An experimental strategy validated to design cost-effective culture media based on response surface methodology.

For any fermentation process, the production cost depends on several factors, such as the genetics of the microorganism, the process condition, and the culture medium composition. In this work, a guideline for the design of cost-efficient culture media using a sequential approach based on response surface methodology is described. The procedure was applied to analyze and optimize a culture medium of registered trademark and a base culture medium obtained as a result of the screening analysis from different culture media used to grow the same strain according to the literature. During the experiments, the procedure quantitatively identified an appropriate array of micronutrients to obtain a significant yield and find a minimum number of culture medium ingredients without limiting the process efficiency. The resultant culture medium showed an efficiency that compares favorably with the registered trademark medium at a 95% lower cost as well as reduced the number of ingredients in the base culture medium by 60% without limiting the process efficiency. These results demonstrated that, aside from satisfying the qualitative requirements, an optimum quantity of each constituent is needed to obtain a cost-effective culture medium. Study process variables for optimized culture medium and scaling-up production for the optimal values are desirable.

In vitro assessment of allergenicity features and localization of probable IgE binding regions.

Rice is cultivated as a staple grain crop in many countries, especially in Asia. In the present study, recombinant rice chitinase was expressed, purified and characterized by in silico and immunobiochemical methods. Rice chitinase was affinity purified and it resolved at 24 kDa on SDS-PAGE. Purified protein was analyzed for pepsin resistance, heat stability, and IgE binding using atopic patients' sera. Chitinase was resistant to pepsin digestion and heat treatment at 90 °C for 1 h. It showed significant IgE binding with 7 of 110 patients' sera positive to different food allergens. Homology modeled 3D structure of rice chitinase was used for B cell epitope prediction. In silico predicted B cell peptides were assessed for IgE binding by ELISA using food allergic patients' sera, epitope RC2 showed IgE binding comparable to chitinase. In conclusion, chitinase was identified as a potential allergen and may share cross reactive epitopes with food allergens.

Comprehensive Assessment of Host Responses to 5-Fluorouracil-Induced Oral Mucositis through Transcriptomic Analysis.

BACKGROUND: Chemotherapy plays an important role in current cancer therapy; however, several problems remain unsolved on the issue of host-therapeutics interaction. The purpose of this study was to investigate the host responses after 5-flurouracil (5-FU) administration and to find the target genes and their relationship with other cytokines in the 5-FU-induced oral mucositis (OM) mouse model through transcriptomic analysis. MATERIALS AND METHODS: Thirty-six 6 to 8 week-old male BALB/c mice were randomly divided into the control group and 5-FU-treated group. In the 5-FU group, mice received 5-FU (100 mg/kg, intraperitoneally) on day 1, day 8, day 15, day 22, and day 29, respectively. We evaluated the oral mucosal change under macroanalysis and histological examination at indicated periods, and then applied transcriptomic analysis of gene expression profile and Immunohistochemical stain to identify the target molecules related to 5-FU-induced OM. RESULTS: The most prominent histological change in this model was observed in the fifth week. The gene expression of Bone gamma-carboxyglutamate protein, related sequence 1 (Bglap-rs1) (-12.69-fold) and Chitinase 3-like 4 (Chi3l4) (-6.35-fold) were significantly down-regulated in this phase. The quantitative real-time PCR results also revealed the expression levels were 0.62-fold in Bglap-rs1 and 0.13-fold in Chi3l4 compared with the control group. Immunohistochemical stain showed significant expression of cluster of differentiation 11b (p<0.01), interleukin-1ß (p<0.001) and tumor necrosis factor-α (p<0.05), and down-regulation of Bglap-rs1 (p<0.01) compared with the control group. By Kyoto Encyclopedia of Genes and Genomes pathway analysis, there were twenty-three pathways significantly participated in this study (p<0.05). CONCLUSIONS: Through comprehensively transcriptomic analysis and IHC stain, we discovered several valuable pathways, verified the main pro-inflammatory cytokines, and revealed two significantly down-regulated genes in the 5-FU-induced OM model. These findings highlighted the way of seeking effective therapeutic agents for chemotherapy-induced OM in future.

