The utility of air on computed tomography scans in the assessment of type 1 open fractures.

PURPOSE: The presence of air on computed tomography (CT) scans has been demonstrated to accurately diagnose occult traumatic arthrotomies. The purpose of this study was to determine if the presence of air on CT scans also has diagnostic utility for type 1 open fractures. METHODS: A retrospective review at a level 1 trauma center identified twenty-eight patients with Gustilo-Anderson Type 1 open fractures and preoperative CT scans. These patients were matched 2:1 with 56 closed fractures who also had CT scans. CT scans were reviewed to determine the presence of suprafascial and subfascial air. RESULTS: Air near the fracture site on CT scan was more common in open fractures then closed fractures (21 (75%) vs. 9 (16%) patients, proportional difference: 59% (37-75%), p < 0.0001). In the open fracture group, 18 (64.2%) patients had both supra- and subfascial air, 2 (7.1%) patients had isolated subfascial air, and 1 (3.5%) patient had isolated suprafascial air. In the closed fracture group, 3 (5.3%) patients had supra- and subfascial air, 4 (7.1%) had isolated subfascial air, and 2 (3.5%) had isolated suprafascial air. The sensitivity and specificity of air on CT for identifying a type 1 open fracture was 75 and 84%, respectively. CONCLUSIONS: This study found that the presence of air on CT scan was more likely in type 1 open versus closed fractures; however, the sensitivity or specificity was too low to be used reliably to identify occult open fractures in isolation. LEVEL OF EVIDENCE: Diagnostic Level III.

The effect of pelvic ring rotation and tilt on the radiographic teardrop distance: an important consideration in the assessment of dynamic displacement on stress radiographs.

PURPOSE: The purpose of this study was to determine the effect of rotation and tilt on the radiographic teardrop distance (TD) on anteroposterior (AP) pelvis radiographs. METHODS: Radiographic examination of a pelvis models was conducted utilizing increasing degrees of beam rotation and tilt on portable C-arm fluoroscopy. The TD, x-plane rotation (symphyseal-mid-sacrum distance (SMS)), and y-plane tilt (sacroiliac joint-symphysis distance (SIS)) were measured by four independent observers. Interobserver reliability was assessed using intraclass correlations. RESULTS: TD was altered by less than 2 mm with up to 7.5° fluoroscopic rotation (SMS: 3 cm) and up to 30° of inlet and 15° of outlet (SIS: ± 3.3 cm). SMS distance effectively corresponded to the degree of rotation present (r = 1.00, CI: 0.97 to 1.00, p < 0.0001) and was strongly correlated to TD (r = -0.95, CI: -0.99 to -0.67, p = 0.001). SIS distance effectively corresponded to the degree of tilt present (r = -0.97, CI: -0.99 to -0.88, p < 0.0001) and was correlated to TD (r = 0.94, CI: 0.75 to 0.99, p = 0.0001). Linear regression models determined that, with every degree of rotation and tilt, TD was altered by 0.4 mm and 0.09 mm, respectively (p = 0.0004, r2 = 0.93 and p < 0.0001, r2 = 0.94, respectively). Interobserver reliability among observers was excellent (0.92). CONCLUSION: The TD has excellent interobserver reliability and is minimally impacted by up to 7.5° of rotation, 30° inlet tilt, and 15° of outlet tilt. Utilization of these thresholds may ensure reliability of TD measurements when assessing pelvis stress radiographs.

Need for syndesmotic fixation and assessment of reduction during ankle fracture fixation, with and without contralateral fluoroscopic images, has poor interobserver reliability.

