Evaluation of the Antioxidant Capacity of Fruit Juices by Two Original Analytical Methods.

Two analytical methods previously developed by our groups were employed to estimate the antioxidant capacity of commercial fruit juices. The electrochemical method, which measures the scavenging activity of antioxidants towards OH radicals generated by both hydrogen peroxide photolysis and Fenton's reaction, is based on the recovery of the cyclic voltametric response of the redox probe Ru(NH3)63+ at a Glassy Carbon electrode modified with a thin film of an insulating polyphenol, in the presence of compounds with antioxidant properties. The values of the antioxidant capacity of the fruit juices are expressed as vitamin C equivalents/L. The chromatographic method is based on the generation of OH radicals via Fenton's reaction in order to test the inhibition of their formation in the presence of antioxidant compounds by monitoring salicylate aromatic hydroxylation derivatives as markers of •OH production, by means of HPLC coupled to coulometric detection. The results are expressed as the percentage of inhibition of •OH production in the presence of the tested juice compared to the control sample. When OH radicals are produced by Fenton's reaction, the antioxidant capacity of the juices, estimated by both methods, displays an analogous trend, confirming that they can be considered an alternative for measuring the ability of antioxidants to block OH radical formation.

ALP-Based Biosensors Employing Electrodes Modified with Carbon Nanomaterials for Pesticides Detection.

Due to the growing presence of pesticides in the environment and in food, the concern of their impact on human health is increasing. Therefore, the development of fast and reliable detection methods is needed. Enzymatic inhibition-based biosensors represent a good alternative for replacing the more complicated and time-consuming traditional methods (chromatography, spectrophotometry, etc.). This paper describes the development of an electrochemical biosensor exploiting alkaline phosphatase as the biological recognition element and a chemically modified glassy carbon electrode as the transducer. The biosensor was prepared modifying the GCE surface by a mixture of Multi-Walled-Carbon-Nanotubes (MWCNTs) and Electrochemically-Reduced-Graphene-Oxide (ERGO) followed by the immobilization of the enzyme by cross-linking with bovine serum albumin and glutaraldehyde. The inhibition of the biosensor response caused by pesticides was established using 2-phospho-L-ascorbic acid as the enzymatic substrate, whose dephosphorylation reaction produces ascorbic acid (AA). The MWCNTs/ERGO mixture shows a synergic effect in terms of increased sensitivity and decreased overpotential for AA oxidation. The response of the biosensor to the herbicide 2,4-dichloro-phenoxy-acetic-acid was evaluated and resulted in the concentration range 0.04-24 nM, with a limit of the detection of 16 pM. The determination of other pesticides was also achieved. The re-usability of the electrode was demonstrated by performing a washing procedure.

A Wearable Electrochemical Gas Sensor for Ammonia Detection.

The next future strategies for improved occupational safety and health management could largely benefit from wearable and Internet of Things technologies, enabling the real-time monitoring of health-related and environmental information to the wearer, to emergency responders, and to inspectors. The aim of this study is the development of a wearable gas sensor for the detection of NH3 at room temperature based on the organic semiconductor poly(3,4-ethylenedioxythiophene) (PEDOT), electrochemically deposited iridium oxide particles, and a hydrogel film. The hydrogel composition was finely optimised to obtain self-healing properties, as well as the desired porosity, adhesion to the substrate, and stability in humidity variations. Its chemical structure and morphology were characterised by infrared spectroscopy and scanning electron microscopy, respectively, and were found to play a key role in the transduction process and in the achievement of a reversible and selective response. The sensing properties rely on a potentiometric-like mechanism that significantly differs from most of the state-of-the-art NH3 gas sensors and provides superior robustness to the final device. Thanks to the reliability of the analytical response, the simple two-terminal configuration and the low power consumption, the PEDOT:PSS/IrOx Ps/hydrogel sensor was realised on a flexible plastic foil and successfully tested in a wearable configuration with wireless connectivity to a smartphone. The wearable sensor showed stability to mechanical deformations and good analytical performances, with a sensitivity of 60 ± 8 µA decade-1 in a wide concentration range (17-7899 ppm), which includes the safety limits set by law for NH3 exposure.

