Flue gas torrefaction of municipal solid waste: Fuel properties, combustion characterizations, and nitrogen /sulfur emissions.

Flue gas torrefaction (FGT) was proposed as the pretreatment of the municipal solid waste (MSW) combustion process to improve the fuel properties of MSW and achieve better combustion performance. The optimal FGT parameters were obtained at 300 ℃ and 30 min, with the energy-mass co-benefit index (EMCI) reaching the maximum of 23.38. FGT could significantly increase the heating value and energy density of MSW while reducing the H/C and O/C ratio. Then, the pyrolysis and combustion experiments were performed by tube furnace and TG-MS. The results proved the chemical compositions of MSW were altered, and the heat transfer was enhanced. With FGT, NOx and SO2 emissions could be reduced by 25.7 % and 52.4 %, respectively. This study provides an in-depth understanding of the mechanism of FGT and paves the way for the clean treatment and energy utilization of MSW.

Flue gas torrefaction of distilled spirit lees and the effects on the combustion and nitrogen oxide emission.

Flue gas torrefaction (FGT) integrated with combustion was introduced for the clean treatment of distilled spirit lees (DSL). The effects of temperature, residence time, and volumetric flow rate of FGTs were investigated. The improvement in the physicochemical and combustion characteristics of the torrefied DSL and the reaction mechanisms were clarified by a tube furnace and the TG-MS device. The results showed that FGT could effectively improve the properties of DSL. With increasing temperature, residence time, and volumetric flow rate, the mass and energy yields decreased. FGT showed positive effects on the removal of free and bonding water, as well as the enrichment of lignin. FGT effectively inhibited the release of NOx. The overall emission of NOx was reduced by 57.3%. Additionally, the cost of DSL drying and denitrification could be greatly reduced by FGT. This study provided a practical treatment for DSL and new insight into FGT.

Contamination, ecological and health risks of trace elements in soil of landfill and geothermal sites in Tibet.

Due to the utilization of landfill technology and geothermal energy production in Tibet, the contamination of the soils and underground water by trace element has currently become a serious problem, both ecologically and to the human health point of view. However, relevant studies concerning this critical problem, particularly in the Tibet area has not been found. Therefore, this study investigated the soil contamination and the spatial distribution of the trace elements in the areas surrounding the Tibetan landfill sites (LS) and geothermal sites (GS) through several pollution evaluation models. In addition, the possible sources of trace elements and their potential impact on public health were also investigated. Results showed that the trace elements in soils nearby LS and GS had moderate to high contamination risk. In soils surrounding LS, mercury had the highest concentration of 0.015 mg/kg and was 6 times higher than the background value of 0.008 mg/kg while in GS, arsenic had the highest concentration of 66.55 mg/kg, and exceeded the soil contamination risk value of 25 mg/kg. Maizhokunggar LS was the most polluted site with an average pollution load index value of 2.95 compared to Naqu, Nyingchi, Shigatse, and Lhasa. 42% of LS were with considerable ecological risk, and all GS had low ecological risk. Both carcinogenic and non-carcinogenic risk for children and adults (male, female) were within the acceptable range. According to the source analysis, unscientific anthropogenic activities including accumulated MSW, industrial discharges, and vehicle emissions significantly contributed 51.83% to soil trace element contamination. Considering that Tibet is an environment-ecologically vulnerable region with very weak self-adjustment ability, accumulated municipal solid waste in the landfill sites should be well disposed of, and even soil remediation should be well implemented.