PURPOSE: To determine the interobserver reliability of syndesmosis assessment using intraoperative ankle mortise fluoroscopic images, with and without contralateral images. METHODS: A survey of 19 operative ankle fracture cases was administered to 17 orthopedic surgeons. Respondents were presented with fluoroscopic mortise and stress images of the ankle after fracture fixation and asked if they would fix the syndesmosis. Final fluoroscopic mortise images were then shown, and respondents were asked to assess the reduction of the syndesmosis. Six weeks later, the survey was administered again with the addition of contralateral fluoroscopic ankle mortise images. Responses were compared to a standard response agreed upon by fellowship-trained orthopedic trauma surgeons. RESULTS: Interobserver reliability for syndesmosis fixation and reduction, with and without contralateral images, was considered weak (kappa 0.48 and 0.43; mean difference 0.05, 95% confidence interval (CI) 0.01 to 0.1) and minimal (kappa 0.25 and 0.22; mean difference 0.02, CI - 0.02 to 0.08). With the addition of contralateral mortise images, the number of surgeons who changed their response for syndesmosis fixation and reduction quality ranged from 0% to 41% and 0% to 88%; with the number of responses matching the standard increasing for both fixation (proportional difference (PD) 7%, CI 1% to 14%) and reduction (PD 14%, CI 7% to 21%); CONCLUSIONS: Interobserver reliability of syndesmosis fixation and reduction remained weak to minimal between surgeons, with and without contralateral images. Future studies are necessary to understand the variability in surgeon responses in order to improve the intraoperative assessment and fixation of syndesmotic injuries.

Spinopelvic Dissociation: Assessment, Reduction Strategies, and Fixation Techniques.

Spinopelvic dissociation is a rare injury associated with 2% to 3% of transverse sacral fractures and 3% of sacral fractures associated with pelvic ring injuries. When spinopelvic dissociation is expediently identified and treated appropriately, patient outcomes can be maximized, highlighting the importance of early diagnosis and treatment. Because of its rarity and complexity, there remains a paucity of high-level evidence-based guidance on treating this complex issue. No consensus exists on fixation techniques or reduction maneuvers to achieve stability, allowing for early functional rehabilitation. The purpose of this article is to review the current body of literature to better understand this injury pattern to help establish a treatment algorithm that appropriately guides the treating surgeons in the surgical planning and perioperative care of these patients.

Fixation of Transverse Acetabular Fractures With Precontoured Plates Alone Causes Fracture Malreduction: A Biomechanical Assessment.

BACKGROUND: Precontoured quadrilateral surface buttress (PQSB) plates have grown in popularity for acetabular fracture fixation. However, our experience has pushed us to hypothesize that their use as sole means of fixation may cause fracture malreduction. A biomechanical model was created to investigate this theory. METHODS: A transverse acetabular fracture was created and reduced anatomically in 18 synthetic hemipelvises. The reduced hemipelvises were fixated using 3 different techniques. Group A fixation included anterior and posterior column screws plus a suprapectineal pelvic reconstruction plate; group B models were fixed using a PQSB plate only; and group C models were fixed with an anterior column screw and a PQSB plate. Acetabular tracking points were placed before final fixation and used to quantify any postfixation displacement. One-way analysis of variance and Tukey HSD testing were used to determine the significant difference (P < 0.05). RESULTS: Models in group B had significant fracture displacement after final fixation when compared with group A and group C models. The average amount of displacement at the anterior column and within the acetabulum was 1.37 mm (95% CI, 1.08-1.65) in group B constructs compared with 0.32 mm (95% CI, 0.22-0.42) and 0.26 mm (95% CI, 0.15-0.38) in groups A and C constructs, respectively. There were no significant differences in displacement after final fixation between group A and group C models. CONCLUSIONS: PQSB plates for acetabular fractures cause malreduction when applied in isolation in this biomechanical model. If a PQSB plate is chosen for fixation, we suggest the use of a columnar lag screw at minimum to hold reduction before plate application.

Orthopaedic trauma surgeons and direct anterior total hip arthroplasty: evaluation of learning curve at a level I academic institution.

