Inhalation health risk assessment of incineration and landfill in the Bohai Rim, China.

An inhalation health risks assessment of 96 waste to energy (WtE) plants and 178 landfills in the Bohai Rim, located in northeast China, has been conducted. Based on the latest emission inventories in 2020, WRF/CALPUFF was used to simulate the diffusion of pollutants. Population-weighted hazard index (HI) and carcinogenic risk (CR) of incineration and landfill for each pollutant and each target organ impacted were calculated. The health risks of incineration and landfill were correlated with per capita municipal solid waste (MSW) disposal quantity, emission factors, pollutant toxic effects and local migration and diffusion conditions. The HI of incineration and landfill in the Bohai Rim were 4.07 × 10-3 and 4.79 × 10-3, respectively, which was lower than the acceptable level (HI < 1), while the CR of incineration and landfill were 4.72 × 10-7 and 2.58 × 10-7, respectively, which was also lower than the acceptable level (CR < 1 × 10-6). The non-carcinogenic risks of incineration mainly targeted respiratory system and development system, while the non-carcinogenic risks of landfill mainly targeted nervous system and respiratory system. The carcinogenic risks of incineration mainly targeted respiratory system and digestive system, while the carcinogenic risks of landfill mainly targeted hepatic system and respiratory system. With the trend that incineration phase in, while landfill phase out, the number of patients for 15 target organ diseases caused by the disposal of unit mass MSW would decrease in the Bohai Rim, ranging from 1.8 × 10-8 - 1.8 × 10-2 (pop/t)，especially in developed provinces, such as Beijing and Tianjin. However, the number of patients for 4 target organ diseases caused by the disposal of unit mass MSW would increase, ranging from 1.18 × 10-6 - 5.28 × 10-3 (pop/t). Based on pollutants' pathogenic mechanisms, this study innovatively accessed and compared incineration and landfill's health risks of target organs, and provide technical and policy suggestions based on the changing trend of MSW disposal methods in the future.

Environmental, economic, and energy analysis of municipal solid waste incineration under anoxic environment in Tibet Plateau.

The first Municipal solid waste incineration (MSWI) plant in Lhasa, Tibet, the plateau region of China, started its operation in 2018. Considering the elevation and extreme climate (low pressure and low oxygen content) in Tibet, noticeable differences may be envisaged compared to MSWI elsewhere. The aim of this study is to evaluate the environmental impacts, economic benefits, and energy efficiency of this MSWI project with three representative MSWI case in plain region using Life cycle assessment (LCA), Cost-benefit analysis (CBA), and energy analysis methods. The result showed that enhancing blast volume and cross-sectional area of the boiler help adapt to the oxygen-deficient environment. GaBi model was employed based on the CML 2001 methodology to perform LCA. LCA shows that the Lhasa MSWI project has lower positive environment impacts than the projects in plain region. More attention is needed for the deficiencies in flue gas emissions of MSWI in the plateau region. CBA shows that the payback period is 11.97 years and the internal rate of return is 8.75%. The energy analysis indicates that the boiler energy efficiency is up to 81.92%. MSWI subject to minor changes seems suitable to Tibetan plateau, and can be deployed further.

Distribution characteristics and potential ecological risk assessment of heavy metals in soils around Shannan landfill site, Tibet.

At present, sanitary landfill is mainly used for domestic waste treatment in Shannan City, Tibet. However, there are few studies on heavy metals in the soil around the landfill in Shannan city. Therefore, the surrounding soil of Luqionggang landfill in Shannan City, Tibet Autonomous Region, is taken as the research object. In the study, the geo-accumulation index method, Nemerow comprehensive pollution index method and potential ecological risk index method are mainly used to evaluate the pollution and risk of heavy metals in the soil around the landfill site. The main results are as follows: The average pH value of the soil around the landfill site is 9.37, belonging to the strong alkaline range. The average values of heavy metals Hg and Ni in soil exceeded the background content, and the average contents of other heavy metals Cu, Pb, Zn, Cr, As and Cd did not exceed the background content. The average content of these eight heavy metals did not exceed the screening value of the national soil environmental quality standard. In the horizontal direction, the average content of heavy metal elements Cu, Cr, Cd, Hg and Ni is relatively high in the west. The average content of heavy metals As, Zn and Pb in the north, east and south is slightly higher than that in the west. And the farther away from the landfill, the less the soil is affected by heavy metals. The evaluation results of geo-accumulation index show that heavy metal Hg is the most affected. The average value of the comprehensive pollution index is 2.969, which is between 2 and 3, belonging to the moderate pollution level. And the west side of the landfill (downstream area) is greatly affected. The evaluation results of potential ecological hazard pollution index show that the potential risk index of single pollutants of heavy metals Cu, Pb, Zn, Cr, Ni, As and Cd belongs to low ecological hazard level, and the potential risk index of single pollutants of heavy metal Hg belongs to relatively heavy ecological hazard level. On the whole, the total potential risk coefficient belongs to medium pollution hazard degree. According to the correlation analysis, there is no significant correlation between heavy metal elements As and Hg and the other six heavy metal elements. In addition, the pollution source of heavy metal As may be mainly soil forming factors and the pollution source of Hg may be mainly human factors.

