[Distribution, Sources and Risk Assessment of the PAHs in the Surface Sediments and Water from the Daye Lake].

8 surface sediments and 8 water samples were collected from the Daye Lake in August 2015.The 16 kinds of EPA control polycyclic aromatic hydrocarbons (PAHs) were analyzed by GC-MS.The results showed that the PAHs concentrations of surface sediments and water ranged from 35.94 ng·g-1 to 2032.73 ng·g-1 and from 27.94 ng·L-1 to 242.95 ng·L-1,with average contents of 940.61 ng·g-1 and 107.77ng·L-1,respectively.The distribution of PAHs in surface sediments indicated that the contents in the center samples were higher than those in the bank samples,but the water showed nearly the opposite tendency.The 4-5 rings high molecular weight PAHs were the main components in the surface sediments,and the 2,4 and 5 rings PAHs were given priority in water.Compared with the other domestic and oversea lakes,the PAHs pollution of the Daye Lake was at a moderate level.Source apportionment showed that the PAHs in surface sediments and water from the Daye Lake came from the combustion source,HWM-PAHs were the dominant part of the PAHs in the sediment,reflecting the sediment PAHs pollution under the effects of mining and smelting over a long period;All monomer PAHs and total PAHs content in sediment did not exceed the ERM and FEL limiting values,showing that there was no particularly serious ecological risk caused by PAHs in the surface sediments from the Daye Lake;the incremental lifetime cancer risks assessment showed that the uptake risk of PAHs in Daye Lake water through the ingestion and dermal absorption were both in the acceptable range recommended by the USEPA,but all sites had higher risk than the acceptable risk level recommended by the Sweden environmental protection agency and Royal society.The pollution of seven carcinogenic PAHs needs prevention and control.

[Pollution Characteristics and Risk Assessment of Heavy Metals in Water and Sediment from Daye Lake].

The surface water and surface sediments were collected from Daye Lake in April 2014. The concentrations of heavy metals were determined by atomic absorption spectroscopy. The pollution potential health risk and ecological risk of heavy metals in water and sediment were assessed by the health risk assessment model and the potential ecological risk index method. The results showed that the concentrations of the heavy metals (Ni, Cd, Cu and Pb) was 49.27 µg·L-1, 2.19 µg·L-1, 12.18 µg·L-1, 12.13 µg·L-1(water) and 78.46 mg·kg-1, 77.13 mg·kg-1, 650.13 mg·kg-1 and 134.22 mg·kg-1 (sediment). Enrichment coefficient indicated that the enrichment of Cd, Cu and Pb was more serious, especially the accumulation of Cd was the most obvious. Compared to typical lakes in China, the contents of heavy metals in water and sediment were relatively high. The spatial pollutant distribution of the heavy metals in water and sediment all presented that the concentrations of the heavy metals were relatively higher in east and west of Daye Lake, relatively more uniform in the middle, and their origins were mainly from human activities. The results of environmental risk indicated that the carcinogens and chemical non-carcinogens health risk values of heavy metals by drinking water pathway were 9.77E-08~1.63E-05a-1. Therefore, the pollution of Ni and Cd should be the primary control target for environmental health risk management. The descending order of pollution degree of four metals in sediment was Cd> Cu> Pb> Ni, and Cd was the main contributor of the potential ecological risk elements.

[Transportation and risk assessment of heavy metal pollution in water-soil from the Riparian Zone of Daye Lake, China].

Each 20 water samples and soil samples (0-10 cm, 10-20 cm) were collected from the riparian zone of Daye Lake in dry season during March 2013. Heavy metals (Cu, Ph, Cd, Zn) have been detected by flame atomic absorption spectrometric (FAAS). The results showed that the average concentrations of Cu, Pb, Cd, Zn in the water were 7.14, 25.94, 15.72 and 37.58 microg x L(-1), respectively. The concentration of Cu was higher than the five degree of the surface water environment quality standard. The average concentrations of Cu, Pb, Cd, Zn in soil(0-10 cm) were 108.38, 53.92, 3.55, 139.26 mg x kg(-1) in soil (10-20 cm) were 93.00, 51.72, 2.08, 171.00 mg x kg(-1), respectively. The Cd concentrations were higher than the three grade value of the national soil environment quality standard. The transportation of Pb from soil to water was relatively stable, and Zn was greatly influenced by soil property and the surrounding environment from soil to water. The transformation of heavy metal in west riparian zone was higher than that of east riparian zone. The potential environmental risk was relatively high. Cu, Pb, Cd, Zn were dominated by residue fraction of the modified BCR sequential extraction method. The overall migration order of heavy metal element was: Pb > Cu > Cd > Zn. There were stronger transformation and higher environmental pollution risk of Cu, Pb. The index of assessment and potential ecological risk coefficient indicated that heavy metal pollution in soil (0-10 cm) was higher than the soil (10-20 cm), Cd was particularly serious.