Effect of optical fiber diameter and laser emission mode (cw vs pulse) on tissue damage profile using 1.94 µm Tm:fiber lasers in a porcine kidney model.

PURPOSE: To evaluate the ablation capacity using two Thulium fiber lasers (TFL) in a porcine kidney model. METHODS: All tissue samples were mounted on a motorized stage for a precise speed of cutting. A continuous wave (cw) TFL and a super pulsed (SP) TFL were used at power settings of 60 and 120 W with 200 and 600 µm laser fibers. After lactate dehydrogenase staining, histological evaluation was performed to measure the vaporization volume (VV), ablation depth (AD), thermo-mechanical damage zones (TMZ), coagulation zones (CZ) and the carbonization grade (CG). RESULTS: At 120 W, no significant differences were seen between 200 and 600 µm fibers utilizing the cw TFL regarding VV (24.6 vs. 28.2 mm3/s), AD (5.6 vs. 5.7 mm), TMZ (0 vs. 0 mm2) and CZ (18.1 vs. 12.3 mm2). Using the SP TFL, no significant differences between both fiber diameters with regard to VV (4 vs. 6.2 mm3/s), AD (2.7 vs. 3.4 mm), TMZ (1 vs. 2.6 mm2) and CZ (3.1 vs. 2.2 mm2) at 120 W were found, respectively. However, the VV of the cw TFL at 60 W was significantly less compared to 120 W using 200 and 600 µm fibers, respectively, whereas the SP TFL did not show significant differences between 60 and 120 W with regard to VV. SP TFL showed a consistently lower CG compared to cw TFL. CONCLUSIONS: This experiment suggests that there is no significant difference using 200 or 600 µm laser fibers in cw or SP TFLs. However, the cw TFL produces a coagulation zone three to five times larger than the SP TFL regardless of the fiber diameter.

High power holmium:YAG versus thulium fiber laser treatment of kidney stones in dusting mode: ablation rate and fragment size studies.

OBJECTIVES: The experimental Thulium fiber laser (TFL) is currently being studied as a potential alternative to the gold standard Holmium:YAG laser for lithotripsy. Recent advances in both Holmium and TFL technology allow operation at similar laser parameters for direct comparison. The use of a "dusting" mode with low pulse energy (0.2-0.4 J) and high pulse rate (50-80 Hz) settings, is gaining popularity in lithotripsy due to the desire to produce smaller residual stone fragments during ablation, capable of being spontaneously passed through the urinary tract. METHODS: In this study, Holmium and TFL were directly compared for 'dusting' using three laser groups, G1: 0.2 J/50 Hz/10 W; G2: 0.2 J/80 Hz/16 W; and G3: 0.4 J/80 Hz/32 W. Holmium laser pulse durations ranged from 200 to 350 µs, while TFL pulse durations ranged from 500 to 1,000 µs, due to technical limitations for both laser systems. An experimental setup consisting of 1 × 1 cm cuvette with 1 mm sieve was used with continuous laser operation time limited to ≤5 minutes. Calcium oxalate monohydrate stone samples with a sample size of n = 5 were used for each group, with average initial stone mass ranging from 216 to 297 mg among groups. RESULTS: Holmium laser ablation rates were lower than for TFL at all three settings (G1: 0.3 ± 0.2 vs. 0.8 ± 0.2; G2: 0.6 ± 0.1 vs. 1.0 ± 0.4; G3: 0.7 ± 0.2 vs. 1.3 ± 0.9 mg/s). The TFL also produced a greater percentage by mass of stone dust (fragments <0.5 mm) than Holmium laser. For all three settings combined, one out of 15 (7%) stones treated with Holmium laser were completely fragmented in ≤5 minutes compared to nine out of 15 (60%) stones treated with TFL. CONCLUSIONS: These preliminary studies demonstrate that the TFL is a promising alternative laser for lithotripsy when operated in dusting mode, producing higher stone ablation rates and smaller stone fragments than the Holmium laser. Clinical studies are warranted. Lasers Surg. Med. 51:522-530, 2019. © 2019 Wiley Periodicals, Inc.