A novel total petroleum hydrocarbon fractionation strategy for human health risk assessment for petroleum hydrocarbon-contaminated site management.

Human health risk assessments for petroleum, oil, and lubricant (POL)-contaminated sites are more complicated than for sites contaminated by single compounds due to the complex composition and various analytical methods associated with total petroleum hydrocarbons (TPH). Although several TPH fractionation methods are commonly used, including that of the TPH Criteria Working Group (TPHCWG), an efficient and economical human health risk assessment method is not yet available. To address this concern, a new modified fractionation strategy is recommended in this study, which resolves the problems of the current TPH fractionation methods while retaining reliability in the results. For the purpose of this study, the distribution characteristics of the 13 TPHCWG fractions were examined, and human health risk assessments for the POL-contaminated sites were performed. The results show that aliphatic EC8-16 and aromatic EC10-21 among the 13 TPH fractions are major contributors to human health risks along all exposure routes, making up approximately 96% of the hazard index (HI) of the TPH fractions, on average. Therefore, it is reasonable to concentrate on aliphatic EC8-16 and aromatic EC10-21 fractions, rather than to study all of the TPH fractions, in evaluating human health risk for TPH-contaminated sites.

Mutagenicity assessment of produced water during photoelectrocatalytic degradation.

Oilfield produced water was treated by photocatalysis, electro-oxidation, and photoelectrocatalysis, respectively. The chemical composition and toxicity of the raw effluent and treated products were assessed by chemical and mutagenicity analysis. The raw effluent exhibited mutagenic activity in both strains of Salmonella typhimurium. The lowest concentration of the dichloromethane extract capable of inducing a positive response in strains TA98 and TA100 were as low as 4 and 5 microg/plate, respectively. All three technologies could detoxify direct-acting mutagenic organic pollutants efficiently, although they could not completely eliminate mutagenicity in the water after 60 min of treatment. At equivalent doses, photoelectrocatalysis exhibited the greatest capability to reduce genotoxicity, whereas photocatalysis was the least effective and did not cause appreciable change in mutagenicity. The gas chromatography-mass spectrometry (GC-MS) analysis revealed that n-alkanes (259.4 ng/L) and phenolic compounds (2,501.4 ng/L) were the main organic constituents in the oilfield produced water. Thus, the results of both biological and chemical analysis indicate that photoelectocatalysis was the most effective technology for degradation of oilfield wastewater.

China's "market economics in command": footwear workers' health in jeopardy.

This study of occupational safety and health (OSH) problems in the footwear industry in China, the world's largest shoemaker, is based on four years of research in China supplemented by research in Taiwan, Australia, and the United States. With the advent of the economic reforms of the early 1980s, the Chinese state is being driven by an economic imperative under which the profit motive overrides other concerns, causing a deterioration in OSH conditions. Footwear workers are being exposed to high levels of benzene, toluene, and other toxic solvents contained in the adhesives used in the shoe-making process. Many workers have been afflicted with aplastic anemia, leukemia, and other health problems. Most of China's current permissible exposure limits to toxins are either outdated or underenforced. As a result, the Chinese state's protection of footwear workers' health is inadequate. The article aims to draw the attention of the international OSH community to the importance of setting specific exposure standards for the footwear industry worldwide.

Exposure assessment for a field investigation of the acute respiratory effects of metalworking fluids. I. Summary of findings.

The exposure assessment summarized here is part of an epidemiologic study of the acute respiratory health effects of metalworking fluid (MF) exposures. Exposures were measured as the inhalable concentrations of the MF aerosol, a variety of metals and elements, and endotoxin as well as the level of culturable bacteria in the aerosol size fraction less than 8 microns. Bulk samples of soluble MFs were tested for pH, mineral and tramp oil fraction, endotoxin, culturable bacteria, and lipopolysaccharide levels. The MF exposed workers had higher geometric mean inhalable aerosol exposures (0.181 mg/m3) than the MF unexposed workers (0.046 mg/m3). The MF exposed workers had higher geometric mean (GM) airborne culturable microbial counts (102 colony-forming units (CFU)/m3 for bacteria < 8 microns) than the unexposed workers (GM = 14 CFU/m3). Among the unexposed, Bacillus was the predominant airborne species, while among the exposed workers, Pseudomonas predominated. Exposed workers also had higher geometric mean airborne endotoxin levels (GM = 7.1 endotoxin units (EU)/m3) than the unexposed workers (GM = 1.9 EU/m3). Elemental concentrations of iron, chlorine, and sulfur were substantially higher among the exposed workers compared to the unexposed workers. For soluble metalworking fluids, the levels of bulk constituents were examined by three categories of time since the machine sump was refilled with fresh MF (< 4 days, 4-21 days, > 21 days). Univariate analyses of percent oil, pH, culturable bacteria, tramp oil percent, endotoxin, or fatty acid levels all showed no statistically significant changes in level over time.

Assessment of the effects of atmospheric oil pollution in post war Kuwait.

A prospective study was undertaken to assess and monitor the effects of oil pollution in soldiers exposed in Kuwait in 1991 after Op Granby. One hundred and twenty five soldiers were monitored over a five month period by measurement of Forced Expiratory Volume (in one second) (FEV1) and Forced Vital Capacity (FVC). Although no demonstrable changes were observed, this study has gone some way to filling the gap in research in this environmentally sensitive field.

Measurement of skin-fold thickness in the guinea pig. Assessment of edema-inducing capacity of cutting fluids, acids, alkalis, formalin and dimethyl sulfoxide.

The rabbit has been used for decades for predictive testing of skin irritancy, but in recent years, the guinea pig has been suggested as an alternative, especially for assessment of one of the components of the irritant reaction: edema (fluid accumulation). A method based on skin-fold measurements with Harpenden calipers has been developed and modified. In previous papers, experience with sodium lauryl sulphate, nonanoic acid and industrial solvents was reported. The present results concern the use of cutting fluids, buffered and unbuffered acid and alkaline solutions, formalin and dimethyl sulfoxide. This inexpensive and comparatively unsophisticated method afforded clear dose-response relationships and good discriminating power. The only exception was the acid and alkaline solutions, where no changes in skin-fold thickness were observed despite their documented irritant potential. The appearance of erythema (visual scoring) and the increase in skin-fold thickness, and their relationship, are discussed with some illustrative examples. The method described is now well standardized and is suited for predictive testing of the edema-inducing capacity of chemicals and products.