A re-evaluation of silk measurement by the cecropia caterpillar (Hyalophora cecropia) during cocoon construction reveals use of a silk odometer that is temporally regulated.

The late 5th instar caterpillar of the cecropia silk moth (Hyalophora cecropia) spins a silken cocoon with a distinct, multilayered architecture. The cocoon construction program, first described by the seminal work of Van der Kloot and Williams, consists of a highly ordered sequence of events. We perform behavioral experiments to re-evaluate the original cecropia work, which hypothesized that the length of silk that passes through the spinneret controls the orderly execution of each of the discrete events of cocoon spinning. We confirm and extend by three-dimensional scanning and quantitative measurements of silk weights that if cocoon construction is interrupted, upon re-spinning, the caterpillar continues the cocoon program from where it left off. We also confirm and extend by quantitative measurements of silk weights that cecropia caterpillars will not bypass any of the sections of the cocoon during the construction process, even if presented with a pre-spun section of a cocoon spun by another caterpillar. Blocking silk output inhibits caterpillars from performing normal spinning behaviors used for cocoon construction. Surprisingly, unblocking silk output 24-hr later did not restart the cocoon construction program, suggesting the involvement of a temporally-defined interval timer. We confirm with surgical reductions of the silk glands that it is the length of silk itself that matters, rather than the total amount of silk extracted by individuals. We used scanning electron microscopy to directly show that either mono- or dual-filament silk (i.e., equal silk lengths but which vary in their total amount of silk extracted) can be used to construct equivalent cocoons of normal size and that contain the relevant layers. We propose that our findings, taken together with the results of prior studies, strongly support the hypothesis that the caterpillar uses a silk "odometer" to measure the length of silk extracted during cocoon construction but does so in a temporally regulated manner. We further postulate that our examination of the anatomy of the silk spinning apparatus and ablating spinneret sensory output provides evidence that silk length measurement occurs upstream of output from the spinneret.

A Gelatin-sulfonated Silk Composite Scaffold based on 3D Printing Technology Enhances Skin Regeneration by Stimulating Epidermal Growth and Dermal Neovascularization.

One of the key problems hindering skin repair is the deficiency of dermal vascularization and difficulty of epidermis regeneration, which makes it challenging to fabricate scaffolds that can biologically fulfill the requirements for skin regeneration. To overcome this problem, three-dimensional printing was used to fabricate a gelatin-sulfonated silk composite scaffold that was incorporated with basic fibroblast growth factor 2 (FGF-2) through binding with a sulfonic acid group (SO3) (3DG-SF-SO3-FGF). The efficacy and mechanism by which the 3DG-SF-SO3-FGF scaffolds promote skin regeneration were investigated both within in vitro cell culture and in vivo with a full-thickness skin defect model. The histological results showed that the gelatin-sulfonated silk composite scaffolds promoted granulation, and that incorporation of FGF-2 significantly enhanced the regeneration of skin-like tissues after implantation in rat skin defects for 14 and 28 days. Further investigations demonstrated that 3DG-SF-SO3-FGF scaffolds might stimulate dermal vascularization. These findings thus suggest that incorporation of FGF-2 into the 3D printed scaffolds is a viable strategy for enhancing skin regeneration.

[Investigation of fibrous cultural materials by infrared spectroscopy].

