Thermally tuned VCSEL at 850†nm as a low-cost alternative source for full-eye SS-OCT.

Swept-source optical coherence tomography (SS-OCT) demonstrates superior performance in comparison to spectral domain OCT with regard to depth ranging. The main driver of cost for SS-OCT systems is, however, the price of the source. Here we show a low-cost alternative swept source that uses a thermally tuned vertical-cavity surface-emitting laser (VCSEL) at 850 nm. Its center wavelength can be tuned by adjusting the operating temperature through modulation of the injection current. At 2 kHz sweep rate, the depth range of the system was 5 cm, with a sensitivity roll-off of under -3 dB across this range. The system achieved a sensitivity of 97 dB with a sample beam power of 0.3 mW and an axial resolution of 50 µm in air. To demonstrate the system performance in vivo, an eye of a healthy volunteer was measured, and full-eye scans were acquired at 25 and 50 kHz from the cornea to the retina. Based on our results, we believe that this technology can be used as a cost-effective alternative OCT for point-of-care diagnostics.

Assessment of Detailed Photoreceptor Structure and Retinal Sensitivity in Diabetic Macular Ischemia Using Adaptive Optics-OCT and Microperimetry.

Purpose: The purpose of this study was to assess density and morphology of cone photoreceptors (PRs) and corresponding retinal sensitivity in ischemic compared to nonischemic retinal capillary areas of diabetic eyes using adaptive optics optical coherence tomography (AO-OCT) and microperimetry (MP). Methods: In this cross-sectional, observational study five eyes of four patients (2 eyes with proliferative diabetic retinopathy (DR) and 3 eyes moderate nonproliferative DR) were included. PR morphology and density was manually assessed in AO-OCT en face images both at the axial position of the inner-segment outer segment (IS/OS) and cone outer segment tips (COSTs). Retinal sensitivity was determined by fundus-controlled microperimetry in corresponding areas (MP-3, Nidek). Results: In AO-OCT, areas affected by capillary nonperfusion showed severe alterations of cone PR morphology at IS/OS and COST compared to areas with intact capillary perfusion (84% and 87% vs. 9% and 8% of area affected for IS/OS and COST, respectively). Mean reduction of PR signal density in affected areas compared to those with intact superficial capillary plexus (SCP) and deep capillary plexus (DCP) perfusion of similar eccentricity was -38% at the level of IS/OS (P = 0.01) and -39% at the level of COST (P = 0.01). Mean retinal sensitivity was 10.8 ± 5.4 in areas affected by DCP nonperfusion and 28.2 ± 1.5 outside these areas (P < 0.001). Conclusions: Cone PR morphology and signal density are severely altered in areas of capillary nonperfusion. These structural changes are accompanied by a severe reduction of retinal sensitivity, indicating the importance of preventing impaired capillary circulation in patients with DR.

Three-dimensional assessment of para- and perifoveal photoreceptor densities and the impact of meridians and age in healthy eyes with adaptive-optics optical coherence tomography (AO-OCT).

An adaptive optics optical coherence tomography (AO-OCT) system is used to assess sixty healthy eyes of thirty subjects (age 22 to 75) to evaluate how the outer retinal layers, foveal eccentricity and age effect the mean cone density. The cone mosaics of different retinal planes (the cone inner segment outer segment junction (IS/OS), the cone outer segment combined with the IS/OS (ISOS+), the cone outer segment tips (COST), and the full en-face plane (FEF)) at four main meridians (superior, nasal, inferior, temporal) and para- and perifoveal eccentricities (ecc 2.5° and 6.5°) were analyzed quantitatively. The mean overall cone density was 19,892/mm2 at ecc 2.5° and 13,323/mm2 at ecc 6.5°. A significant impact on cone density was found for eccentricity (up to 6,700/mm2 between ecc 2.5° and 6.5°), meridian (up to 3,700/mm2 between nasal and superior meridian) and layer (up to 1,400/mm2 between FEF and IS/OS). Age showed only a weak negative effect. These factors as well as inter-individual variability have to be taken into account when comparing cone density measurements between healthy and pathologically changed eyes, as their combined effect on density can easily exceed several thousand cones per mm2 even in parafoveal regions.

Morphologic and Functional Assessment of Photoreceptors After Macula-Off Retinal Detachment With Adaptive-Optics OCT and Microperimetry.

PURPOSE: Limited information is available on morphologic and functional regeneration of photoreceptors after retinal detachment (RD) surgery. This observational clinical study compared morphologic and functional changes of cones after vitrectomy for macula-off retinal detachment. DESIGN: Prospective, fellow-eye comparative case series. METHODS: StudyPopulation: Five eyes after vitrectomy with gas for macula-off retinal detachment (retinal detachment eyes, RDE) and 5 healthy fellow eyes (HFE) of 5 patients (mean age 59.8 years, macula-off duration 0.5 days to 5.5 days). ObservationProcedures: Eyes were examined with adaptive-optics optical coherence tomography (AO-OCT), spectral-domain OCT (SDOCT), and microperimetry (MP) at 6 (baseline, BL) and 56 weeks (follow-up, FUP) after 23 gauge pars plana vitrectomy and SF6 gas tamponade. Eight corresponding regions at foveal eccentricities of 2.5° (ecc 2.5°) and 6.5° (ecc 6.5°) were analyzed in every eye. AO-OCT en face images and SD-OCT B-scans were graded regarding irregularity and loss of photoreceptor signals ranging from none to severe changes. The number of detectable cones at height of the inner-outer segment junction (IS/OS) and cone outer segment tips (COST) was counted manually in AO-OCT images. MP with a custom grid was used to assess retinal sensitivity at these locations. MainOutcomeMeasures: Cone density, cone pattern regularity and signal attenuation, retinal sensitivity. RESULTS: In comparison to HFE, RDE showed highly irregular cone patterns in AO-OCT and irregular outer retinal bands in SDOCT. Despite significant improvement of cone pattern regularity compared to BL (P < .001), 63% of AO images showed remaining cone pattern irregularity and 45.5% of SDOCT B-scans showed severe signal reduction at FUP. In HFE, mean cone density retrieved from IS/OS and COST remained around 20,000/mm2 (ecc 2.5°) and 16,000/mm2 (ecc 6.5°) at BL and FUP. Cone density of RDE was significantly reduced and ranged between 200/mm2 and 15,600/mm2 (P < .001) at BL. Despite improvement at FUP (P < .001), mean cone density at IS/OS and COST was still lower compared to HFE and ranged between 7790 and 9555 cones/mm2 (P < .001). Mean retinal sensitivity of all measured locations remained 18 dB in HFE and was significantly lower in RDE, with 14.30 dB at BL and 14.64 dB at FUP. Both SDOCT grading and microperimetry sensitivity showed strong correlation with AO-OCT grading and cone density (rho values > 0.750). CONCLUSIONS: The combination of AO-OCT, SDOCT, and microperimetry is a powerful tool to capture cone regeneration after vitreoretinal surgery. Our study shows that cone morphology and function improve within 56 weeks after RD surgery but structural and functional impairment is still present.