Simultaneous determination and risk assessment of metalaxyl and azoxystrobin in potato by liquid chromatography with tandem mass spectrometry.

A liquid chromatography with tandem mass spectrometry method was developed and validated to simultaneously determine metalaxyl and azoxystrobin in soil, potato, and potato foliage samples. The samples were extracted by 20 mL of acetonitrile and purified with dispersive solid-phase extraction using octadecyl silane as sorbent. The method showed good linearity (determination coefficients ≥ 0.9926) for metalaxyl (2.5-500 ng/mL) and azoxystrobin (5-1000 ng/mL). The limits of detection and quantification for both fungicides were 1.5-20 µg/kg. The average recoveries in soil, potato, and potato foliage were 83.07-92.87% for metalaxyl and 82.71-98.53% for azoxystrobin. The intra- and inter-day relative standard deviations were all less than 9%. The method was successfully applied on the residual analysis of metalaxyl and azoxystrobin in field trial samples. The results showed that the concentrations of metalaxyl and azoxystrobin in potato samples collected from Guizhou and Hunan were below 50 and 100 µg/kg (maximum residue limit set by China), respectively, at 5 days after the last application. When following the recommended application manual, metalaxyl and azoxystrobin do not present health concerns to the population because the risk quotients are far below 100%. All the above data could help and promote the safe and proper use of metalaxyl and azoxystrobin in potato.

Health risk assessment of haloacetonitriles in drinking water based on internal dose.

To estimate the health risk of haloacetonitriles in different kinds of drinking water, the concentrations of haloacetonitriles in tap water, boiled water and direct drinking water were detected. The physiologically based pharmacokinetic (PBPK) model was used to calculate internal dose in the human body for haloacetonitriles through ingestion, and the probability distributions of the non-carcinogenic risk of haloacetonitriles for human via drinking water were assessed. This study found that the mean concentrations of dichloroacetonitrile (DCAN) in tap water, boiled water and direct drinking water were 0.955 µg/L, 0.207 µg/L and 0.127 µg/L, and those of dibromoacetonitrile (DBAN) were 0.221 µg/L, 0.104 µg/L, 0.089 µg/L, respectively. In China, direct drinking water is used most frequently, so the concentrations of haloacetonitriles in direct drinking water were used to obtain data on the internal dose of haloacetonitriles. In addition, the simulation results for the PBPK model showed that the highest and lowest concentrations of DCAN occurred in the liver and venous blood, respectively. The peak concentrations of DBAN in each tissue were in the decreasing order liver > rapidly perfused tissue > kidney > slowly perfused tissues > fat > arterial blood (venous blood). In addition, the highest 95th percentile hazard quotients (HQ) value of haloacetonitriles via drinking water for humans was 8.89 × 10-3, much lower than 1. The 95th percentile hazard index (HI) was 0.046, which was also lower than 1, suggesting that there was no obvious non-carcinogenic risk.

Occurrence and health risk assessment of halogenated disinfection byproducts in indoor swimming pool water.

Swimming pool disinfection byproducts (DBPs) have become a concern in many countries all over the world. In this study, the concentrations of several categories of DBPs, including trihalomethanes (THMs), haloacetic acids (HAAs), haloacetonitriles (HANs), haloketones (HKs) and trichloronitromethane (TCNM), in 13 public indoor swimming pools in Nanjing, China were determined, the correlations between DBPs and water quality parameters as well as between different DBP categories were evaluated, and the health risks of the DBPs to human were examined. The results indicate that the DBP levels in the swimming pools in Nanjing were relatively high, with HAAs as the most dominant category, followed by THMs, HANs, HKs and TCNM sequentially. Bromochloroacetic acid (BCAA), trichloromethane (TCM), dichloroacetonitrile (DCAN), and 1,1,1-trichloropropanone (1,1,1-TCP) were the most dominant species among HAAs, THMs, HANs, and HKs, respectively. For all the different categories of DBPs, the concentrations in the pool disinfected with ozonation/chlorination were lower than those in the pool disinfected with chlorination. The DBP levels were generally not affected by the number of swimmers and the DBP levels on different dates were relatively stable. Besides, the chlorine residual seemed to be a critical concern in most of the swimming pools in this study. Moreover, there were some correlations between DBPs and water quality parameters as well as between different DBP categories. It is to be noted that the predicted cancer and health risks of the DBPs in these swimming pools were generally higher than the regulatory limits by USEPA, and thus DBPs in these swimming pools should be concerned.

