Ex vivo assessment of bicuspidization repair in treating severe functional tricuspid regurgitation: a stereo-scopic PIV study.

There has been a resurgence of interest in the treatment of severe functional tricuspid regurgitation (FTR) due to the awareness of its poor outcomes and potential percutaneous therapies. Kay bicuspidization has been adapted in percutaneous therapies but its clinical outcome remains uncertain. The present study evaluates the efficacy of Kay repair in a novel ex vivo pulsatile system. Porcine tricuspid valve (TV) (n = 3) was extracted and incorporated into a patient-specific silicon right ventricle (RV) emulating severe FTR, on which Kay repair was subsequently performed. TV area metrics and RV hemodynamic assessment by means of stereo-scopic particle image velocimetry were quantified in both FTR and post-repair conditions. Bicuspidization led to significant increase in cardiac output although the overall increment due to this approach alone was generally small, possibly due to existence of residual TR and the large reduction in TV opening area. Kinetic energy and viscous loss levels were increased post-repair, especially during diastolic filling. Main vortex structures generally maintained post-procedural. However, there was enhanced swirling motion in larger RV domain. Although this might reduce mural-thrombus risk, the relatively more complex vortex phenomenon likely resulted in elevated viscous loss observed and may potentially impact long-term adaptation. The RV hemodynamic alteration after tricuspid repair could be used to predict the success of these future transcatheter solutions.

Hemodynamic assessment of extra-cardiac tricuspid valves using particle image velocimetry.

There has not been much progress in the development of transcatheter tricuspid valves to treat tricuspid regurgitation because of the difficulty in anchoring a stented valve onto the complex tricuspid annulus. Hence, the concept of heterotopic implantation of the transcatheter tricuspid valve onto the cavo-atrial junction was proposed. However, to date there has been no detailed in vitro investigation of the hemodynamic performance of this new device. The study utilises both 2-D and 3-D particle image velocimetry (PIV) to interrogate the flow patterns in the vicinity of the extra-cardiac tricuspid valves in an in vitro physiological flow loop, specifically at four measurement locations in the cavo-atrial anatomy. Comparison of the 2-D and 3-D PIV results revealed that accuracy of 2-D PIV would be acceptable at time point and at measurement locations where the velocity was mostly planar with minimal or low out-of-plane flow such as at the outlet of the superior vena cava valve at the point of valve closure. The results also showed that the RSS in the vicinity of the valves were relatively low (∼150 dynes/cm2) with the exception of that in the leakage jet at the upstream of the valve. The leakage in the leaflets could be a result of the use of aortic valve leaflets which was more suited for the higher pressured environment of the left side of the heart. The stent design could also be customised for implantation in the vena cava. In summary, these issues could be eradicated with improvements to the leaflet and stent design which would enhance the haemodynamics of the post-implantation flow performance.

Numerical Assessment of Novel Helical/Spiral Grafts with Improved Hemodynamics for Distal Graft Anastomoses.

In the present work, numerical simulations were conducted for a typical end-to-side distal graft anastomosis to assess the effects of inducing secondary flow, which is believed to remove unfavourable flow environment. Simulations were carried out for four models, generated based on two main features of 'out-of-plane helicity' and 'spiral ridge' in the grafts as well as their combination. Following a qualitative comparison against in vitro data, various mean flow and hemodynamic parameters were compared and the results showed that helicity is significantly more effective in inducing swirling flow in comparison to a spiral ridge, while their combination could be even more effective. In addition, the induced swirling flow was generally found to be increasing the wall shear stress and reducing the flow stagnation and particle residence time within the anastomotic region and the host artery, which may be beneficial to the graft longevity and patency rates. Finally, a parametric study on the spiral ridge geometrical features was conducted, which showed that the ridge height and the number of spiral ridges have significant effects on inducing swirling flow, and revealed the potential of improving the efficiency of such designs.