BACKGROUND: Interest in the direct anterior approach for total hip arthroplasty has increased over recent years; however, the potential for substantial complications exists, especially during the surgeon's learning curve. We evaluated the change in various metrics to help identify a single surgeon's learning curve. Additionally, we examined whether the learning curve was different for primarily arthroplasty versus trauma-trained surgeons. METHODS: We reported outcomes from the first 50 total hip arthroplasties performed through a direct anterior approach by a trauma fellowship-trained orthopaedic surgeon. Intraoperative and post-operative clinical outcomes were evaluated, including length of procedure, estimated blood loss, length of hospitalization, disposition to home versus care facility, need for blood transfusion, and complications. Previous reported learning curve outcomes were analysed with a comparison between those who are primarily arthroplasty specialists versus those who include hip arthroplasty as only a portion of their practice. RESULTS: A significant difference in surgical time from 135 to 113 min was observed between the first 25 cases and the last 25. Estimated blood loss (EBL) and lateral femoral cutaneous nerve injury rates decreased but not to a significant degree. Among reported learning curves, surgical time was significantly lower among fellowship-trained arthroplasty specialists when compared with other surgeons. CONCLUSION: Our data support that surgeons who perform primarily joint arthroplasty will likely have a decreased surgical time, but similar EBL compared to those who include arthroplasty as only a portion of their practice, however, a number of confounding variables do exist, and additional investigation is warranted.

Short-term results of percutaneous treatment of acetabular fractures: functional outcomes, radiographic assessment and complications.

PURPOSE: Our purpose was to assess functional outcomes, radiographic characteristics and complications in patients who underwent fixation of acetabular fracture using percutaneous means only. METHODS: This was a retrospective cohort study of adult patients with an acetabular fracture admitted to a level 1 trauma centre and treated with closed reduction and percutaneous fixation. Nineteen patients were identified, and mechanism of injury, radiologic classification of fracture, complications and functional outcomes were analysed. Outcome measurements included Patient Reported Outcomes Measurement Information System (PROMIS) and Western Ontario and McMaster Universities Osteoarthritis Index (WOMAC) scores, which are validated patient questionnaires assessing functional outcome. They are scored as a point range on a per-question basis, with a combined range possibility of 0-96 for WOMAC and 5-75 for PROMIS. RESULTS: Nineteen patients over a two year period were reviewed. Fracture displacement improved following surgery from a mean 7.3 mm (range 0-33 mm) to 2.6 mm (range 0-12 mm). Complications included one post-operative death from non-ST-segment elevation myocardial infarction, sciatic nerve injury, malpositioned screw and deep infection. There were no vascular injuries, pulmonary emboli or deep venous thromboses. Of the 19 patients eligible for the study, seven completed both PROMIS mobility and WOMAC osteoarthritis questionnaires at a mean follow-up of 572 days (1.57 years), with a range of 435-862 days. The average WOMAC score was 7.4 (range 0-30) and mean PROMIS score 66.4 (range 50-75). CONCLUSIONS: Functional outcomes in this study are comparable with other published studies and support percutaneous management of acetabular fractures as an effective alternative to open reduction and internal fixation.

Analysis of usage and associated cost of external fixators at an urban level 1 trauma centre.

OBJECTIVE: To determine the usage, indication, duration, and cost associated with external fixation usage. Additionally, to show the significant cost associated with external fixator use and reinvigorate discussions on external fixator reuse. DESIGN, SETTING, AND PATIENTS: A retrospective review of a prospectively gathered trauma database was undertaken to identify all patients treated with external fixation frames for pelvic and lower extremity injuries between September 2007 and July 2010. MAIN OUTCOME AND MEASURES: We noted the indications for frame use, and we determined the average duration of external fixation for each indication. The cost of each frame was calculated from implant records. RESULTS: 341 lower extremity and pelvic fractures were treated with external fixation frames during the study period. Of these, 92% were used as temporary external fixation. The average duration of temporary external fixation was 10.5 days. The cost of external fixation frame components was $670,805 per year. The average cost per external fixation frame was $5900. CONCLUSIONS: The majority of external fixators are intended as temporary frames, in place for a limited period of time prior to definitive fixation of skeletal injuries. As such, most frames are not intended to withstand physiologic loads, nor are they expected provide a precise maintenance of reduction. Given the considerable expense associated with external fixation frame components, the practice of purchasing external fixation frame components as disposable "single-use" items appears to be somewhat wasteful. LEVEL OF EVIDENCE: Level II.