Concentrations and correlations of disinfection by-products in municipal drinking water from an exposure assessment perspective.

Although disinfection by-products (DBPs) occur in complex mixtures, studies evaluating health risks have been focused in few chemicals. In the framework of an epidemiological study on cancer in 11 Spanish provinces, we describe the concentration of four trihalomethanes (THMs), nine haloacetic acids (HAA), 3-chloro-4-(dichloromethyl)-5-hydroxy-2(5H)-furanone (MX), four haloacetonitries, two haloketones, chloropicrin and chloral hydrate and estimate correlations. A total of 233 tap water samples were collected in 2010. Principal component analyses were conducted to reduce dimensionality of DBPs. Overall median (range) level of THMs and HAAs was 26.4 (0.8-98.1) and 26.4 (0.9-86.9) µg/l, respectively (N=217). MX analysed in a subset (N=36) showed a median (range) concentration of 16.7 (0.8-54.1)ng/l. Haloacetonitries, haloketones, chloropicrin and chloral hydrate were analysed in a subset (N=16), showing levels from unquantifiable (<1 µg/l) to 5.5 µg/l (dibromoacetonitrile). Spearman rank correlation coefficients between DBPs varied between species and across areas, being highest between dibromochloromethane and dibromochloroacetic acid (r(s)=0.87). Principal component analyses of 13 DBPs (4 THMs, 9 HAAs) led 3 components explaining more than 80% of variance. In conclusion, THMs and HAAs have limited value as predictors of other DBPs on a generalised basis. Principal component analysis provides a complementary tool to address the complex nature of the mixture.

Determination of pesticide residues in foods by acetonitrile extraction and partitioning with magnesium sulfate: collaborative study.

A collaborative study was conducted to determine multiple pesticide residues in fruits and vegetables using a quick, simple, inexpensive, and effective sample preparation method followed by concurrent analysis with gas chromatography/mass spectrometry (GC/MS) and liquid chromatography/ tandem mass spectrometry (LC/MS/MS). For short, the method is known as QuEChERS, which stands for quick, easy, cheap, effective, rugged, and safe. Twenty representative pesticides were fortified in 3 matrixes (grapes, lettuces, and oranges) at 3 duplicate levels unknown to the collaborators ranging from 10 to 1000 ng/g. Additionally, 8 incurred pesticide residues were determined. Thirteen laboratories from 7 countries provided results in the study, and a variety of different instruments were used by collaborators. The QuEChERS procedure simply entails 3 main steps: (1) a 15 g homogenized sample is weighed into a 50 mL centrifuge tube to which 15 mL acetonitrile containing 1% HOAc is added along with 6 g MgSO4 and 1.5 g NaOAc, and the tube is shaken and centrifuged; (2) a portion of the extract is mixed with 3 + 1 (w/w) MgSO4-primary secondary amine sorbent (200 mg/mL extract) and centrifuged; and (3) the final extract is analyzed by GC/MS and LC/MS/MS. To detect residues <10 ng/g in GC/MS, large-volume injection of 8 microL is typically needed, or the extract can be concentrated to 4 g/mL in toluene, in which case 2 microL splitless injection is used. In the study, the averaged results for data from 7-13 laboratories (not using internal standardization) for the 18 blind duplicates at the 9 spiking levels in the 3 matrixes are as follows [%recovery and reproducibility relative standard deviation (RSD(R), %)]: atrazine, 92 (18); azoxystrobin, 93 (15); bifenthrin, 90 (16); carbaryl, 96 (20); chlorothalonil, 70 (34); chlorpyrifos, 89 (25); cyprodinil, 89 (19); o,p'-DDD, 89 (18); dichlorvos, 82 (21); endosulfan sulfate, 80 (27); imazalil, 77 (33); imidacloprid, 96 (16); linuron, 89 (19); methamidophos, 87 (17); methomyl, 96 (17); procymidone, 91 (20); pymetrozine, 69 (19); tebuconazole, 89 (15); tolylfluanid (in grapes and oranges), 68 (33); and trifluralin, 85 (20). For incurred pesticides, kresoxim-methyl (9.2 +/- 3.2 ng/g) and cyprodinil (112 +/- 18) were found in the grapes; permethrins (112 +/- 41), lamda-cyhalothrin (58 +/- 11), and imidacloprid (12 +/- 2) were determined in the lettuces; and ethion (198 +/- 36), thiabendazole (53 +/- 8), and imazalil (13 +/- 4) were determined in the oranges. Chlorpyrifosmethyl (200 ng/g) was used as a quality control standard added during sample homogenization and yielded 86% recovery and 19% RSD(R). Intralaboratory repeatabilities for the method averaged 9.8% RSD for all analytes. The results demonstrate that the method is fit-for-purpose to monitor many pesticide residues in fruits and vegetables, and the Study Director recommends that it be adopted Official First Action.

