Bone quality assessment in patients with healing mandibular fracture sites: a computed tomography investigation.

The objective of this retrospective study was to assess the bone quality of healing mandibular fracture sites by measuring the Hounsfield units (HU) on computed tomographic (CT) images obtained presurgery and postsurgery in patients treated with rigid internal fixation (RIF). The HU values of healing fracture sites were compared to those of corresponding nonfractured (control) sites on the opposing side and cervical vertebrae sites in the same patients. In total, 31 patients with 45 mandibular fractures treated with RIF underwent presurgical and postsurgical CT examinations. The scans performed after surgery (1, 3, 6, 12, or 18 months) were taken only when there was a need for radiographic evaluation due to a complaint of discomfort from the patient or when the surgeon needed to verify the postsurgical outcome, and each patient underwent only a single postsurgical CT. At the presurgical CT examination, the HU values were lower in the fracture sites than in the control sites. At 3 months postsurgery, the HU values in the fracture sites had increased as the mandibular bone healed. At 6 months postsurgery, the HU values in the fracture sites were higher than those of the control sites. At 12 and 18 months postsurgery, the HU values of both sites were similar. The HU values of the cervical vertebrae remained constant with time. These results suggest that, in patients who have been treated with RIF for mandibular bone fracture, HU values measured by CT vary across time, expressing the physiologic bone healing process.

Assessment of the correlation between mandibular radiomorphometric patterns and dual-energy X-ray absorptiometry measurements for screening bone mineral density.

The objective of this study was to investigate the correlation between scores for femoral and lumbar spine bone mineral density (dual-energy X-ray absorptiometry [DXA]) and visual, qualitative mandibular bone pattern assess¬ments (mandibular cortical index, trabecular bone pattern, and visual mandibular cortical width) as well as age and body mass index. Three trained observers evaluated 200 panoramic radiographs and 200 femoral and lumbar spine DXA measurements from 100 male and 100 female participants. The κ test showed an acceptable agreement among observers (0.73; P = 0.003). The Shapiro-Wilk test revealed that the variables were not normally distributed, so the Spearman correlation test was used. The mean age of the sample was 60.7 (13.9) years, and 86.0% of the patients were White. There were inverse correlations between the mandibular cortical index and the spine T-score in men, women, and the total sample as well as between the spine Z-score in the total sample. An inverse correlation was observed between the trabecular bone pattern and the spine T- and Z-scores in women and the total sample. The results also showed inverse correlations between the visual mandibular cortical width and all parameters analyzed in men, women, and the total sample except for the femur T-score and spine T- and Z-scores in men. Body mass index was correlated with all DXA parameters. Age was inversely correlated with femur T-scores in men and women but not with spine DXA values in men. The results suggest that qualitative assessments of radiomorphometric patterns on panoramic radiographs correlate with DXA values and therefore are suitable for screening patients at risk of developing low bone mineral density.

Assessment of mandibular cortical index in patients with hepatic cirrhosis: A case-control study.

AIMS: To assess the presence of alterations suggestive of reduced bone mineral density (BMD) by using mandibular cortical index (MCI) in panoramic radiographs of cirrhotic individuals and to evaluate their relationship with other characteristics of hepatic cirrhosis (HC). METHODS AND RESULTS: This is an observational case-control study assessing the medical records of 165 cirrhotic patients matched by sex and age with healthy individuals. MELD (model of end stage liver disease) score, etiology, complications, comorbidities, and serum levels of vitamin D were collected. MCI was used to obtain BMD. Binary logistic regression was used to test associations and the risk estimates were expressed in odds ratio. Most of the sample consisted of men (73.93%) with median age of 56 years old. In the study group, the mean value of MELD was 16.5 and hepatitis C was the main etiology of HC (33.9%). Cirrhotic individuals are 3.99 times more likely to present alterations suggestive of reduced BMD (p < .01). There was no statistical significance in the association of MCI with levels of vitamin D, comorbidities, etiology or cirrhosis complications. CONCLUSIONS: MCI suggestive of reduced BMD is more likely to be identified in panoramic radiographs of cirrhotic individuals than of healthy ones.

Imaging features of Stafne bone defects on computed tomography: An assessment of 40 cases.

PURPOSE: This study was performed to assess and describe the imaging features of 40 cases of Stafne bone defects (SBDs) on computed tomographic (CT) examinations. MATERIALS AND METHODS: This study collected data, including age and sex, from 40 patients with SBDs who underwent CT exams. The imaging features of the SBDs were assessed in terms of their location, average size, the relationship of their contour with the cortical plate of the lingual mandible, bone margins, degree of internal density, shape, topographic relationship between the defect and the mandibular edge, the distance from the SBD to the base of the mandible, and the Ariji classification (type I, II, and III). RESULTS: The average age was 57.3 years (range, 28-78 years), and the patients were predominantly male (70%). In all cases (100%), the posterior unilateral lingual SBD variant was observed. Within the Ariji classification, type I was the most common (60%). Among the most frequently observed radiographic characteristics were thick sclerotic bone margin across the entire defect contour, completely hypointense internal content, an oval shape, and continuity with the mandibular base with discontinuity of the mandibular edge. CONCLUSION: This study showed that posterior SBDs could present with an oval or rounded shape, complete hypodensity, and thick sclerotic margins. Likewise, SBDs could appear almost anywhere, with minor differences from the classic SBD appearance. It is fundamental for dental practitioners to know the imaging features of SBDs, since they are diagnosed primarily based on imaging.

Assessment of alveolar bone marrow fat content using 15 T MRI.

