Occurrence, phase distribution, and mass loadings of benzothiazoles in riverine runoff of the Pearl River Delta, China.

A set of six benzothiazoles was determined in riverine runoff samples of the Pearl River Delta (PRD) collected monthly from March 2005 to February 2006. The concentrations of total benzothiazoles ranged from 220 to 611 ng/L, with benzothiazole (BT) being the most prominent (82%), followed by 2-methylthiobenzothiazole (MBT),thianaphthene (TN), and triphenylene (TP). The annual fluxes ofTN, BT, MBT, dibenzothiophene (DBT), 2-(4-morpholinyl)benzothiazole (24MoBT), and TP from the PRD to the coastal ocean were 1.94, 65.1, 10.1,0.63, 0.18, and 0.89 tons/yr, summing to yield an annual flux of 79 tons/yr for total benzothiazoles. In the PRD, approximately 1.1 x 10(5) tons of rubber are estimated to be released into the environment each year. This corresponds to the annual fluxes of 13 tons/yr for BT and 0.4 tons/yr for 24MoBT from tire particles. The annual fluxes of BT from scrap tires from Japan, Korea, Brazil, the European Union, the United States, and China were 99, 21, 36, 270, 328, and 120 tons/yr, respectively. The fluxes of 24MoBT from the same countries were 3.0, 0.5, 1.1, 8.4, 10.3, and 3.8 tons/ yr, respectively. These results indicated that tire-wear particles and scrap tires are the dominant sources of benzothiazoles in the environment. By comparison, Asia may be the major contributor to the global input of benzothiazoles from auto tires in the coming years. Overall, the six benzothiazoles under investigation appeared to be suitable tracers of pollutant inputs to surface runoff within the PRD aquatic system. In addition, 24MoBT seemed more appropriate than BT to trace tire rubber residues and therefore can be a good indicator of economic development and urbanization in a specific region.

Assessment of sampling designs to measure riverine fluxes from the Pearl River Delta, China to the South China Sea.

The Pearl River Delta (PRD), located in South China and adjacent to the South China Sea, is comprised of a complicated hydrological system; therefore, it was a great challenge to sample adequately to measure fluxes of organic and inorganic materials to the coastal ocean. In this study, several sampling designs, including five-point (the number of sampling points along the river cross-section and three samples collected at the upper, middle, and bottom parts at each vertical line), three-point (at the middle and two other profiles), one-point (at the middle profile), and single-point (upper, middle, or bottom sub-sampling point at the middle profile) methods, were assessed using total organic carbon (TOC) and suspended particulate matter (SPM) as the measurables. Statistical analysis showed that the three- and five-point designs were consistent with one another for TOC measurements (p > 0.05). The three- and one-point sampling methods also yielded similar TOC results (95% of the differences within 10%). Single-point sampling yielded considerably larger errors than the three- and one-point designs, relative to the results from the five-point design, but sampling at the middle sub-point from the middle profile of a river achieved a relatively smaller error than sampling at the upper or bottom sub-point. Comparison of the sampling frequencies of 12 times a year, four times a year, and twice a year indicated that the frequency of twice a year was sufficient to acquire representative TOC data, but larger sample size and higher sampling frequency were deemed necessary to characterize SPM.