Longitudinal assessment of dental erosion-abrasion by cross-polarization optical coherence tomography in vitro.

This study tested a novel in vitro dental erosion-abrasion model and the performance of cross-polarization optical coherence tomography (CP-OCT) in longitudinally monitoring the simulated lesions. Thirty human enamel specimens were prepared and randomized to receive three dental erosion-abrasion (EA) protocols: severe (s-EA, lemon juice/pH:2.5/4.25%w/v citric acid), moderate (m-EA, grapefruit juice/pH:3.5/1.03%w/v citric acid) and no-EA (water, control). EA challenge was performed by exposing the specimens to acidic solutions 4x/day and to brushing 2x/day with 1:3 fluoridated toothpaste slurry, for 14 days. Enamel thickness measurements were obtained using CP-OCT at baseline (D0), 7 (D7) and 14 days (D14) and micro-computed tomography (micro-CT) at D14. Enamel surface loss was measured with both CP-OCT and optical profilometry at D0, D7 and D14. Data was analyzed with repeated-measures ANOVA and Pearson's correlation (r) (α = 0.05). CP-OCT enamel thickness decreased over time in the s-EA group (D0 >D7 > D14, p < 0.001) and m-EA group (D0 > D14, p = 0.019) but did not change in the no-EA group (p = 0.30). Overall, CP-OCT and micro-CT results at D14 correlated moderately (r = 0.73). CP-OCT surface loss was highest for s-EA (p <0.001) but did not differ between moderate and no-EA (p = 0.25). Enamel surface loss with profilometry increased with severity (no-EA>m-EA>s-EA, p < 0.001). D14 surface loss was higher than D7 for both methods except for the no-EA group with profilometry. CP-OCT and profilometry had moderate overall correlation (r = 0.70). Our results revealed that the currently proposed in vitro dental erosion-abrasion model is valid and could simulate lesions of different severities over time. CP-OCT was a suitable method for monitoring the EA lesions.

Cross-polarization optical coherence tomographic assessment of in situ simulated erosive tooth wear.

This clinical study tested cross-polarization optical coherence tomography (CP-OCT) monitoring of erosive tooth wear (ETW). Twenty participants completed a 14-day/arm, 3-arm crossover study simulating different ETW severities. Participants received two enamel specimens (per arm) and were randomized to: severe (s-ETW, lemon juice/pH:2.5/4.25%wt/vol citric acid), moderate (m-ETW, grapefruit juice/pH:3.5/1.03%wt/vol citric acid), and non-ETW (water). Enamel thickness was measured with CP-OCT (day[D] 0, 7, 14) and micro-computed tomography (µ-CT; D14). Enamel surface loss was determined with CP-OCT and optical profilometry (OP; D7, D14). CP-OCT showed higher enamel surface loss for D14 than D7 for m-ETW (P = .009) and s-ETW (P = .040) and differentiated severity at D14 (s-ETW > non-ETW, P = .027). OP was able to differentiate surface loss between days (D7 < D14, P < .001) for m-ETW and s-ETW, and ETW severity effect after 7 and 14 days (non-ETW < m-ETW < s-ETW, P < .001). At D14, CP-OCT and µ-CT were positively correlated (r = .87, ICC = .62). CP-OCT showed potential as a tool for clinical ETW monitoring.

Impact of early biofilm on the assessment of initial enamel erosion with swept-source optical coherence tomography.

Objective: This study examined the impact of early biofilm on the tooth surface, during the assessment of initial enamel erosion using swept-source optical coherence tomography (SS-OCT). Method and materials: Forty-five enamel windows of 2 × 4 mm2 were prepared on 23 extracted human teeth. The specimens were exposed to citric acid (pH 3.2) for 30 minutes and randomly divided into three groups (n = 15): Group 1, no biofilm; Group 2, 1-day-old biofilm; and Group 3, 3-day-old biofilm. Specimens in Groups 2 and 3 were inoculated with oral bacteria (Streptococcus sanguinis, Streptococcus mitis, and Actinomyces naeslundii) to produce early laboratory-cultivated biofilms for 1 and 3 days respectively. Surface microhardness (SMH) measurements were taken at pre- (t1) and post-erosion (t2); and SS-OCT scans were done at t1, t2, and post-biofilm cultivation (t3). Integrated reflectivity (IR) of the tooth-air interface (IRsurface) and enamel (IRenamel) were computed from the mean A-scans. Statistical analysis was performed using paired t tests and one-way ANOVA (α = .05). Results: A significant increase in IRenamel was observed at t2 (P < .05). At t3, IRsurface between Group 1 (control) and Group 2 (P = .012) as well as Group 3 (P = .001) were significantly different. Significant variances in IRenamel were perceived between t2 and t3 for Groups 2 and 3 but not for Group 1. Conclusion: As early biofilm affected SS-OCT assessment of initial enamel erosion, they should be removed from the tooth surface prior to OCT procedures..

