PM 2.5 Airborne Particulates Near Frac Sand Operations.

The rapid growth of hydraulic fracturing for oil and gas extraction in the U.S. has led to 135 active "frac" sand mines, processing plants, and rail transfer stations in Wisconsin. Potential environmental health risks include increased truck traffic, noise, ecosystem loss, and groundwater, light, and air pollution. Emitted air contaminants include fine particulate matter (PM2.5) and respirable crystalline silica. Inhalation of fine dust particles causes increased mortality, cardiovascular disease, lung disease, and lung cancer. In the authors' pilot study, use of a filter-based ambient particulate monitor found PM2.5 levels of 5.82-50.8 µg/m3 in six 24-hour samples around frac sand mines and processing sites. Enforcement of the existing U.S. Environmental Protection Agency annual PM2.5 standard of 12 µg/m3 is likely to protect the public from silica exposure risks as well. PM2.5 monitoring around frac sand sites is needed to ensure regulatory compliance, inform nearby communities, and protect public health.

Flexural toughness of steel fiber reinforced high performance concrete containing nano-SiO2 and fly ash.

This paper aims to clarify the effect of steel fiber on the flexural toughness of the high performance concrete containing fly ash and nano-SiO2. The flexural toughness was evaluated by two methods, which are based on ASTM C1018 and DBV-1998, respectively. By means of three-point bending method, the flexural toughness indices, variation coefficients of bearing capacity, deformation energy, and equivalent flexural strength of the specimen were measured, respectively, and the relational curves between the vertical load and the midspan deflection (P(V)-δ) were obtained. The results indicate that steel fiber has great effect on the flexural toughness parameters and relational curves (P(V)-δ) of the three-point bending beam specimen. When the content of steel fiber increases from 0.5% to 2%, the flexural toughness parameters increase gradually and the curves are becoming plumper and plumper with the increase of steel fiber content, respectively. However these flexural toughness parameters begin to decrease and the curves become thinner and thinner after the steel fiber content exceeds 2%. It seems that the contribution of steel fiber to the improvement of flexural toughness of the high performance concrete containing fly ash and nano-SiO2 is well performed only when the steel fiber content is less than 2%.

Pooled exposure-response analyses and risk assessment for lung cancer in 10 cohorts of silica-exposed workers: an IARC multicentre study.

OBJECTIVES: Silica is one of the most common occupational exposures worldwide. In 1997 the International Agency for Research on Cancer (IARC) classified inhaled crystalline silica as a human carcinogen (group 1), but acknowledged limitations in the epidemiologic data, including inconsistencies across studies and the lack of extensive exposure-response data. We have conducted a pooled exposure-response analysis of 10 silica-exposed cohorts to investigate lung cancer. METHODS: The pooled cohort included 65,980 workers (44,160 miners, 21,820 nominees), and 1,072 lung cancer deaths (663 miners, 409 nonminers). Follow-up has been extended for five of these cohorts beyond published data. Quantitative exposure estimates by job and calendar time were adopted, modified, or developed to permit common analyses by respirable silica (mg/m3) across cohorts. RESULTS: The log of cumulative exposure, with a 15-year lag, was a strong predictor of lung cancer (p = 0.0001), with consistency across studies (test for heterogeneity, p = 0.34). Results for the log of cumulative exposure were consistent between underground mines and other facilities. Categorical analyses by quintile of cumulative exposure resulted in a monotonic trend with odds ratios of 1.0. 1.0, 1.3, 1.5, 1.6. Analyses using a spline curve also showed a monotonic increase in risk with increasing exposure. The estimated excess lifetime risk (through age 75) of lung cancer for a worker exposed from age 20 to 65 at 0.1 mg/m3 respirable crystalline silica (the permissible level in many countries) was 1.1-1.7%, above background risks of 3-6%. CONCLUSIONS: Our results support the decision by the IARC to classify inhaled silica in occupational settings as a carcinogen, and suggest that the current exposure limits in many countries may be inadequate. These data represent the first quantitative exposure-response analysis and risk assessment for silica using data from multiple studies.

Is Percoll safe for in vivo use?

Fourteen virgin female rabbits were injected with 60% Percoll solution in the right ovary and uterine horn and sperm prepared with Percoll in the left ovary and uterine horn. Histologic examination after 4 weeks showed no inflammatory cell infiltration in either uterine horns or ovaries.