RESUMO
Metalloporphyrins with open d-shell ions can drive biochemical energy cycles. However, their utilization in photoconversion is hampered by rapid deactivation. Mapping the relaxation pathways is essential for elaborating strategies that can favorably alter the charge dynamics through chemical design and photoexcitation conditions. Here, we combine transient optical absorption spectroscopy and transient X-ray emission spectroscopy with femtosecond resolution to probe directly the coupled electronic and spin dynamics within a photoexcited nickel porphyrin in solution. Measurements and calculations reveal that a state with charge-transfer character mediates the formation of the thermalized excited state, thereby advancing the description of the photocycle for this important representative molecule. More generally, establishing that intramolecular charge-transfer steps play a role in the photoinduced dynamics of metalloporphyrins with open d-shell sets a conceptual ground for their development as building blocks capable of boosting nonadiabatic photoconversion in functional architectures through "hot" charge transfer down to the attosecond time scale.
RESUMO
Inorganic perovskites display an enticing foreground for their wide range of optoelectronic applications. Recently, supercrystals (SCs) of inorganic perovskite nanocrystals (NCs) have been reported to possess highly ordered structure as well as novel collective optical properties, opening new opportunities for efficient films. Here, we report the large-scale assembly control of spherical, cubic, and hexagonal SCs of inorganic perovskite NCs through templating by oil-in-oil emulsions. We show that an interplay between the roundness of the cubic NCs and the tension of the confining droplet surface sets the superstructure morphology, and we exploit this interplay to design dense hyperlattices of SCs. The SC films show strongly enhanced stability for at least two months without obvious structural degradation and minor optical changes. Our results on the controlled large-scale assembly of perovskite NC superstructures provide new prospects for the bottom-up production of optoelectronic devices based on the microfluidic production of mesoscopic building blocks.
RESUMO
Photocatalytic water splitting has become a promising strategy for converting solar energy into clean and carbon-neutral solar fuels in a low-cost and environmentally benign way. Hydrogen gas is such a potential solar fuel/energy carrier. In a classical artificial photosynthetic system, a photosensitizer is generally associated with a co-catalyst to convert photogenerated charge into (a) chemical bond(s). In the present study, assemblies consisting of CdSe quantum dots that are coupled with one of two molecular complexes/catalysts, that is, [Fe2 S2 (CO)6 ] or [Fe3 Te2 (CO)9 ], using an interface-directed approach, have been tested as catalytic systems for hydrogen production in aqueous solution/organic solution. In the presence of ascorbic acid as a sacrificial electron donor and proton source, these assemblies exhibit enhanced activities for the rate of hydrogen production under visible light irradiation for 8â h in aqueous solution at pHâ 4.0 with up to 110â µmol of H2 per mg of assembly, almost 8.5â times that of pure CdSe quantum dots under the same conditions. Transient absorption and time-resolved photoluminescence spectroscopies have been used to investigate the charge carrier transfer dynamics in the quantum dot/iron carbonyl cluster assemblies. The spectroscopic results indicate that effective electron transfer from the molecular iron complex to the valence band of the excited CdSe quantum dots significantly inhibits the recombination of photogenerated charge carriers, boosting the photocatalytic activity for hydrogen generation; that is, the iron clusters function as effective intermediaries for electron transfer from the sacrificial electron donor to the valence band of the quantum dots.
RESUMO
An efficient and novel 2,5-bis(benzo[d]thiazol-2-yl)phenol scaffold-based ratiometric fluorescent probe BTP-Cys for the sensing of cysteine has been developed. The probe BTP-Cys with acrylates moiety, as recognition site, has been successfully constructed on account of the excited state intramolecular proton transfer (ESIPT) mechanism. Upon the treatment with Cys (0-250⯵M), this probe BTP-Cys exhibits a dramatic fluorescent intensity ratios enhancement (from 0.03 to 18.3) and a large emission shift (113â¯nm). The detection limit of this probe is as low as 3.8â¯×â¯10-7â¯M. Importantly, the concentration and time dependent of Cys in bovine serum albumin (BSA) has also been measured, indicating that BTP-Cys could be a biocompatible and rapid probe for Cys in vitro.
Assuntos
Cisteína/análise , Corantes Fluorescentes/química , Fenóis/química , Soroalbumina Bovina/análise , Animais , Bovinos , Cisteína/química , Concentração de Íons de Hidrogênio , Limite de Detecção , Técnicas de Sonda Molecular , Soroalbumina Bovina/química , Espectrometria de FluorescênciaRESUMO
There is a mounting effort to use nickel oxide (NiO) as p-type selective electrode for organometal halide perovskite-based solar cells. Recently, an overall power conversion efficiency using this hole acceptor has reached 18%. However, ultrafast spectroscopic investigations on the mechanism of charge injection as well as recombination dynamics have yet to be studied and understood. Using time-resolved terahertz spectroscopy, we show that hole transfer is complete on the subpicosecond time scale, driven by the favorable band alignment between the valence bands of perovskite and NiO nanoparticles (NiO(np)). Recombination time between holes injected into NiO(np) and mobile electrons in the perovskite material is shown to be hundreds of picoseconds to a few nanoseconds. Because of the low conductivity of NiO(np), holes are pinned at the interface, and it is electrons that determine the recombination rate. This recombination competes with charge collection and therefore must be minimized. Doping NiO to promote higher mobility of holes is desirable in order to prevent back recombination.
RESUMO
Based on a novel coumarin-quinolinium platform, probe 2 was rationally designed and synthesized as a novel ratiometric fluorescent sensor for sulfite anions. The probe exhibited a wide dynamic concentration range for sulfite anions in a PBS buffer (containing 1 mg mL(-1) BSA). More importantly, the probe was suitable for ratiometric fluorescence imaging in living cells with high sensitivity, favorable selectivity, and minimal cytotoxicity.