Methods of assessment of early dentine erosion: a review.

Dentine erosion is an increasingly recognised problem, especially in aging population, and various methods have been utilised for its assessment. This narrative review was planned to summarise the methods for the assessment of the early stages of dentine erosion. Relevant original articles published in the English language from 2013 to 2017 were reviewed. Laboratory techniques and methods with in vivo potential were separately studied. It is evident that the assessment of early dentine erosion is complex and requires a combination of methods. For clinical evaluation, chemical analysis and optical methods show great potential but are in need of more validation.

A novel electron-microscopic method for measurement of mineral content in enamel lesions.

OBJECTIVE: To assess Scanning Electron Microscopy in Back-Scattered Emission mode (BSE-SEM) for measurement of lesion mineral content as a function of depth. Direct comparison is made with Transverse Micro-Radiography (TMR) and Surface Micro-Hardness (SMH) on carious and erosive lesions. DESIGN: Caries lesions prepared from sound bovine enamel at 37 °C and pH 4.6 in unsaturated (7d) or part-saturated (8d, 4.1 mM Ca2+, 8 mM Pi) lactic acid /methyl cellulose gel system, followed by TMR analysis. Erosive lesions prepared from sound bovine enamel (1% citric acid, pH3.8, room temperature) for 5, 10, 15 or 20 min at n = 10 per treatment group. SMH readings (Vickers diamond, 1.9 N, 20 s) were taken from acid-treated and reference areas of each sample. BSE-SEM performed on polished cross-sections of lesioned samples (Jeol JSM6490LV SEM; high vacuum, 10 keV beam voltage, magnification x500 with constant working distance of 10 mm). Under identical SEM conditions, polished standards i.e. MgF2, alumina, Mg, Al and Si provided a calibration plot of BSE-SEM signal vs. atomic number (z¯). Mineral content vs. depth plots were derived from the cross-sectional BSE-SEM data. RESULTS: Cross-sectional BSE-SEM images clearly differentiate between caries and erosive lesions. Comparison of caries lesion mineral loss from BSE-SEM with TMR data showed good correlation (R2 = 0.98). Similarly, comparison of BSE-SEM data from erosive lesions showed good correlation (R2 = 0.99) with hardness loss data from SMH. CONCLUSION: BSE-SEM provides a relatively rapid and cost-effective method for the assessment of mineral content in demineralised tooth enamel and is applicable to both caries and erosive lesions.

Geochemical sources, hydrogeochemical behavior, and health risk assessment of fluoride in an endemic fluorosis area, central Iran.

The present study is the first attempt to put forward the possible source(s) and health risk assessment of fluoride in Bahabad, central Iran. Fluoride concentrations ranged from 0.22 to 2.35 mg/L and 292-355 mg/kg in the groundwater and soil samples, respectively. Geochemical provenance techniques using major and rare earth elements in soils revealed that local shale is the most probable source rock of fluoride in the area. A two-step chemical fractionation method applied on soil samples demonstrated that residual and water-soluble fractions were the most probable modes of fluoride in soil, whereas exchangeable fraction had a minor role. The coefficient of aqueous migration showed that fluoride in the studied soils behaved as a mobile element. Moreover, the relative mobility indicated that soils played a more important role than rocks in releasing fluoride into groundwater. In groundwater medium, chemical weathering, evaporation, and ion exchange acted as the main geochemical controlling factors of fluoride enrichment. Findings of this study signify that the role of NaCl and NaSO4-type waters should be considered more to recognize susceptible areas to fluoride contamination in groundwater. People in the study area are exposed to high levels of fluoride intake through drinking water, thus making dental fluorosis a major public health concern in the area. Scanning electron microscopy of the dentin's enamel showed morphological modifications (e.g., cracks and fissures) in residents' enamel structures. The results of this study may lead to suitable management strategies to mitigate the endemic fluorosis problem.

Topographic and radiographic profile assessment of dental erosion. Part III: Effect of green and black tea on human dentition.

