Safety assessment of the substance poly(2-hydroxypropanoic acid), n-octyl/n-decyl esters, for use in food contact materials.

The EFSA Panel on Food Contact Materials, Enzymes and Processing Aids (CEP) assessed the safety of poly(2-hydroxypropanoic acid), n-octyl/n-decyl esters (OLA8), which is intended to be used as a plasticiser into polylactic acid (PLA) in contact with non-fatty foods. OLA8 is intended to be used at up to 5% and 15% w/w with or without starch, respectively (or with other additives with similar function). The migration for 10 days at 40°C from the film without starch was 0.16 mg/kg in 10% ethanol and 0.01 mg/kg in 3% acetic acid, while from the film with the starch it was well above 0.05 mg/kg food in all simulants. Some of the testing conditions were inconsistently reported. The substance did not induce gene mutations in bacterial cells and did not induce structural chromosomal aberrations or polyploidy in mammalian cells, thus, does not raise concern for genotoxicity. Instead of providing a 90-day oral toxicity study, a hydrolysis study in ■■■■■ was submitted to read-across from the authorised starting substances, ■■■■■ and the ■■■■■. However, the data provided did not allow to perform the read-across, thus no appropriate toxicological data were provided to support migration above 0.05 mg/kg food (including for contact with 10% ethanol and use in combination with starch). The Panel concluded that OLA8 does not raise a safety concern for the consumer if it is used as an additive at up to 15% w/w in the manufacture of PLA articles that do not contain starch (and other additives with similar function), that are intended to be in contact for 10 days at 40°C with foods simulated by 3% acetic acid and from which the migration does not exceed 0.05 mg/kg food.

Safety assessment of bleached cellulose pulp for use in plastic food contact materials.

The EFSA Panel on Food Contact Materials, Enzymes and Processing Aids assessed the safety of the substance bleached cellulose pulp, consisting of cellulose fibres (70-92%) and hemicellulose (8-30%) obtained from pine and spruce wood. The substance is intended to be used ■■■■■ in polyethylene and polypropylene food contact materials. The final articles are intended to be used for all food types and for long-term storage at room temperature, with or without a short time at higher temperature, including hot-fill. Low-density polyethylene samples containing ■■■■■ of the substance were subjected to a broad set of migration tests with food simulants and extraction tests with dichloromethane. The limits of detection ranged from ■■■■■ (when specified). The Panel noted that they do not ensure the detection of genotoxic substances at a concentration leading to a human exposure above the Threshold of Toxicological Concern. Moreover, not all possibly migrating substances were identified or amenable to the analytical methods applied. No toxicological data were provided for the substance itself, as its migration into food is not expected. The safety of the potentially migrating substances of low molecular mass detected was addressed individually and was considered adequate. However, the Panel considered this approach insufficient owing to a substantial fraction of unidentified components. The Panel concluded that the information provided by the applicant does not allow the safety assessment of the substances below 1,000 Da from bleached cellulose pulp from pine and spruce wood used in plastic food contact materials potentially migrating into food. Therefore, the Panel could not conclude on the safety of the use of bleached cellulose pulp from pine and spruce wood as a plastic additive.

Assessment of the impact of the IARC Monograph Vol. 121 on the safety of the substance styrene (FCM No 193) for its use in plastic food contact materials.

The EFSA Panel on Food Contact Materials, Enzymes and Processing Aids (CEP) was requested by the European Commission to re-evaluate the safety of styrene (FCM No 193) for use in plastic food contact materials (FCM) following the classification by the International Agency for Research on Cancer (IARC) as 'probably carcinogenic to humans'. The IARC Monograph pertains to hazard identification, based on studies on high-dose occupational exposures by inhalation and animal studies, also mainly by inhalation. The Panel considered that the IARC conclusions cannot be directly applied to the evaluation of risks for consumers from the oral exposure to styrene, but also concluded that, based on the data provided in the IARC Monograph and by the industry, a concern for genotoxicity associated with oral exposure to styrene cannot be excluded. The migration of styrene into foods packed in styrenic plastics is below 10 µg/kg for the majority of the foods, but up to 230 µg/kg was reported. Migration tends to be high for contact with fatty foods, and/or with high surface to volume ratios of the FCM. Dietary exposure of the consumers to styrene migrating from styrenic plastics was estimated in the order of 0.1 µg/kg body weight (bw) per day. It is in the same range as exposure from styrene present in foods as such. The dietary exposure (food component plus migration from styrenic plastics) is similar or lower than that by inhalation in the general population. Taking the human exposure data into account, the Panel concluded that a systematic review of genotoxicity and mechanistic data, comparative toxicokinetics and analysis of species differences is required for assessing the safety of styrene for its use in FCM.