Phytoremediation of Cd-contaminated farmland soil via various Sedum alfredii-oilseed rape cropping systems: Efficiency comparison and cost-benefit analysis.

Phytoremediation is a green technology for heavy metal removal from contaminated soil, and its remediation efficiency and economic feasibility in field trial should be evaluated before large-scale application. However, there is still lacking relevant analysis, especially for phytoremediation with different cropping patterns. In the present study, we performed phytoremediation on slightly Cd-contaminated farmland soil via three cropping systems, i.e. Sedum alfredii monoculture, oilseed rape monoculture, and S. alfredii-oilseed rape intercropping. Dry weights of S. alfredii and oilseed rape were both enhanced under intercropping pattern, while the highest total Cd extraction amount (148 g ha-1) were observed under S. alfredii monoculture. Furtherly, a cost-benefit analysis via Monta Carlo simulation in a ten-year lifetime was conducted. The benefits of S. alfredii monoculture and intercropping schemes would offset the total costs in 6 and 8 years, respectively. S. alfredii monoculture achieved a higher net present value of 1.88 × 104 US$ as compared with intercropping (9.53 × 103 US$). These results indicate that S. alfredii monoculture scheme could be a promising phytoremediation strategy for slightly Cd-contaminated soil owing to better remediation efficiency and economic feasibility. Moreover, the enhancement in mechanization level and the reduction of seedling cost could further improve its economic viability.

Assessment of biomass demineralization on gasification: From experimental investigation, mechanism to potential application.

Considering the advantages (e.g. agglomeration mitigation) and disadvantages (e.g. inorganic species catalysis removal) of biomass demineralization, it is valuable to investigate its effects on gasification performance, thus assessing its necessity prior to performing gasification. To accomplish this, corn straw (CS) was demineralized to different degrees with H2O and HCl, respectively. H2O and HCl demineralization behaved different abilities to inorganic species removal. Cellulose and hemicelluloses content decreased, while lignin content increased, especially with HCl demineralization. The experiments were investigated by using a bench-scale downdraft fixed-bed gasifier at 600-800 °C and were further analyzed via thermogravimetric coupled with Fourier transform infrared spectrometry. Demineralization demonstrated a positive effect on gasification at lower temperatures (600-700 °C) for a dominant effect of lignin content and an insignificant effect of inorganic species removal. However, the catalysis of inorganic species increased as the temperature increased, resulting in the highest H2 (11.30 vol%) and CO (16.02 vol%) production of raw CS compared to demineralized CS at 800 °C. Inorganic species had a dual positive effect on CO generation, promoting both CO2 and char generation leading to a higher CO yield following Boundouard reaction, and increasing the formation of active intermediates thus producing more CO. These effects enhanced when the gasification temperature increased. Additionally, inorganic species catalyzed the aromatic rings rearrangement to generate more H2O, thus driving the endothermic Primary water-gas to produce H2. This was also positively correlated with gasification temperature. Therefore, raw CS demonstrated higher H2 and CO production than demineralized CS at a higher gasification temperature. Moreover, the promotion effect of inorganic species on thermal devolatilization of methoxyl groups and Methanation reaction led to the higher CH4 production of raw CS. This research clarifies the effects of biomass demineralization on its gasification and suggests the potential application.

Environmental, energy, and economic analysis of integrated treatment of municipal solid waste and sewage sludge: A case study in China.