This study compared green and black tea to soda and orange juice in terms of their erosive effect on the human dentition. Vinegar and water were used as active and passive control fluids. An accelerated in vitro test was used to monitor how short- and long-term exposure to these fluids affected the topography and morphology of the coronal segments of the human dentition. This 20-week test was conducted under controlled conditions, independent of the influencing factors of the oral environment. The erosive effects of these fluids were categorized generally into three groups: highly erosive (vinegar), moderately erosive (soda and orange juice), and minimally erosive (black and green tea). The erosive effect of tea was similar to that of water, which has no erosion potential. Given the systemic and dental benefits of tea and the low potential for erosion, green and black tea should be highly encouraged for daily beverage consumption.

Topographic and radiographic profile assessment of dental erosion. Part II: effect of citrus fruit juices on human dentition.

This study sought to monitor changes in the topography, morphology, and radiographic profiles of human permanent teeth that had been exposed to citrus fruit juices. The effect of long-term exposure was monitored for a prolonged duration of 20 weeks according to set criteria. Topographic and morphologic changes were observed at weekly intervals following challenge by test fluids (orange, lemon, and grapefruit juices) and compared with control fluids (acetic acid and water). The qualitative changes in the specimens' topography and the morphology of citrus fruit juices and control fluids are described as a function of time, in specific details. The digitized radiographic images obtained at four-week intervals were analyzed and the changes were assessed. The results indicated that orange juice specimens demonstrated the mildest changes, while lemon juice specimens displayed the most severe damage to the coronal segments of the teeth. This damage manifested as loss of cusp height, cervical enamel, and coronal radius, as well as reduction of enamel cap height. Of the tested and control fluids, lemon juice displayed the most eros ion, followed by acetic acid, grapefruit juice, orange juice, and water, which had no effect. Continued immersion in the four acidic fluids led to varying degrees of enamel loss progression.

Topographic and radiographic profile assessment of dental erosion--Part I: Effect of acidulated carbonated beverages on human dentition.

Evidence-based case reports and epidemiologic surveys have indicated an association between dental erosion and high consumption of acidulated carbonated beverages (ACBs). This study sought to monitor the effect of exposure to ACBs on the topography and geometrical profile of disassociated human dentition. Two representatives of ACBs, caramelized (ACCB) and non-caramelized (AN-CCB), were evaluated along with control liquids. Following exposure to the fluids, qualitative assessment of topographic changes and quantitative analysis of digitized serial radiographic tracings were performed at four-week intervals for 20 weeks. Within the controlled perimeters of this in vitro test, the erosive effects of ACBs were closely similar but were lower than those caused by acetic acid (control fluid). These effects were indicated by changes in enamel topography (such as color, translucency, texture, and integrity) as well as reduction in specimen profile parameters. This amounted to an average weekly reduction in cusp tip height, a loss of cervical enamel, a reduction of enamel cap height, and reduction of crown radius for the ACBs and acetic acid.

Comparison of calcium/phosphorus analysis, longitudinal microradiography and profilometry for the quantitative assessment of erosive demineralisation.

The study is a comparison of methods for the quantitative measurement of erosive mineral loss including longitudinal microradiography (LMR), profilometry (PM), and analysis of calcium (CA) and phosphorus (PA) in the erosion solution. Polished human enamel samples were taped, covered with nail varnish and the edges of the resulting enamel window marked with drilled holes as a reference. All samples were subjected to baseline LMR. Sixty samples each were eroded with citric acid (0.05 M; pH 2.3; 10 ml per sample) for 30, 60, 90, or 120 min. Erosive loss of each sample was estimated by the four methods. All methods revealed a linear erosive loss over time and showed good linear correlation. Values calculated from PM and LMR were both approximately 20% lower than those from CA and PA. After 30 min erosion, LMR showed no significant correlation with the other three methods. With LMR, erosive loss below 20 microm should be interpreted with care.

The laboratory assessment of enamel erosion: a review.

OBJECTIVES: To review the various methods and techniques available to assess enamel erosion in vitro. DATA: Peer reviewed scientific articles. SOURCES: Medline and Web of Science searches and manual searching. STUDY SELECTION: Laboratory based assessments only included. CONCLUSIONS: A number of macroscopic and microscopic techniques have been used to assess enamel erosion in vitro and in situ. This review examines techniques which are either well established or comparatively novel techniques that are being explored for their potential.