectively, with a ratio between inorganic arsenic and total arsenic ranging between 5 and 100%. Consumption of the recommended dose of the individual dietary supplement would lead to an exposure to inorganic arsenic within the range of 0.07 to 13 µg day(-1). Such exposure from dietary supplements would in worst case constitute 62.4% of the range of benchmark dose lower confidence limit values (BMDL01 at 0.3 to 8 µg kg bw(-1) kg(-1) day(-1)) put down by European Food Safety Authority (EFSA) in 2009, for cancers of the lung, skin and bladder, as well as skin lesions. Hence, the results demonstrate that consumption of certain dietary supplements could contribute significantly to the dietary exposure to inorganic arsenic at levels close to the toxicological limits established by EFSA.