Critical review and re-assessment of analyte protectants in gas chromatography.

Despite nearly 80 years of advancements in gas chromatography (GC), indirect chemical matrix effects (MEs), known as the matrix-induced response enhancement effect, still occur to cause a high bias in the GC analysis of susceptible analytes, unless precautions are taken. Matrix-matched calibration is one common option used in GC to compensate for the MEs, but this approach is usually inconvenient, imprecise, and inefficient. Other options, such as the method of standard additions, surface deactivation techniques, chemical derivatizations, priming the GC, and/or use of internal standards, also have flaws in practice. When methods are accommodating, the use of analyte protectants (APs) can provide the best practical solution to not only overcome MEs, but also to maximize analyte signal by increasing chromatographic and detection efficiencies for the analytes. APs address the source of MEs in every injection by filling active sites in the GC inlet, column, and detector, particularly in GC-MS, rather than the analytes that would otherwise undergo degradation, peak tailing, and/or diminished response due to interactions with the active sites. The addition of an adequate amount of APs (e.g. sugar derivatives) to all calibration standards and final extracts alike often leads to lower detection limits, better accuracy, narrower peaks, and greater robustness than the other options to compensate for MEs in GC. This article consists of a critical review of the scientific literature, proposal of mechanisms and theory, and re-evaluation studies involving APs for the first time in GC-orbitrap and GC-MS/MS with a high-efficiency ion source design. The findings showed that 1 µg each of co-injected shikimic acid and sorbitol in the former case, and 1 µg shikimic acid alone in the latter case, led to high quality results in multi-residue analysis of pesticides and environmental contaminants.

Assessment of Test Portion Sizes after Sample Comminution with Liquid Nitrogen in an Improved High-Throughput Method for Analysis of Pesticide Residues in Fruits and Vegetables.

In this study, sample processing of bulk commodities using an efficient one-step comminution procedure with liquid nitrogen (LN2) was devised and assessed in the analysis of pesticide residues in fruits and vegetables. LN2 was added to the fresh samples from a tank by opening a valve, and the standard food chopper was kept in a laboratory hood to reduce safety risks. Test portions of four replicates each of 0.25, 0.5, 1, 2, 5, 10, and 15 g were taken from eight fruits and vegetables (tomato, squash, broccoli, apple, grape, peach, green bean, and cucumber) individually comminuted with LN2. For comparison without comminution, similar test portions of a reconstituted freeze-dried certified reference material of pesticides in cucumber were also analyzed by the same method. More than 100 pesticides were monitored by both ultra-high-performance liquid chromatography-tandem mass spectrometry (UHPLC-MS/MS) and instrument top sample preparation (ITSP) + fast low-pressure gas chromatography-tandem mass spectrometry (LPGC-MS/MS). A new version of QuEChERS-based sample preparation was followed, in which 5 mL of 4:1 (v/v) acetonitrile/water per gram of sample is used for extraction and 200 µL of initial extract is quickly evaporated, reconstituted in water, and ultracentrifuged for UHPLC-MS/MS analysis. For ITSP+LPGC-MS/MS, another portion of the initial extract undergoes salt-out partitioning with 4:1 (w/w) anhydrous MgSO4/NaCl and the upper layer extract is transferred to an autosampler vial for automated cleanup and analysis in parallel. Quality control spikes were made during the comminution, extraction, cleanup, and analysis steps to isolate and estimate the individual and overall measurement uncertainties of the approach. The recommended test portion size is 2 g for routine monitoring by this approach, but results demonstrated that subsamples as low as 0.5 g typically gave overall biases and relative standard deviations of <10% for nearly all pesticides, commodities, and methods, which is 3-5% lower than previously evaluated sample processing and analytical methods. This approach can be used to improve data quality, laboratory efficiency, and sample throughput in routine monitoring programs for regulatory, risk assessment, and other purposes.

A dual validation approach to detect anthelmintic residues in bovine liver over an extended concentration range.

This paper describes a method for the detection and quantification of 38 residues of the most widely used anthelmintics (including 26 veterinary drugs belonging to the benzimidazole, macrocyclic lactone and flukicide classes) in bovine liver using two different protocols for MRL and non-MRL levels. A dual validation approach was adopted to reliably quantify anthelmintic residues over an extended concentration range (1-3000 µg kg(-1)). Sample extraction and purification was carried out using a modified QuEChERS method. A concentration step was included when analysing in the low µg kg(-1) range. Rapid analysis was carried out by ultra-high performance liquid chromatography-tandem mass spectrometry (UHPLC-MS/MS), which was capable of detecting residues to <2 µg kg(-1). The method has been single-laboratory validated according to the 2002/657/EC guidelines and met acceptability criteria in all but a few cases. The inclusion of 19 internal standards, including 14 isotopically labelled internal standards, improved accuracy, precision, decision limit (CCα) and detection capability (CCß).

Evaluation of automated direct sample introduction with comprehensive two-dimensional gas chromatography/time-of-flight mass spectrometry for the screening analysis of dioxins in fish oil.