Cultural fibrous material includes both important categories, i. e. textile and paper, consisting of precious cultural materials in museum, such as costume, painting, and manuscript. In recent years more and more connoisseur and conservator's concerns are, through nondestructive method, the authenticity and the ageing identification of these cultural relics especially made from fragile materials. In this research, we used attenuated total reflection infrared spectroscopy to identify five traditional textile fibers, alongside cotton, linen, wool, mulberry silk and tussah silk, and another five paper fibers alongside straw, wheat straw, long qisong, Chinese alpine rush and mulberry bar, which are commonly used for making Chinese traditional xuan paper. The research result showed that the animal fiber (wool, mulberry silk and tussah silk) and plant fiber (cotton and linen) were easier to be distinguished by comparing the peaks at 3 280 cm-1 belonging to NH stretching vibration and a serious peaks related to amide I to amide III. In the spectrum of wool, the peak at 1 076 cm-1 was assigned to the S-O stretching vibration absorption of cystine in wool structure and can be used to tell wool from silk. The spectrum of mulberry silk and tussah silk seems somewhat difficult to be identified, as well as the spectrum of cotton and linen. Five rural paper fibers all have obvious characteristic peaks at 3 330, 2 900 cm-1 which are related to OH and CH stretching vibration. In the fingerprint wavenumber range of 1 600 - 800 cm, the similar peaks also appeared at 1 370, 1 320 cm-1 and 1 162, 1 050 cm-1, both group peaks respectively are related to CH and CO vibration in the structure of cellulose and hemicellulose in paper fibers. Although there is more similarity of the infrared spectroscopy of these 5 paper fibers, some tiny difference in absorbance also can be found at 3 300 cm-1 and in the fingerprint range at 1 332, 1 203, and 1 050 cm-1 which are related to C-O-C vibration in cellulose. Moreover, in order to explore direct and simple method to identify different materials with similar spectrum,. the principal component analysis (PCA) was applied to separate cotton and linen, mulberry silk and tussah silk, as well as five paper fibers. To eliminate and reduce the spectral scattering caused by sample uneven surface roughness, the multiplicative scatter correction (MSC) has been applied based on total spectral data. The result showed that the score plot using the first two principal components can effectively categorize both group textiles of cotton and linen, as well as mulberry silk and tussah silk, and they have similar chemical structure. For five paper fibers, the PCA was applied in different spectral range (918-550, 1 280-918, 1 700-1 280 and 3 800-2 800 cm-1), and the best result appeared in the range from 3 800 to 2 800 cm-1, in which the five paper fibers can be well categorized. This research showed that infrared spectroscopy combined with principal component analysis has great potential advantage on identifying fibrous materials with similar structure.

Dragline silk: a fiber assembled with low-molecular-weight cysteine-rich proteins.

Dragline silk has been proposed to contain two main protein constituents, MaSp1 and MaSp2. However, the mechanical properties of synthetic spider silks spun from recombinant MaSp1 and MaSp2 proteins have yet to approach natural fibers, implying the natural spinning dope is missing critical factors. Here we report the discovery of novel molecular constituents within the spinning dope that are extruded into dragline silk. Protein studies of the liquid spinning dope from the major ampullate gland, coupled with the analysis of dragline silk fibers using mass spectrometry, demonstrate the presence of a new family of low-molecular-weight cysteine-rich proteins (CRPs) that colocalize with the MA fibroins. Expression of the CRP family members is linked to dragline silk production, specifically MaSp1 and MaSp2 mRNA synthesis. Biochemical data support that CRP molecules are secreted into the spinning dope and assembled into macromolecular complexes via disulfide bond linkages. Sequence analysis supports that CRP molecules share similarities to members that belong to the cystine slipknot superfamily, suggesting that these factors may have evolved to increase fiber toughness by serving as molecular hubs that dissipate large amounts of energy under stress. Collectively, our findings provide molecular details about the components of dragline silk, providing new insight that will advance materials development of synthetic spider silk for industrial applications.

[Infrared spectroscopy investigation on conformational change of silk fiber induced by gaseous organic acids existing in museum].

Study on the impact of pollutants on cultural materials in storing or displaying micro-environment in museum is considered as very important for the preservation of cultural relics and its aging prevention. This paper applied the Fourier transform infrared (attenuated total reflection) technique to assess silk structural changes under volatile organic acids (formic acid/acetic acid), which usually come from decorative materials emission and commonly exist in the surface or around cultural materials. The focus of this work was on investigating the changes of peptide bond in the area of amide I-amide III, as well as the peptide chains (GlyAla), characteristic region. The structural and conformational changes in silk fiber treated with gaseous formic and acetic acid were assessed. The results indicate that both the gaseous acids can weaken the intermolecular hydrogen bond in fiber peptide, based on the spectral changes in the increased intensity of amide I (1 617 cm(-1)), the narrowing amide II peak (1 515 cm(-1)), the increased intensity of random coil conformation in amide III peak (1 230 cm(-1)), and the decreased fiber crystallinity as well. The obvious secondary structural conformation occurred when the concentration of gaseous formic acid reached 8.1 mg x m(-3) in simulated environment. The conformational transformation was supported by the observation of the rapidly reduced random coil conformation, the increased short peptide chains (GlyAla)n with beta-sheet conformation characteristic peak (1 000, 975 cm(-1)), and the enhanced fiber crystallinity degree as well. In contrast, gaseous acetic acid has less impact on the amide I and amide II bond based on the spectral changes, but it did promote random coil conformation and decreased fiber crystallinity. This work also provides a potential application of the infrared spectroscopy in non-destructive investigation of silk in-situ.