Temporal and spatial evolution of a laser-induced plasma from a steel target.

The space and time evolution of a laser-induced plasma from a steel target has been studied using optical time-of-flight and shadowgraphic techniques. The results, obtained for two distinct laser energy regimes, allow us to individuate two different regions in the plume, one characterized by air and continuum emissions produced by the shock wave ionization and the other characterized by emissions from ablated material. Moreover, it was shown that a sufficiently high laser fluence and short delay time of acquisition are needed to avoid inhomogeneous effects in the plasma, as required in analytical applications such as laser-induced breakdown spectroscopy.

Dose perturbation in the presence of metallic implants: treatment planning system versus Monte Carlo simulations.

An increasing number of patients receiving radiation therapy have metallic implants such as hip prostheses. Therefore, beams are normally set up to avoid irradiation through the implant; however, this cannot always be accomplished. In such situations, knowledge of the accuracy of the used treatment planning system (TPS) is required. Two algorithms, the pencil beam (PB) and the collapsed cone (CC), are implemented in the studied TPS. Comparisons are made with Monte Carlo simulations for 6 and 18 MV. The studied materials are steel, CoCrMo, Orthinox, TiAlV and Ti. Monte Carlo simulated depth dose curves and dose profiles are compared to CC and PB calculated data. The CC algorithm shows overall a better agreement with Monte Carlo than the PB algorithm. Thus, it is recommended to use the CC algorithm to get the most accurate dose calculation both for the planning target volume and for tissues adjacent to the implants when beams are set up to pass through implants.

Residual 60Co activity in steel samples exposed to the Hiroshima atomic-bomb neutrons.

Residual 60Co radioactivity produced by the neutrons from the Hiroshima atomic bomb has been measured by means of gamma-ray spectrometry for seven steel samples located up to 1,800 m slant range and one control sample obtained at 4.5 km from the hypocenter. After removing the main constituent of iron ions from the steel sample by the solvent extraction method, nickel and cobalt were chemically separated by the ion exchange process. Gamma-ray measurements were performed with a low background well-type germanium detector. Derived specific activities 60Co:Co were compared with previous measurements and with the calculation based on the neutron fluence of current dosimetry system DS86. It has been shown that a systematic discrepancy exists between the measured and calculated activity. The calculated-to-measured ratios for 60Co are consistent with those of 152Eu and 36Cl activity.

Photoneutron fields in medical accelerator rooms with primary barriers constructed of concrete and metals.

This study investigates the photoneutron field found in medical accelerator rooms with primary barriers constructed of metal slabs plus concrete. An increased neutron dose equivalent was observed for barriers containing lead or steel as compared to barriers fabricated entirely of concrete. The effect of the beam's size and distance from the primary barriers on the neutron dose was evaluated and the portion of the neutron dose due to the metal slabs was determined.

Determination of 60Co activity in steel samples in Hiroshima.

Specific activity of 60C in two steel samples taken at 687m S and 1295m NNW from the hypocenter was measured by gamma-ray spectrometry and neutron activation analysis. The results are consistent with previous data by Hashizume et al. for steel rings on the surface of roofs of buildings. content of nickel and copper in the samples was found to be too small to account for any significant 60Co production by fast neutron reactions.

Determination of specific activity of cobalt (60Co/Co) in steel samples exposed to the atomic bomb in Hiroshima.

Specific activity 60Co/Co in two steel samples taken at 687m S and 1295m NNW from the hypocenter was measured by gamma-ray spectrometry and neutron activation analysis. The results were, respectively, (2.64 +/- 0.38) x 10(1) and (3.09 +/- 0.48) x 10(-1) dpm/mg Co at the time of bombing, which are consistent with previous data by Hashizume et al. for steel rings on the surface of roofs of buildings. The present data are expected to serve as verification of the bomb neutron transport calculations. Content of nickel and copper in the samples, determined by colorimetric and neutron activation methods, respectively, was too small to account for any significant 60Co production by the (n,p) and (n, alpha) reactions.