RESUMO
There is growing awareness that nature-based solutions (NBS) prevent negative effects and secure ecosystem services. However, the potential of NBS to provide intended benefits has not been rigorously assessed. Water, food, and energy (WFE) are essential for human well-being. This study highlights the importance of NBS in terms of water, food, and energy. A set of on-site NBS that includes permeable pavements, plant microbial fuel cells, bio-filtration basins, and rain gardens is used to determine the contribution of NBS to the environmental and economic development of urban environments. The results of this study show that NBSs benefit an urban environment in terms of water treatment, stormwater retention, food production and energy generation, carbon sequestration, pollination, sedimentation retention, and cultural services dimension. This research highlights an urgent need for the integration of water, food, and energy plans to ensure that NBSs contribute to the environment and for the conservation of ecosystem services.
Assuntos
Ecossistema , Purificação da Água , Desenvolvimento Econômico , Filtração , Humanos , ChuvaRESUMO
Heterogeneous Fenton oxidation of trichloroethylene (TCE) catalyzed by sewage sludge biochar was studied. The highest TCE removal efficiency was 83% at pH 3.1, catalyzed by 300 W biochar. The biochars produced at higher microwave power levels provided better catalytic effect, due to higher iron contents and specific surface areas. Reactivity of sewage sludge biochar maintained after several uses, which provides an advantage for using as a permeable reactive barrier to remediate groundwater pollution. Chromium, copper, nickel, lead, and zinc were found in the leachate generated from sewage sludge biochar, and most of the concentrations were lower than the standards for non-drinking water use. Besides, copper, zinc, and iron were found in the reaction solutions of Fenton oxidation. Because of the highest dosage required for Fenton oxidation, the environmental impact caused by 200 W biochar is highest. The environmental impact caused by 300 W biochar is lowest. Among the four endpoint impact categories in the life cycle assessment (LCA), human health is the highest concern, whereas ecosystem quality is the least. According to experimental and LCA results, the optimum microwave power level would be 300 W. The primary impact source is microwave pyrolysis because of high energy usage.
Assuntos
Carvão Vegetal/química , Tricloroetileno/química , Catálise , Ecossistema , Poluição Ambiental , Ferro/química , Oxirredução , Esgotos/químicaRESUMO
Contaminated sediment may pose a serious threat to human health and ecosystems. However, sediment remediation is typically an expensive and time-consuming process. Therefore, an effective decision-making process for the remediation of contaminated sediment is essential for identifying the optimal approach. Since a single assessment for sediment remediation may be insufficient, combining different analytical approaches is highly recommended. The objective of this study was to develop a comprehensive assessment framework based on the concept of green and sustainable remediation that considers various environmental, economic, and social aspects for the management of contaminated sediment. We propose a framework based on human health risk assessment (HHRA) and cost-benefit analysis (CBA) and apply the multicriteria decision analysis (MCDA) technique to implement integrated and sustainable strategies for sediment management. We used the framework to determine the best alternative for managing heavy-metal-contaminated sediment in a river in Northern Taiwan. The results of the pre-remediation HHRA indicated an unacceptably high cancer risk to children, while the CBA revealed that a remediation project was economically feasible. Moreover, the results of the MCDA revealed that a strategy involving in-situ capping with anthracite-based activated carbon would be relatively inexpensive and result in low risk to human health. In addition, this strategy would have a higher environmental impact and greater public acceptance as compared to a method involving the dredging and washing of soil. Thus, in this case study, in-situ capping using anthracite-based activated carbon was identified as the preferable remediation alternative from multiple perspectives. The proposed framework should allow decision-makers to choose the optimal integrated management strategy for similar river sites with contaminated sediment.
RESUMO
Trihalomethanes (THMs) are suspected carcinogens and reproductive toxicants commonly found in chlorinated drinking water. This study investigates the formation of THMs and their associated risks during different tea brewing habits. Three main categories of tea (black, oolong, and green) under various brewing conditions and drinking water sources were tested. Tea samples prepared in ordinary thermos flask formed significant levels of total THM (TTHM). The highest TTHM formation came from black tea made with tap water, plausibly due to higher concentrations of reactive THM precursors. Compared with tap water, when the background solution is bottled water or distilled water, less TTHM was observed in prepared tea infusions. The results also revealed that unlike the traditional teapot-based tea serving habit, the removal of THMs is significantly reduced when tea infusion is stored in enclosed containers. Risk assessment analysis based on the survey among tea shop costumers also revealed that cancer risks induced by ingestion of THMs through drinking tea infusions prepared in thermos flask exceeded the tolerable level. Data obtained in this research demonstrated that drinking tea infusions directly from enclosed containers can be a significant source of exposure to THMs.
Assuntos
Exposição Dietética/análise , Chá , Trialometanos/análise , Adolescente , Adulto , Feminino , Humanos , Masculino , Medição de Risco , Água/química , Adulto JovemRESUMO
This study used life cycle assessment software SimaPro 7.2 and impact assessment model IMPACT 2002+ to evaluate the environmental impact and benefits of a biochar cofiring supply chain used for electricity generation. The biochar was assumed to be produced by rice straw torrefaction and the case study was located in Taoyuan County, Taiwan. This supply chain may provide impact reduction benefits in five categories (aquatic ecotoxicity, terrestrial ecotoxicity, land occupation, global warming, and non-renewable energy) but cause higher impacts than coal firing systems in other categories. Damage assessment of cofiring systems indicated that damage to human health was higher while the damage categories of ecosystem quality, climate change, and resources were lower. Carbon reduction could be 4.32 and 4.68metric tons CO2eq/ha/yr at 10% and 20% cofiring ratios, respectively. The improvement of electricity generation efficiency of cofiring systems may be the most important factor for reducing its environmental impact.
