Two-phase and three-phase liquid-phase microextraction of hydrochlorothiazide and triamterene in urine samples.

This paper reports the applicability of two-phase and three-phase hollow fiber based liquid-phase microextraction (HF-LPME) for the extraction of hydrochlorothiazide (HYD) and triamterene (TRM) from human urine. The HYD in two-phase HF-LPME is extracted from 24 mL of the aqueous sample into an organic phase with microliter volume located inside the pores and lumen of a polypropylene hollow fiber as acceptor phase, but the TRM in three-phase HF-LPME is extracted from aqueous donor phase to organic phase and then back-extracted to the aqueous acceptor phase, which can be directly injected into HPLC for analysis. Under optimized conditions preconcentration factors of HYD and TRM were obtained as 128 and 239, respectively. The calibration curves were linear (R(2) ≥ 0.995) in the concentration range of 1.0-100 µg/L for HYD and 2.0-100 µg/L for TRM. The limits of detection for HYD and TRM were 0.5 µg/L. The intra-day and inter-day RSD based on four replicates were obtained as ≤5.8 and ≤9.3%, respectively. The methods were successfully applied for determining the concentration of the drugs in urine samples. Copyright © 2015 John Wiley & Sons, Ltd.

Capillary electrophoretic determination of triamterene, methotrexate, and creatinine in human urine.

A capillary zone electrophoresis (CZE) method using a fused-silica capillary (60.2 cm x 75 microm ID) was investigated for the determination of triamterene (TRI), methotrexate (MTX), and creatinine (CREA) in human urine. The separation was performed using a hydrodynamic injection time of 7 s (0.5 psi), a voltage of 25 kV, a capillary temperature of 30 degrees C, and 40 mM phosphoric acid adjusted to pH 2.25 by addition of triethanolamine as separation electrolyte. Under these conditions, analysis takes about 15 min. A linear response over the 0.5-15.0 mg L(-1) concentration range was found for TRI and MTX, and 0.5-80.0 mg L(-1) for CREA. Dilution of the sample (water:urine, 1:1 for TRI and MTX, and 1:25 for CREA determination) was the only step necessary prior to analysis by electrophoresis. The developed method is easy, rapid, and sensitive and has been applied to determine triamterene,methotrexate, and creatinine in urine samples with satisfactory results.