An automated direct sample introduction technique coupled to comprehensive two-dimensional gas chromatography-time of flight mass spectrometry (DSI-GC x GC/TOF-MS) was applied for the development of a relatively fast and easy analytical screening method for 17 polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDD/Fs) and 4 non-ortho polychlorinated biphenyls (PCBs) in fish oil. Comparison of instrumental performance between DSI-GC x GC/TOF-MS and the traditional gas chromatographic high resolution mass spectrometric (GC-HRMS) method showed good agreement of results for standard solutions analyzed in blind fashion. Relatively high tolerance of the DSI technique for lipids in the final extracts enabled a streamlined sample preparation procedure that only required gel permeation chromatography (GPC) and solid-phase extraction (SPE) cleanup with graphitized carbon black. The sample size for the method was 2g of cod liver oil, which achieved limits of quantitation (LOQs) of 0.019-7.8 pg/g toxic equivalent quotients for the individual PCDD/Fs. Lower detection limits can be achieved by using larger sample size and scaling up the sample preparation procedure, but this adds to the labor, time, solvent consumption, and expense of the approach. However, the streamlined method yielded 0.94 pg/g and 2.3 pg/g LOQs for 2,3,7,8-tetrachloro dibenzofuran (TCDF) and 3,3',4,4',5-pentachloro biphenyl (CB126), which were sufficiently low for regulatory monitoring of 2g samples. Therefore, instead of congener specific analysis, this streamlined analytical screening method for TCDF and CB126 has the potential to monitor fish oil contaminated with dioxin and dioxin-like PCBs at or above current food safety limits. Acceptable recoveries for nearly all analytes at three different spiking levels in fish oil samples were achieved with good repeatability.

Determination of pesticide residues in foods by acetonitrile extraction and partitioning with magnesium sulfate: collaborative study.

A collaborative study was conducted to determine multiple pesticide residues in fruits and vegetables using a quick, simple, inexpensive, and effective sample preparation method followed by concurrent analysis with gas chromatography/mass spectrometry (GC/MS) and liquid chromatography/ tandem mass spectrometry (LC/MS/MS). For short, the method is known as QuEChERS, which stands for quick, easy, cheap, effective, rugged, and safe. Twenty representative pesticides were fortified in 3 matrixes (grapes, lettuces, and oranges) at 3 duplicate levels unknown to the collaborators ranging from 10 to 1000 ng/g. Additionally, 8 incurred pesticide residues were determined. Thirteen laboratories from 7 countries provided results in the study, and a variety of different instruments were used by collaborators. The QuEChERS procedure simply entails 3 main steps: (1) a 15 g homogenized sample is weighed into a 50 mL centrifuge tube to which 15 mL acetonitrile containing 1% HOAc is added along with 6 g MgSO4 and 1.5 g NaOAc, and the tube is shaken and centrifuged; (2) a portion of the extract is mixed with 3 + 1 (w/w) MgSO4-primary secondary amine sorbent (200 mg/mL extract) and centrifuged; and (3) the final extract is analyzed by GC/MS and LC/MS/MS. To detect residues <10 ng/g in GC/MS, large-volume injection of 8 microL is typically needed, or the extract can be concentrated to 4 g/mL in toluene, in which case 2 microL splitless injection is used. In the study, the averaged results for data from 7-13 laboratories (not using internal standardization) for the 18 blind duplicates at the 9 spiking levels in the 3 matrixes are as follows [%recovery and reproducibility relative standard deviation (RSD(R), %)]: atrazine, 92 (18); azoxystrobin, 93 (15); bifenthrin, 90 (16); carbaryl, 96 (20); chlorothalonil, 70 (34); chlorpyrifos, 89 (25); cyprodinil, 89 (19); o,p'-DDD, 89 (18); dichlorvos, 82 (21); endosulfan sulfate, 80 (27); imazalil, 77 (33); imidacloprid, 96 (16); linuron, 89 (19); methamidophos, 87 (17); methomyl, 96 (17); procymidone, 91 (20); pymetrozine, 69 (19); tebuconazole, 89 (15); tolylfluanid (in grapes and oranges), 68 (33); and trifluralin, 85 (20). For incurred pesticides, kresoxim-methyl (9.2 +/- 3.2 ng/g) and cyprodinil (112 +/- 18) were found in the grapes; permethrins (112 +/- 41), lamda-cyhalothrin (58 +/- 11), and imidacloprid (12 +/- 2) were determined in the lettuces; and ethion (198 +/- 36), thiabendazole (53 +/- 8), and imazalil (13 +/- 4) were determined in the oranges. Chlorpyrifosmethyl (200 ng/g) was used as a quality control standard added during sample homogenization and yielded 86% recovery and 19% RSD(R). Intralaboratory repeatabilities for the method averaged 9.8% RSD for all analytes. The results demonstrate that the method is fit-for-purpose to monitor many pesticide residues in fruits and vegetables, and the Study Director recommends that it be adopted Official First Action.

Evaluation of the QuEChERS sample preparation approach for the analysis of pesticide residues in olives.

This paper describes the use of a quick, easy, cheap, effective, rugged, and safe (QuEChERS) method for extraction and cleanup of 16 pesticide residues of interest in olives and olive oil. These products contain a high lipid content, which can adversely affect pesticide recoveries and harm traditional chromatographic systems. For extraction, the main factors (oil and water content) were studied and optimized in experiments to maximize pesticide recoveries. Dispersive SPE with different sorbents was also investigated to minimize matrix coextractives and interferences. For analysis, a new automated DSI device was tested in GC-MS to avoid nonvolatile coextractives from contaminating the instrument. LC-MS/MS with positive ESI was used for those pesticides that were difficult to detect by GC-MS. The final method was validated for olives in terms of recoveries, repeatabilities, and reproducibilities using both detection techniques. The results demonstrated that the method achieved acceptable quantitative recoveries of 70-109% with RSDs < 20% for DSI-GC-MS and 88-130% with RSDs < 10% for LC-MS/MS, and LOQ at or below the regulatory maximum residue limits for the pesticides were achieved.