Biaxial stress and optoelectronic properties of Al-doped ZnO thin films deposited on flexible substrates by radio frequency magnetron sputtering.

Transparent conductive Al-doped ZnO (AZO) thin films were deposited on polyethylene terephthalate (PET) and polycarbonate (PC) substrates using radio frequency (RF) magnetron sputtering. The biaxial stress was measured with a double beam shadow moiré interferometer, and x-ray diffraction (XRD) was used to investigate the crystal orientation of ZnO. The substrate temperature was varied from room temperature to 150°C in steps of 25°C. The experimental results showed that the residual and shearing stresses increased with the increase in substrate temperature. The residual stress can be separated into principle and shearing stresses by Mohr's circle rule, and the shearing stress (tensile stress) was different from the compressive stress of the residual stress. However, the optimal substrate temperatures for PET and PC were 75°C and 100°C, and the shearing stresses were 424.82 and 543.68 MPa, respectively. AZO/PET and AZO/PC thin films cracked at substrate temperatures of 75°C and 100°C, respectively. AZO/PET thin film at a substrate temperature of 100°C had a resistivity low to the order of 10-3 Ω-cm.

Platinum Metallization of Polyethylene Terephthalate by Supercritical Carbon Dioxide Catalyzation and the Tensile Fracture Strength.

Polyethylene terephthalate (PET) is known to be highly inert, and this makes it difficult to be metallized. In addition, Pt electroless plating is rarely reported in the metallization of polymers. In this study, the metallization of biocompatible Pt metal is realized by supercritical CO2 (sc-CO2)-assisted electroless plating. The catalyst precursor used in the sc-CO2 catalyzation step is an organometallic compound, palladium (II) acetylacetonate (Pd(acac)2). The electrical resistance is evaluated, and a tape adhesion test is utilized to demonstrate intactness of the Pt layer on the PET film. The electrical resistance of the Pt/PET with 60 min of the Pt deposition time remains at a low level of 1.09 Ω after the adhesion test, revealing positive effects of the sc-CO2 catalyzation step. A tensile test is conducted to evaluate the mechanical strength of the Pt/PET. In-situ electrical resistances of the specimen are monitored during the tensile test. The fracture strength is determined from the stress value when the short circuit occurred. The fracture strength is 33.9 MPa for a specimen with 30 min of the Pt deposition time. As the Pt deposition time increases to 45 min and 60 min, the fracture strengths reach 52.3 MPa and 65.9 MPa, respectively. The promoted fracture strength and the decent electrical conductivity demonstrate the advantages toward biomedical devices.

A high temporal/spatial resolution neuro-architecture study of rodent brain by wideband echo planar imaging.

Latest simultaneous multi-slice (SMS) methods greatly benefit MR efficiency for recent studies using parallel imaging technique. However, these methods are limited by the requirement of array coils. The proposed Coherent Wideband method, which employs an extended field of view to separate multiple excited slices, can be applied to any existing MRI instrument, even those without array coils. In this study, the Coherent Wideband echo-planar imaging method was implemented on 7 T animal MRI to exhibit comprehensive enhancements in neuro-architecture, including diffusion tensor imaging (DTI) and functional MR studies (fMRI). Under the same scan time, the time-saving effect can be manipulated to increase the number of averages for DTI SNR improvement, reducing fractional anisotropy difference by 56.9% (from 0.072 to 0.041) and the deviation angle by 64% (from 25.3° to 16.2°). In summary, Coherent Wideband Echo Planar Imaging (EPI) will provide faster, higher resolution, thinner slice, or higher SNR imaging for precision neuro-architecture studies.

Performance Enhancement of Pentacene-Based Organic Thin-Film Transistors Using a High-K PVA/Low-K PVP Bilayer as the Gate Insulator.

In this study, we proposed using the high-K polyvinyl alcohol (PVA)/low-K poly-4-vinylphenol (PVP) bilayer structure as the gate insulator to improve the performance of a pentacene-based organic thin-film transistor. The dielectric constant of the optimal high-K PVA/low-K PVP bilayer was 5.6, which was higher than that of the single PVP layer. It resulted in an increase in the gate capacitance and an increased drain current. The surface morphology of the bilayer gate dielectric could be suitable for pentacene grain growth because the PVP layer was deposited above the organic PVA surface, thereby replacing the inorganic surface of the ITO gate electrode. The device performances were significantly improved by using the bilayer gate dielectric based upon the high-K characteristics of the PVA layer and the enlargement of the pentacene grain. Notably, the field-effect mobility was increased from 0.16 to 1.12 cm2/(Vs), 7 times higher than that of the control sample.

A specific absorption rate reduction method for simultaneous multislice magnetic resonance imaging.

This study proposes a modified Shinnar-Le Roux method to synthesize the excitation radio frequency (RF) pulse for a 2D gradient echo (GRE) based simultaneous multi-slice (SMS) magnetic resonance imaging (MRI) with features of low specific absorption rate (SAR) and small out-of-slice ripple. This synthesis method for SMS RF pulses employs thinner slice bandwidth and lower multislice offset frequencies to reduce SAR values and adopts a weighted Parks-McClellan algorithm to reduce sidelobes. Formulas for estimating relative SAR values of the SMS pulses are also introduced. Relative SAR values and out-of-slice ripples of the proposed and typical RF pulses with different parameters are presented. In simultaneous 5-slice phantom and 3-slice human brain imaging, SMS pulses synthesized with the proposed method achieve 32% and 28% SAR values of standard pulses while providing similar image qualities. Typical RF pulses such as sinc x cos can also take advantage of the proposed method and offer lower SAR values for SMS imaging. The RF pulse synthesized using the proposed method features low SAR, small sidelobes, and consistent image quality for 2D GRE-based SMS MRI. This method is applicable to the synthesis of typical SMS RF pulses for significant SAR reduction.