Assuntos
Técnicas Biossensoriais/métodos , Cumarínicos/química , Corantes Fluorescentes/química , Macrófagos/metabolismo , Compostos de Quinolínio/química , Sulfitos/análise , Animais , Sobrevivência Celular , Corantes Fluorescentes/síntese química , Camundongos , Modelos Moleculares , Espectroscopia de Prótons por Ressonância Magnética , Teoria Quântica , Espectrometria de Fluorescência , Fatores de TempoRESUMO
Fluorescence imaging has emerged as a powerful tool for monitoring biomolecules within the context of living systems with high spatial and temporal resolution. Researchers have constructed a large number of synthetic intensity-based fluorescent probes for bio-imaging. However, intensity-based fluorescent probes have some limitations: variations in probe concentration, probe environment, and excitation intensity may influence the fluorescence intensity measurements. In principle, the use of ratiometric fluorescent probes can alleviate this shortcoming. Förster resonance energy transfer (FRET) is one of the most widely used sensing mechanisms for ratiometric fluorescent probes. However, the development of synthetic FRET probes with favorable photophysical properties that are also suitable for biological imaging applications remains challenging. In this Account, we review the rational design and biological applications of synthetic FRET probes, focusing primarily on studies from our laboratory. To construct useful FRET probes, it is a pre-requisite to develop a FRET platform with favorable photophysical properties. The design criteria of a FRET platform include (1) well-resolved absorption spectra of the donor and acceptor, (2) well-separated emission spectra of the donor and acceptor, (3) donors and acceptors with comparable brightness, (4) rigid linkers, and (5) near-perfect efficiency in energy transfer. With an efficient FRET platform in hand, it is then necessary to modulate the donor-acceptor distance or spectral overlap integral in an analyte-dependent fashion for development of FRET probes. Herein, we emphasize our most recent progress on the development of FRET probes by spectral overlap integral, in particular by changing the molar absorption coefficient of the donor dyes such as rhodamine dyes, which undergo unique changes in the absorption profiles during the ring-opening and -closing processes. Although partial success has been obtained in design of first-generation rhodamine-based FRET probes via modulation of acceptor molar absorption coefficient, further improvements in terms of versatility, sensitivity, and synthetic accessibility are required. To address these issues with the first-generation rhodamine-based FRET probes, we have proposed a strategy for the design of second-generation probes. As a demonstration, we have developed FRET imaging probes for diverse targets including Cu²âº, NO, HOCl, cysteine, and H2O2. This discussion of the methods for successfully designing synthetic FRET probes underscores the rational basis for further development of new FRET probes as a molecular toolbox for probing and manipulating a wide variety of biomolecules in living systems.
Assuntos
Desenho de Fármacos , Transferência Ressonante de Energia de Fluorescência/métodos , Corantes Fluorescentes/química , Imagem Molecular/métodos , AbsorçãoRESUMO
In this paper, we report enhanced performance of inverted polymer solar cells composed of poly[2,3-bis-(3-octyloxyphenyl)quinoxaline-5,8-diyl-alt-thiophene-2,5-diyl] (TQ1):[6,6]-phenyl-C(71)-butyric acid methyl ester (PC(71)BM) blends by using poly(ethylene oxide) (PEO)-modified ZnO as an electron transport layer. It is found that PEO modification to the ZnO nanoparticle surface can effectively passivate the surface traps of ZnO, suppress the recombination loss of carriers, reduce the series resistance, and improve the electrical coupling of ZnO/active layer. Consequently, both the short-circuit current (J(SC)) and the fill factor (FF) of the inverted solar cells are considerably improved. The resulting power conversion efficiency (PCE) is improved to 5.64% as compared to 4.5% of the reference device using a ZnO electron transport layer. Moreover, this approach can also successfully improve the J(SC) and FF of anther inverted solar cell composed of poly[N-9â³-hepta-decanyl-2,7-carbazole-alt-5,5-(4',7'-dithienyl-2',1',3'-benzothiadiazole)] (PCDTBT):PC(71)BM blends. The PCE of the device based on the PEO-modified ZnO layer is increased to 6.59% from 5.39% of the reference device based on the ZnO layer.
RESUMO
We have constructed a novel NIR fluorescent turn-on hydrogen sulfide probe suitable for fluorescent imaging in living cells based on thiolysis of dinitrophenyl ether.
Assuntos
Éter/química , Corantes Fluorescentes/química , Sulfeto de Hidrogênio/química , Raios Infravermelhos , Compostos de Boro/química , Humanos , Células MCF-7 , Microscopia de FluorescênciaRESUMO
Pectin, a polysaccharide extracted from the cell wall of plants, was used as the drug carrier to synthesize the pectin-adriamycin conjugates (P(A)n). The structure of the conjugates was confirmed by UV and IR. The degree of esterification (DE) of the pectin was assessed, and it was found that DE significantly influenced the carboxy group contents, inherent viscosity and galacturonic acid contents of the pectin. The results of drug release test in vitro showed that the conjugate was stable in normal saline, but was gradually enzymolyzed to release the adriamycin in blood plasma and in lymph nodes. The results of lymphatic targeting study of P(A), demonstrated that the modification of DE or drug coupling capacity of pectin significantly influenced the lymphatic targeting characteristics of P (A)n. The adriamycin concentration of lymph nodes was 208 times higher than that of plasma after local injection of the P(A)n, of which the adriamycin content was 27.9% and the pectin was deesterificated 120 minutes by the use of hypothermy alkaline deesterification method.