OBJECTIVES: Bone marrow fat is inversely correlated with bone mineral density. The aim of this study is to present a method to quantify alveolar bone marrow fat content using a 15 T magnetic resonance imaging (MRI) scanner. STUDY DESIGN: A 15 T MRI scanner with a 13-mm inner diameter loop-gap radiofrequency coil was used to scan seven 3-mm diameter alveolar bone biopsy specimens. A 3-D gradient-echo relaxation time (T1)-weighted pulse sequence was chosen to obtain images. All images were obtained with a voxel size (58 µm3) sufficient to resolve trabecular spaces. Automated volume of the bone marrow fat content and derived bone volume fraction (BV/TV) were calculated. Results were compared with actual BV/TV obtained from micro-computed tomography (CT) scans. RESULTS: Mean fat tissue volume was 20.1 ± 11%. There was a significantly strong inverse correlation between fat tissue volume and BV/TV (r = -0.68; P = .045). Furthermore, there was a strong agreement between BV/TV derived from MRI and obtained with micro-CT (interclass correlation coefficient = 0.92; P = .001). CONCLUSIONS: Bone marrow fat of small alveolar bone biopsy specimens can be quantified with sufficient spatial resolution using an ultra-high-field MRI scanner and a T1-weighted pulse sequence.

Assessment of osteoporotic alterations in achondroplastic patients: a case series.

Achondroplasia (ACH) is the most common form of human dwarfism and has been associated with biochemical alterations of the bone tissue, also observed in cases of osteoporosis. The present case series aimed at assessing low bone density, diagnosed with spinal bone mineral density (BMD) analysis and with panoramic radiograph measurements, in ACH patients. Spinal BMD was measured by means of dual-energy X-ray absorptiometry at the lumbar region (L1-L4). On dental panoramic radiographs of the patients, the mandibular cortical width was measured separately on the right and left sides. The Klemetti Index was also assigned as appropriate for evaluating the cortical area below the mandibular foramen. Additional parameters such as patient age, gender, body mass index, and number of teeth were also recorded. BMD results showed that 5/11 cases presented with skeletal osteopenia/osteoporosis diagnoses. Additionally, mandibular cortical erosion was detected in panoramic radiographs in 8/11 cases. The BMD and panoramic radiographic alterations found in this study suggest that the diagnosis of low bone density may have a special clinical relevance in cases of bone tissue disorders, such as achondroplasia.

Avaliação do risco à osteopenia/osteoporose através do questionário avaliativo e sua associação com a análise morfológica do cortéx inferior da mandíbula realizadas em radiografias panorámicas / Risk assessment of osteopenia/osteoposis through the evaluation questionnaire and its association with the morphological analysis of the mandibular inferior cortex in panoramics radiographs

Objetivo: os autores apresentam uma proposta de questionário e conduta para referenciar pacientes com risco de osteoporose para avaliação médica...

Objective: The authors prepared a questionnaire for referring patients about the risk at osteoporosis...

Assessment of simulated mandibular condyle bone lesions by cone beam computed tomography.

There are many limitations to image acquisition, using conventional radiography, of the temporomandibular joint (TMJ) region. The Computed Tomography (CT) scan is a better option, due to its higher accuracy, for purposes of diagnosis, surgical planning and treatment of bone injuries. The aim of the present study was to analyze two protocols of cone beam computed tomography for the evaluation of simulated mandibular condyle bone lesions. Spherical lesions were simulated in 30 dry mandibular condyles, using dentist drills and drill bits sizes 1, 3 and 6. Each of the mandibular condyles was submitted to cone beam computed tomography (CBCT) using two protocols: 1) axial, coronal and sagittal multiplanar reconstruction (MPR); and 2) sagittal plus coronal slices throughout the longitudinal axis of the mandibular condyles. For these protocols, 2 observers analyzed the CBCT images independently, regarding the presence or not of injuries. Only one of the observers, however, performed on 2 different occasions. The results were compared to the gold standard, evaluating the percentage of agreement, degree of accuracy of CBCT protocols and observers' examination. The z test was used for the statistical analysis. The results showed there were no statistically significant differences between the 2 protocols. There was greater difficulty in the assessment of small-size simulated lesions (drill # 1). From the results of this study, it can be concluded that CBCT is an accurate tool for analyzing mandibular condyle bone lesions, with the MPR protocol showing slightly better results than the sagittal plus coronal slices throughout the longitudinal axis.

Assessment of simulated mandibular condyle bone lesions by cone beam computed tomography

There are many limitations to image acquisition, using conventional radiography, of the temporomandibular joint (TMJ) region. The Computed Tomography (CT) scan is a better option, due to its higher accuracy, for purposes of diagnosis, surgical planning and treatment of bone injuries. The aim of the present study was to analyze two protocols of cone beam computed tomography for the evaluation of simulated mandibular condyle bone lesions. Spherical lesions were simulated in 30 dry mandibular condyles, using dentist drills and drill bits sizes 1, 3 and 6. Each of the mandibular condyles was submitted to cone beam computed tomography (CBCT) using two protocols: 1) axial, coronal and sagittal multiplanar reconstruction (MPR); and 2) sagittal plus coronal slices throughout the longitudinal axis of the mandibular condyles. For these protocols, 2 observers analyzed the CBCT images independently, regarding the presence or not of injuries. Only one of the observers, however, performed on 2 different occasions. The results were compared to the gold standard, evaluating the percentage of agreement, degree of accuracy of CBCT protocols and observers' examination. The z test was used for the statistical analysis. The results showed there were no statistically significant differences between the 2 protocols. There was greater difficulty in the assessment of small-size simulated lesions (drill # 1). From the results of this study, it can be concluded that CBCT is an accurate tool for analyzing mandibular condyle bone lesions, with the MPR protocol showing slightly better results than the sagittal plus coronal slices throughout the longitudinal axis.