Assuntos
Carvão Vegetal/química , Carvão Mineral/análise , Conservação de Recursos Energéticos/métodos , Meio Ambiente , Incineração/métodos , Modelos Químicos , Software , Simulação por ComputadorRESUMO
The purpose of this study was to explore the impact of feedstock collection and torrefaction pretreatment on the efficiency of a biomass co-firing system. Considering the transformation of existing municipal solid waste incinerators, several scenarios in which biomass supply chains depend on centralised pretreatment and transportation alternatives are presented. The cost, net energy output, and greenhouse gas effects of these scenarios were analysed using a spreadsheet model. Based on the Taoyuan County case in Taiwan, the mitigation costs of carbon emissions for rice straw and Pennisetum are 77.0 $/Mg CO(2) and 63.8 $/Mg CO(2), respectively. Results indicate that transporting feedstock from its source to the pretreatment and co-firing stations contributes the most to logistical costs for both straw and Pennisetum, regardless of whether torrefaction was adopted. Nonetheless, torrefaction requires more demonstrated cases at various scales to obtain the technical and economic data required for further analysis.
Assuntos
Poluição do Ar/prevenção & controle , Incineração/métodos , Modelos Químicos , Oryza/química , Pennisetum/química , Componentes Aéreos da Planta/química , Eliminação de Resíduos/métodos , Biomassa , Dióxido de Carbono/metabolismo , Sistemas de Informação Geográfica , Eliminação de Resíduos/economia , TaiwanRESUMO
Metropolitan Taipei located in north Taiwan uses a hybrid sewer system consisting of mostly separate sewer for the populated regions, and partly combined sewer for less populated regions. This study used the concept that Marginal Cost of Control (MCC) equals to Marginal Benefits of Control (MBC) to establish the method for studying the optimal household connection percentage, and the most cost-effective construction of the separate sewer in the hybrid sewer system. Results indicate the improvement of the receiving water quality in a cost-effective analysis manner. The most cost-effective sanitary sewer construction can be reached when the stream Biochemical Oxygen Demand (BOD5) meets the river quality standard, which can be applied in other cities and existing systems.
Assuntos
Esgotos/química , Eliminação de Resíduos Líquidos/economia , Reprodutibilidade dos Testes , Taiwan , Fatores de Tempo , Eliminação de Resíduos Líquidos/métodos , Poluentes Químicos da ÁguaRESUMO
To ease the NIMBY (not in my back yard) syndrome of constructing municipal solid waste (MSW) incinerators in Taiwan, compensatory funding is widely allocated to the impacted communities to gain the acceptance and support of residents living the impacted areas. This paper presents a spatial methodology for distributing a compensatory fund more logically based on the environmental impact on each neighborhood in Taipei City. This method integrates ten impact factors, which have been proposed by a local committee, to evaluate all neighborhoods using mathematical models combined with spatial analyses in an analytic hierarchy process. The compensatory fund is distributed according to the resulting final scores. A GIS (geographic information systems)-based system has been developed to assist in assigning the final scores to the neighborhoods impacted. Results on impact factors and fund distributions are combined; they are included in an information system and displayed in spatial scales. For Taipei City, the impact of air quality during the incinerator operating period is the item of greatest concern to the surrounding residents and thus, it receives a relatively higher weight of 0.2894. As a result, high impact scores were assigned to not only those neighborhoods hosting the incinerators, but also the neighborhoods where the maximum particulate air pollutants occurred. This approach could be applicable to other MSW incinerators with similar environmental impact problems and interest in compensation schemes.
Assuntos
Sistemas de Informação Geográfica , Incineração/economia , Incineração/métodos , Cidades , Meio Ambiente , Poluentes Ambientais , Financiamento Governamental , TaiwanRESUMO
The traditional life cycle assessment (LCA) does not perform quantitative uncertainty analysis. However, without characterizing the associated uncertainty, the reliability of assessment results cannot be understood or ascertained. In this study, the Bayesian method, in combination with the Monte Carlo technique, is used to quantify and update the uncertainty in LCA results. A case study of applying the method to comparison of alternative waste treatment options in terms of global warming potential due to greenhouse gas emissions is presented. In the case study, the prior distributions of the parameters used for estimating emission inventory and environmental impact in LCA were based on the expert judgment from the intergovernmental panel on climate change (IPCC) guideline and were subsequently updated using the likelihood distributions resulting from both national statistic and site-specific data. The posterior uncertainty distribution of the LCA results was generated using Monte Carlo simulations with posterior parameter probability distributions. The results indicated that the incorporation of quantitative uncertainty analysis into LCA revealed more information than the deterministic LCA method, and the resulting decision may thus be different. In addition, in combination with the Monte Carlo simulation, calculations of correlation coefficients facilitated the identification of important parameters that had major influence to LCA results. Finally, by using national statistic data and site-specific information to update the prior uncertainty distribution, the resultant uncertainty associated with the LCA results could be reduced. A better informed decision can therefore be made based on the clearer and more complete comparison of options.