Low-Cost Laser Micromachining Super Hydrophilic-Super Hydrophobic Microgrooves for Robotic Capillary Micromanipulation of Microfibers.

Capillary self-alignment technique can achieve highly accurate and fast alignment of micro components. Capillary self-alignment technique relies on the confinement of liquid droplets at receptor sites where hydrophobic-hydrophilic patterns are widely used. This paper reports a low-cost microsecond pulse laser micromachining method for fabrication of super hydrophilic-super hydrophobic grooves as receptor sites for capillary self-alignment of microfibers. We investigated the influence of major manufacturing parameters on groove sizes and wetting properties. The effects of the width (20 µm-100 µm) and depth (8 µm-36 µm) of the groove on the volume of water droplet contained inside the groove were also investigated. We show that by altering scanning speed, using a de-focused laser beam, we can modify the wetting properties of the microgrooves from 10° to 120° in terms of the contact angle. We demonstrated that different types of microfibers including natural and artificial microfibers can self-align to the size matching super hydrophilic-super hydrophobic microgrooves. The results show that super hydrophilic-super hydrophobic microgrooves have great potential in microfiber micromanipulation applications such as natural microfiber categorization, fiber-based microsensor construction, and fiber-enforced material development.

Molecule-Graphene Hybrid Materials with Tunable Mechanoresponse: Highly Sensitive Pressure Sensors for Health Monitoring.

The development of pressure sensors is crucial for the implementation of electronic skins and for health monitoring integrated into novel wearable devices. Tremendous effort is devoted toward improving their sensitivity, e.g., by employing microstructured electrodes or active materials through cumbersome processes. Here, a radically new type of piezoresistive pressure sensor based on a millefeuille-like architecture of reduced graphene oxide (rGO) intercalated by covalently tethered molecular pillars holding on-demand mechanical properties are fabricated. By applying a tiny pressure to the multilayer structure, the electron tunnelling ruling the charge transport between successive rGO sheets yields a colossal decrease in the material's electrical resistance. Significantly, the intrinsic rigidity of the molecular pillars employed enables the fine-tuning of the sensor's sensitivity, reaching sensitivities as high as 0.82 kPa-1 in the low pressure region (0-0.6 kPa), with short response times (≈24 ms) and detection limit (7 Pa). The pressure sensors enable efficient heartbeat monitoring and can be easily transformed into a matrix capable of providing a 3D map of the pressure exerted by different objects.

Nonclinical Safety Assessment of Morus alba L. Fruits: Study of 90-D Toxicity in Sprague Dawley Rats and Genotoxicity in Salmonella.

Morus alba L. is a traditional herb with a long history of consumption, both as an edible fruit and as medicine. However, its safety evaluation has not yet been established. The objective of this study was to evaluate subchronic oral toxicity and genotoxicity of M. alba L. fruits (MFE). The subchronic toxicity after daily oral administration of MFE at 0, 40, 200, and 1000 mg/kg for 90 d was examined in Sprague Dawley (SD) rats. MFE administration did not lead to death, adverse effects, change in food and water consumption, and body weight gain. Significant toxic effects were not found within the parameters of organ weight, biochemical values, and hematological and urine analysis between the control and the MFE group. The genotoxicity of MFE was assayed by Ames test in Salmonella typhimurium strains TA98, TA102, and TA1535. No genotoxicity was found in all the tested strains. Thus in this study, a no-observed-adverse-effect level for MFE in 90 d repeated oral toxicity study in rats was determined to be greater than 1000 mg/kg regardless of gender. The results also suggested that MFE does not have a genotoxicity potential.