Multianalyte chemical identification and quantitation using a single radio frequency identification sensor.

We demonstrate an approach for multianalyte chemical identification and quantitation using a single conventional radio frequency identification (RFID) tag that has been adapted for chemical sensing. Unlike other approaches of using RFID sensors, where a special tag should be designed at a much higher cost, we utilize a conventional RFID tag and coat it with a chemically sensitive film. As an example, we demonstrate detection of several vapors of industrial, health, law enforcement, and security interest (ethanol, methanol, acetonitrile, water vapors) with a single 13.56-MHz RFID tag coated with a solid polymer electrolyte sensing film. By measuring simultaneously several parameters of the complex impedance from such an RFID sensor and applying multivariate statistical analysis methods, we were able to identify and quantify several vapors of interest. With a careful selection of the sensing film and measurement conditions, we achieved parts-per-billion vapor detection limits in air. These RFID sensors are very attractive as ubiquitous multianalyte distributed sensor networks.

A high performance liquid chromatography method for the simultaneous determination of arctiin, chlorogenic acid and glycyrrhizin in a Chinese proprietary medicine.

A high performance liquid chromatography (HPLC) method was developed for the simultaneous determination of arctiin, chlorogenic acid and glycyrrhizin in the tablets of a Chinese proprietary medicine named, "Yin Qiao Jie Du Pian". The analysis was performed by a reverse phase gradient elution, using an aqueous mobile phase (containing 0.4% acetic acid and 4.5% tetrahydrofuran) modified by acetonitrile and detection made simultaneously at three wavelengths. The method was validated for specificity, accuracy, precision and limits of detection and quantification. Tablets of seven commercial brands were analyzed and found to contain different amounts of the three bioactive markers. This raised the question of the quality and the efficacy of the products. The method developed can be used for the quality control of "Yin Qiao Jie Du" tablets.

Investigation of the retention/pH profile of zwitterionic fluoroquinolones in reversed-phase and ion-interaction high performance liquid chromatography.

The retention/pH profiles of three fluoroquinolones, ofloxacin, norfloxacin and ciprofloxacin, was investigated by means of reversed-phase high performance liquid chromatography (RP-HPLC) and reversed-phase ion-interaction chromatography (RP-IIC), using an octadecylsilane stationary phase and acetonitrile as organic modifier. Sodium hexanesulphonate and tetrabutylammonium hydroxide were used as sources of counter ions in ion-interaction chromatography. The retention/pH profiles under in RP-HPLC were compared to the corresponding lipophilicity/pH profiles. Despite the rather hydrophilic nature of the three fluoroquinolones positive retention factors were obtained while there was a shift of the retention maximum towards more acidic pH values. This behavior was attributed mainly to non-hydrophobic silanophilic interactions with the silanized silica gel material of the stationary phase. In ion-interaction chromatography the effect of counter ions over a broad pH range was found to be ruled rather by the ion pair formation in the mobile phase which led to a drastic decrease in retention as a consequence of the disruption of the zwitterionic structure and thereupon the deliberation of a net charge in the molecules. At pH values at which zwitterionic structure was not favored both the ion-exchange and ion pair formation mechanisms were assumed to contribute to the retention.

Quantitative assessment of the reliability of identification by high-performance liquid chromatography-mass spectrometry.

At present, mass spectrometry (MS) is the most reliable method for identification but there is not yet a quantitative equation describing this fact. In this investigation an approach to the quantitative assessment of the reliability of identification by MS is proposed which is useful for determination of the selectivity and the validation of analytical methods. Mass spectra of the analytes are presented as maps in which the characteristic ions and their intensities are used for identification. A formula for the quantitative expression of the significance of these parameters to the reliability and the identification is given. The contribution of the resolution of MS instruments or their possibilities of a multiple fragmentation to the reliability of the identification is shown. This approach makes it possible to compare the reliability of identification with different MS instruments. Despite the small contribution of the separation of the chromatographic column compared to the MS separation, the role of the column in the identification is very important to distinguish isomers because their MS spectra are similar.