RESUMO
The formation of the alveolar bone, which houses the dental primordia, and later the roots of tooth, may serve as a model to approach general questions of alveolar bone formation. In this respect, this study aimed to investigate the potential interactions between the alveolar bone formation and tooth eruption by using finite element (FE) methods, and to figure out whether the expanding tooth systems induce shear stresses that lead to alveolar bone formation. 3D geometric surface models were generated from the 3D histological data of the heads of mice (C57 Bl/6J) ranging from stages embryonic (E) to postnatal (P) stages E15 to P20 using the reconstruction software 3-Matic. Bone, dentin, enamel and dental follicle around the primordia were generated and converted into 3D FE models. Models were imported into the FE software package MSC.Marc/Mentat. As material parameters of embryonic dentine, pulp, enamel, dental follicle, and bony structures basically are unknown, these were varied from 1% to 100% of the corresponding known material parameters for humans and a sensitivity analysis was performed. Surface loads were applied to the outside surface of dental follicle ranging from 0.1 to 5.0N/mm2. The validity of the model was analysed by comparing the activity pattern of the alveolar bone as determined in the histological study with the loading pattern from the numerical analysis. The results show that when varying the surface loads, the distribution of shear stresses remained same, and while varying the material properties of the hard tissues, the location of highest shear stresses remained stable. Comparison of the histologically determined growth regions with the distribution of shear stresses computed in the numerical model showed a very close agreement. The results provide a strong proof to support Blechschmidt's hypothesis that the bone in general is created under the influence of shear forces.