[Distribution Characteristics and Risk Assessment of Heavy Metal Pollution in Farmland Soils and Crops in Luancheng, Shijiazhuang City].

In order to explore the distribution characteristics of heavy metal contamination of farmland soil surrounding Luancheng town, Shijiazhuang City, Henan province, the concentrations of As, Cd, Cr, Cu, Hg, Ni, Pb, and Zn in the surface soil and crops were determined and assessed. The principal components were also analyzed for source apportionment. The heavy metal concentrations in crops were further detected, and the non-carcinogenic health risks in the study area were evaluated using the probabilistic risk assessment method, as to provide a theoretical basis for the treatment, prevention, and control of heavy metal pollution in farmland soil in Luancheng. According to the results, ω(Cd), ω(Cr), ω(Cu), ω(Pb), and ω(Zn) in the soils were 0.06-1.08, 22.14-473.47, 12.83-150.74, 10.75-577.72, and 62.23-652.78 mg·kg-1, which exceeded the standard with over-standard rates reaching 1.83%, 1.22%, 0.61%, 0.61%, and 1.22%, respectively. Further, Cd and Pb were transported into crops, in which Cd concentrations exceeded the standard in some corn samples, and Cd and Pb concentrations exceeded the standard in some wheat samples. The total non-carcinogenic health risks (TTHQ) to the human body caused by the consumption of heavy metals in corn grown in the study area were all less than 1, with no obvious negative effects, and TTHQ was higher than 1 in wheat, increasing the likelihood of negative impacts on the human body. With the influence of the distribution of pollution-related enterprises in the industrial zone, heavy metal concentrations were higher in the south, west, and middle directions of the study area. Among them, the study area soil was slightly contaminated by Cd (Level 1). Cd and Hg had a slight potential ecological risk (Level 2), whereas other heavy metals had low potential ecological risk (Level 1). In general, most of the surface cultivated soil was not obviously polluted by heavy metals in the study area. According to the PMF results and survey, we speculated that soil heavy metals mainly came from soil parent material (52.05%), artificial pollution sources (historical sewage irrigation and industrial manufacture) (32.98%), and atmospheric deposition (14.97%). To summarize, the study area should be divided into a priority protection category and safe utilization category. The input of pollution sources should be strictly controlled for the priority protection category, and alternative planting, rotating, and fallow should be implemented for the safe utilization category to reduce the risk of standard-exceeding agricultural products.

[Spatial Distribution and Risk Assessment of Heavy Metal Pollution in Farmland Soils Surrounding a Typical Industrial Area of Henan Province].

In order to fully explore the spatial distribution of soil heavy metal contaminants in farmland soil surrounding a typical industrial area in Dakuai town, Xinxiang city, Henan Province, the concentrations of As, Cd, Cr, Cu, Ni, Pb, and Zn in the surface soil and within the soil profile were determined and assessed. The principal components were also analyzed for source apportionment to provide a theoretical basis for the control and prevention of heavy metal pollution. According to the results, the soils in the study area are severely contaminated by Cd and Cu and moderated contaminated by As due to the battery manufacture and Cu (e.g., pipe and wire) processing. The concentrations of Cd, Cu, and As in soils were (2.56±1.23) mg·kg-1, (205.58±157.49) mg·kg-1, and (15.27±4.14) mg·kg-1, respectively, which exceeds standards by 100%, 89.44%, and 3.40%, respectively. Accounting for the influence of pollution sources, terrain, runoff erosion, and prevailing wind direction, all heavy metal concentrations were higher in the south direction, lower in the north direction. The concentrations of Cd and Cu in soil profile samples decreased with depth, with highest concentrations at the surface, indicating the strong effect of industrial activities. Arsenic concentrations varied little with soil depth due to its strong migration ability in alkaline soil, again suggesting an industrial source. Among them, the soil of study area was severely contaminated by Cd and Cu (Level 5). Cd poses a severe potential ecological risk (Level 5) and Cu poses a medium risk (Level 2) in the study soils, while other heavy metals show low potential ecological risk (Level 1). The order of the risk identified was Cd > Cu > Ni > As > Pb > Cr > Zn. In addition, the combined potential ecological risk of heavy metals in the target area is severe. The principal component analysis showed that the high As, Cd, and Cu contents are mainly derived from industrial areas. Therefore, it is urgent to remediate Cd and Cu soil contamination in this area and implement precautions to limit As contamination.

Adding a recyclable amendment to facilitate sewage sludge biodrying and reduce costs.

Finding an economical amendment, available in a steady supply, is needed to support the biodrying industrialization. This research developed a recyclable biodrying amendment (RBA) to condition the biodrying of sewage sludge. The pilot-scale treatment (TR), which included the addition of equivalent weights of RBA and sawdust as amendments, resulted in a higher pile temperature and longer thermophilic phase compared to the control (TC), which used only sawdust as an amendment. The final moisture content levels were below 50% with both TR and TC. The heat use efficiency for water evaporation was 72.2% and 73.0% in TR and TC, respectively. The activity of α-amylase and cellulose 1,4-ß-cellobiosidase increased during the thermophilic phase, while the activity of endo-1,4-ß-glucanase and endo-1,4-ß-xylanase decreased during the thermophilic phase with both TR and TC. The fourier-transform infrared spectra indicated that adding the RBA resulted in good biodegradability of the lipids, proteins, and polysaccharides. The humic acid to fulvic acid ratio in TR and TC increased from 0.33 (TR) and 0.35 (TC) on day 0-0.46 (TR) and 0.45 (TC) on day 21, indicating the humification process. The RBA recovery rate was 95.6% and can be reused. These findings highlight that adding RBA showed satisfactory biodrying performance, reduced the amendment cost, and the biodrying product could be incinerated without energy deficit.