Nanostructured Copper-Based Electrodes Electrochemically Synthesized on a Carbonaceous Gas Diffusion Membrane with Catalytic Activity for the Electroreduction of CO2.

In this work, four different 4 cm2-sized nanostructured Cu-based electrocatalysts have been designed by a one-step electrodeposition process of Cu metal on a three-dimensional carbonaceous membrane. One consisted of Cu0, and the other three were obtained by further simple oxidative treatments. Morphological, structural, and electrochemical investigations on the four materials were carried out by scanning electron microscopy, Raman spectroscopy, X-ray diffraction, linear sweep voltammetry, and potential-controlled electrolysis. All the electrocatalysts showed promising catalytic activities toward CO2 electroreduction in liquid phase, with a remarkable selectivity toward acetic acid achieved when using the oxidized materials. In particular, the best electrocatalytic activity was observed for the Cu2O-Cu0 catalyst, working at a relatively low potential (-0.4 V vs RHE), which exhibited a stable and low current density of 0.46 mA cm-2 and a productivity of 308 µmol gcat-1 h-1. These results were attributed to the nanostructured morphology that is characterized by many void spaces and by a high surface area, which should guarantee a large number of CuI and Cu0 catalytic active sites. Moreover, kinetic analyses and preliminary studies about catalyst regeneration highlighted the stability of the best-performing catalyst.

Analytical profiling of selected antioxidants and total antioxidant capacity of goji (Lycium spp.) berries.

Goji berries and derived products represent a relevant source of micronutrients, most of which are natural antioxidants and contribute to the high nutritional quality of these fruits. Three brands of dried goji berries have been analysed by a multidisciplinary approach to get an insight into both their content of selected antioxidants and their antioxidant capacity (AC). The former goal has been achieved by developing a liquid chromatographic method coupled to mass spectrometry and combined to a fast solid phase extraction. Several significant representative antioxidant compounds belonging to the following classes: flavonoids, flavan-3-ols, phenolic acids, amino acids and derivatives, and carotenoids have been taken into account. Quercetin and rutin were found to be the predominant flavonoids, chlorogenic acid was the most abundant phenolic acid and zeaxanthin was the major carotenoid. The AC of the goji berries has been evaluated by four analytical methods in order to estimate the contributions of different reactions involved in radicals scavenging. In particular, AC has been determined using 3 standardised methods (DPPH, ABTS, ORAC) and a recently proposed electrochemical method, which measures the scavenging activity of antioxidants towards OH radicals generated both by hydrogen peroxide photolysis and the Fenton reaction. The results obtained from chemical composition and antioxidant capacity assays confirm the high nutritional and commercial value of goji berries and highlight that the three brands do not exhibit significant differences.

A new electrochemical sensor for OH radicals detection.

A new, cheap modified electrode for indirect detection of OH radical is described. A glassy carbon (GC) electrode was modified with a polyphenol film prepared by oxidative potentiostatic electropolymerization of 0.05 M phenol in 1M H2SO4. The film having a thickness of ~10nm perfectly covered the GC surface and inhibited the charge transfer of many redox species. The degradation of the polyphenol film, that was induced by OH radicals generated by Fenton reaction or by H2O2 photolysis, is the analytical signal and it was evaluated by cyclic voltammetry and chronoamperometry using the redox probe Ru(NH3)6(3+). Some simulations of the kinetics of the reactions occurring in the solution bulk and near the electrode surface were carried out to fully understand the processes that lead to the analytical signal. The modified electrode was used to evaluate the performances of different TiO2-based photocatalysts and the results were successfully compared with those obtained from a traditional HPLC method that is based on the determination of the hydroxylation products of salicylic acid.

Nitroimidazole and glucosamine conjugated heteroscorpionate ligands and related copper(II) complexes. Syntheses, biological activity and XAS studies.