Incineration is well used to treat municipal solid wastes (MSW) but is difficult to treat sewage sludge (SS) because it requires a large amount of heat to remove high content of moisture in SS. Over 50 billion tons of SS are discharged annually in China, and the need for a better waste treatment strategy is urgent. This paper is to introduce a waste disposal technology referring to the integrated treatment of MSW and SS. Four scenarios were analyzed including Mono-incineration of MSW (Case 1) and SS (Case 2), co-incineration of SS and MSW by traditional (Case 3) and integrated ways (Case 4), in terms of environment, energy and economic impact by means of LCA, CED and TEA method. From the environmental perspective, the top four mid-point categories involving the largest effect on four cases are N-C (non-carcinogens), OLD (Ozone layer depletion), TET (Terrestrial eco-toxicity), and GWP (Global warming potential). Case 4 has the most positive effect on climate change and resources (-1.44 kg CO2 eq and -18 MJ, respectively) according to end-point categories. From the view of energy, Case 4 shows the best performance of energy efficiency, and significantly saves the non-renewable energy (0.21 t coal per ton feedstock compared with Case 3). From the economic part, Case 4 is preferentially potential with the best profit, cutting down 79.08% of cost in coal than that in Case 3. These results provide understandings of developing an effective approach for co-treating MSW and SS in the near future.

Contamination source apportionment and health risk assessment of heavy metals in soil around municipal solid waste incinerator: A case study in North China.

Few studies have comprehensively taken into account the source apportionment and human health risk of soil heavy metals in the vicinity of municipal solid waste incinerator (MSWI) in high population density area. In this study, 8 elements (Cr, Pb, Cu, Ni, Zn, Cd, Hg, and As) in fly ash, soil samples from different functional areas and vegetables collected surrounding the MSWI in North China were determined. The single pollution index, integrated Nemerow pollution index, principal component analysis (PCA), absolute principle component score-multiple linear regression (APCS-MLR) model and dose-response model were used in this study. The results showed that the soils around the MSWI were moderately polluted by Cu, Pb, Zn, and Hg, and heavily polluted by As and Cd. MSWI had a significant influence on the distribution of soil heavy metals in different distances from MSWI. The source apportionment results showed that MSWI, natural source, industrial discharges and coal combustion were the four major potential sources for heavy metals in the soils, with the contributions of 36.08%, 29.57%, 10.07%, and 4.55%, respectively. MSWI had a major impact on Zn, Cu, Pb, Cd, and Hg contamination in soil. The non-carcinogenic risk and carcinogenic risk posed by soil heavy metals surrounding the MSWI were unacceptable. The soil heavy metals concentrations and health risks in different functional areas were distinct. MSWI was the predominate source of non-carcinogenic risk with the average contribution rate of 36.99% and carcinogenic risk to adult male, adult female and children with 4.23×10-4, 4.57×10-4, and 1.41×10-4 respectively, implying that the impact of MSWI on human health was apparent. This study provided a new insight for the source apportionment and health risk assessment of soil heavy metals in the vicinity of MSWI.

Biodiesel production process from microalgae oil by waste heat recovery and process integration.

In this work, the optimization of microalgae oil (MO) based biodiesel production process is carried out by waste heat recovery and process integration. The exergy analysis of each heat exchanger presented an efficient heat coupling between hot and cold streams, thus minimizing the total exergy destruction. Simulation results showed that the unit production cost of optimized process is 0.592$/L biodiesel, and approximately 0.172$/L biodiesel can be avoided by heat integration. Although the capital cost of the optimized biodiesel production process increased 32.5% and 23.5% compared to the reference cases, the operational cost can be reduced by approximately 22.5% and 41.6%.

Factors affecting the performance of a single-chamber microbial fuel cell-type biological oxygen demand sensor.

Microbial fuel cells (MFCs) are devices that exploit microorganisms as biocatalysts to degrade organic matter or sludge present in wastewater (WW), and thereby generate electricity. We developed a simple, low-cost single-chamber microbial fuel cell (SCMFC)-type biochemical oxygen demand (BOD) sensor using carbon felt (anode) and activated sludge, and demonstrated its feasibility in the construction of a real-time BOD measurement system. Further, the effects of anodic pH and organic concentration on SCMFC performance were examined, and the correlation between BOD concentration and its response time was analyzed. Our results demonstrated that the SCMFC exhibited a stable voltage after 132 min following the addition of synthetic WW (BOD concentration: 200 mg/L). Notably, the response signal increased with an increase in BOD concentration (range: 5-200 mg/L) and was found to be directly proportional to the substrate concentration. However, at higher BOD concentrations (>120 mg/L) the response signal remained unaltered. Furthermore, we optimized the SCMFC using synthetic WW, and tested it with real WW. Upon feeding real WW, the BOD values exhibited a standard deviation from 2.08 to 8.3% when compared to the standard BOD5 method, thus demonstrating the practical applicability of the developed system to real treatment effluents.