Colloid chitin azure is a dispersible, low-cost substrate for chitinase measurements in a sensitive, fast, reproducible assay.

Chitin and its derivatives are widely used as biomedical materials because of their versatility and biocompatibility. Chitinases are enzymes that produce chito-oligosaccharides from chitin. The assay of chitinase activity is difficult because few appropriate substrates are available. In this study, the authors developed an efficient and low-cost chitinase assay using colloidal chitin azure. The assay feasibility is evaluated and compared with traditional assays employing colloidal chitin and chitin azure. The authors found that the optimum pH for determining chitinase activity using colloid chitin azure was pH 5 or 8. The method was sensitive, and the assay was complete within 30 min. When the assay was used to measure chitinase activities produced by 2 strains of chitinolytic bacteria, BCTS (an Escherichia coli BL21 [DE3] expressing a secretory recombinant chitinase) and AS1 (a chitinolytic bacterium with low levels of chitinase), it was shown that cultivation in Bushnell-Haas selection medium caused AS1 to secrete a higher level of chitinase than was secreted when the bacterium grew in other media. In summary, colloid chitin azure is a sensitive, feasible, reproducible, and low-cost substrate for the assay of chitinase activity.

Costs and benefits of processivity in enzymatic degradation of recalcitrant polysaccharides.

Many enzymes that hydrolyze insoluble crystalline polysaccharides such as cellulose and chitin guide detached single-polymer chains through long and deep active-site clefts, leading to processive (stepwise) degradation of the polysaccharide. We have studied the links between enzyme efficiency and processivity by analyzing the effects of mutating aromatic residues in the substrate-binding groove of a processive chitobiohydrolase, chitinase B from Serratia marcescens. Mutation of two tryptophan residues (Trp-97 and Trp-220) close to the catalytic center (subsites +1 and +2) led to reduced processivity and a reduced ability to degrade crystalline chitin, suggesting that these two properties are linked. Most remarkably, the loss of processivity in the W97A mutant was accompanied by a 29-fold increase in the degradation rate for single-polymer chains as present in the soluble chitin-derivative chitosan. The properties of the W220A mutant showed a similar trend, although mutational effects were less dramatic. Processivity is thought to contribute to the degradation of crystalline polysaccharides because detached single-polymer chains are kept from reassociating with the solid material. The present results show that this processivity comes at a large cost in terms of enzyme speed. Thus, in some cases, it might be better to focus strategies for enzymatic depolymerization of polysaccharide biomass on improving substrate accessibility for nonprocessive enzymes rather than on improving the properties of processive enzymes.

Assessment of chitin decomposer diversity within an upland grassland.

The breakdown of chitin within an acidic upland grassland was studied. The aim was to provide a molecular characterisation of microorganisms involved in chitin degradation in the soil using soil microcosms and buried litter bags containing chitin. The investigation involved an examination of the effects of liming on the microbial communities within the soil and their chitinolytic activity. Microcosm experiments were designed to study the influence of lime and chitin enrichment on the grassland soil bacterial community ex situ under controlled environmental conditions. Bacterial and actinomycete counts were determined and total community DNA was extracted from the microcosms and from chitin bags buried at the experimental site. PCR based on specific 16S rRNA target sequences provided products for DGGE analysis to determine the structure of bacterial and actinomycete communities. Chitinase activity was assessed spectrophotometrically using chitin labelled with remazol brilliant violet. Both liming and chitin amendment increased bacterial and actinomycete viable counts and the chitinase activity. DGGE band patterns confirmed changes in bacterial populations under the influence of both treatments. PCR products amplified from DNA isolated from chitin bags were cloned and sequenced. Only a few matched known species but a prominent coloniser of chitin proved to be Stenotrophomonas maltophilia.