New nitroimidazole and glucosamine conjugated heteroscorpionate ligands, namely 2,2-bis(3,5-dimethyl-1H-pyrazol-1-yl)-N-(2-(2-methyl-5-nitro-1H-imidazol-1-yl)ethyl)acetamide (L(MN)) and 1,3,4,6-tetra-O-acetyl-2-{[bis(3,5-dimethyl-1H-pyrazol-1-yl)acetyl]amino}-2-deoxy-ß-D-glucopyranose (L(DAC)), respectively, were synthesized by direct coupling of preformed side chain acid and amine components. The related copper(II) complexes {[(L(MN))(2)Cu]Cl(2)}, and {[(L(DAC))(2)Cu]Cl(2)} have been prepared from the reaction of CuCl(2)*2H(2)O with L(MN) or L(DAC) ligand in methanol solution. Single crystal structural characterization was undertaken for the L(MN) ligand. In the absence of a coordinated metal core, the overall arrangement of the ligand is determined by some loose intra- and inter-molecular nonbonding contacts. X-Ray Absorption Spectroscopy (XAS) has been used to probe the local structure of the two copper(II) complexes, {[(L(MN))(2)Cu]Cl(2)} and {[(L(DAC))(2)Cu]Cl(2)}. The EXAFS analysis has permitted the identification of the local environment of the copper site. Copper interacts with 2 units of ligand in both complexes, and it is found to be 6-fold coordinated. Its local structure is described by four Cu-N and two Cu-O interactions to form a pseudo-octahedron core, with a 0.14 Å lengthening of the Cu-O bond length in the case of L(DAC) complex with respect to the L(MN) one, likely due to the higher steric hindrance of the glucosamine moiety. The XANES analysis agrees with these results, also confirming the Cu(II) formal copper oxidation state for both complexes. The new copper(II) complexes {[(L(MN))(2)Cu]Cl(2)} and {[(L(DAC))(2)Cu]Cl(2)} as well as the corresponding uncoordinated ligands were evaluated for their cytotoxic activity towards a panel of several human tumour cell lines. The results reported here indicate that both copper(II) complexes show similar spectra of cytotoxicity and very low resistance factors (RF < 2) against C13* ovarian cancer cells which have acquired resistance to cisplatin.

Intercalation of iron(III) hexacyano complex in a Ni,Al hydrotalcite-like compound.

The product obtained by the intercalation of hexacyanoferrate(III) inside a Ni, Al hydrotalcite-like compound (Htlc) has been characterized using XRD, FT-IR, Raman, and XAS spectroscopy. The intercalation was carried out by anionic exchange of the originally existing chloride ions. The combined use of those techniques gave more insight on the insertion chemistry of Htlcs. Extended X-ray absorption fine structure spectra of the intercalated Htlc demonstrated that the native structure was stable during the iron complex insertion, whereas the exchange process occurred with a partial reduction of hexacyanoferrate(III). Both Raman and FT-IR spectroscopy pointed out the concomitant formation of K(2)NiFe(II)(CN)(6) and KNiFe(III)(CN)(6). The effect of aging on the intercalated product is also addressed.

Spectrophotometric determination of aluminium and nickel.

A simple spectrophotometric method, based on the complexes with xylenol orange (XO) and EDTA, is presented for the rapid determination of aluminium and nickel, respectively, in synthetic samples of hydrotalcite. The method only requires the solubilization in sulphuric acid of the inorganic material before the ligand addition. Under optimum conditions, the complexes Al-XO and Ni-EDTA showed maximum absorption at 554 nm and 380 nm, respectively. The method obeyed Beer's law in the concentration range 0.14-1.8 microg mL(-1) of aluminium, and 30-2730 microg mL(-1) of nickel. Molar absorptivities were 2.45 x 10(4) and 14.85 L mol(-1) cm(-1) while Sandell's sensitivities were 1.1 x 10(-3) and 3.9 microg cm(-2) for aluminium and nickel, respectively. The standard addition technique was used and the recoveries obtained revealed that the proposed procedure shows good accuracy.