Consumption of aspartame and other artificial sweeteners and risk of cancer in the Spanish multicase-control study (MCC-Spain).

Use of artificial sweeteners (AS) such as aspartame, cyclamate, saccharin and sucralose is widespread. We evaluated the association of use of aspartame and other AS with cancer. In total 1881 colorectal, 1510 breast, 972 prostate and 351 stomach cancer and 109 chronic lymphocytic leukaemia (CLL) cases and 3629 population controls from the Spanish Multicase-Control (MCC-Spain) study were recruited (2008-2013). The consumption of AS, from table-top sweeteners and artificially sweetened beverages, was assessed through a self-administered and validated food frequency questionnaire (FFQ). Sex-specific quartiles among controls were determined to compare moderate consumers (

Occupational exposure to pesticides and endometrial cancer in the Screenwide case-control study.

BACKGROUND: Endometrial cancer is the most common gynaecological tumour in developed countries and disease burden is expected to increase over the years. Identifying modifiable risk factors may help developing strategies to reduce the expected increasing incidence of these neoplasms. OBJECTIVE: This study evaluates the association between occupational exposure to pesticides and endometrial cancer using data from a recent case-control study in Spain. METHODS: The analyses included data from 174 consecutive incident endometrial cancer cases and 216 hospital controls frequency-matched by age. Data were collected through structured epidemiological questionnaires and exposure to pesticides was assessed using a Spanish job-exposure matrix (MatEmESp). RESULTS: Overall, 12% of controls and 18% of cases were occupationally exposed to pesticides. We observed a positive association between occupational exposure to pesticides and endometrial cancer (OR = 2.08; 95% CI = 1.13-3.88 compared to non-exposed). In general, exposures that occurred farther in the past were significantly associated with endometrial cancer. Exposure to insecticides, fungicides and herbicides were positively associated with endometrial cancer (OR = 2.08; 95% CI = 1.13-3.88, OR = 4.40; 95% CI = 1.65-13.33, and OR = 5.25; 95% CI = 1.84-17.67, respectively). The agricultural, poultry and livestock activities scenario was associated with endometrial cancer (OR = 4.16; 95% CI = 1.59-12.32), while the cleaning exposure scenario was not (OR = 1.22; 95% CI = 0.55-2.67). CONCLUSIONS: Assessment of occupational exposure to pesticides assessed using a Spanish job-exposure matrix revealed a positive association with endometrial cancer. The elucidation of the role of pesticide compounds on endometrial cancer should shed a light on the aetiology of this tumour.

Risk of prostate cancer in the proximity of industrial installations: A multicase-control study in Spain (MCC-Spain).

BACKGROUND: Prostate cancer (PC) is the second most frequent tumor in men worldwide; however, its etiology remains largely unknown, with the exception of age and family history. The wide variability in incidence/mortality across countries suggests a certain role for environmental exposures that has not yet been clarified. OBJECTIVE: To evaluate the association between risk of PC (by clinical profile) and residential proximity to pollutant industrial installations (by industrial groups, groups of carcinogens, and specific pollutants released), within the context of a Spanish population-based multicase-control study of incident cancer (MCC-Spain). METHODS: This study included 1186 controls and 234 PC cases, frequency matched by age and province of residence. Distances from participants' residences to the 58 industries located in the study area were calculated and categorized into "near" (considering different limits between ≤1 km and ≤ 3 km) or "far" (>3 km). Odds ratios (ORs) and 95 % confidence intervals (95%CIs) were estimated using mixed and multinomial logistic regression models, adjusted for potential confounders and matching variables. RESULTS: No excess risk was detected near the overall industries, with ORs ranging from 0.66 (≤2 km) to 1.11 (≤1 km). However, positive associations (OR; 95%CI) were found, by industrial group, near (≤3 km) industries of ceramic (2.54; 1.28-5.07), food/beverage (2.18; 1.32-3.62), and disposal/recycling of animal waste (2.67; 1.12-6.37); and, by specific pollutant, near plants releasing fluorine (4.65; 1.45-14.91 at ≤1.5 km) and chlorine (5.21; 1.56-17.35 at ≤1 km). In contrast, inverse associations were detected near industries releasing ammonia, methane, dioxins+furans, polycyclic aromatic hydrocarbons, trichloroethylene, and vanadium to air. CONCLUSIONS: The results suggest no association between risk of PC and proximity to the overall industrial installations. However, some both positive and inverse associations were detected near certain industrial groups and industries emitting specific pollutants.

Eco-Friendly Pavements Manufactured from Mixed Recycled Aggregates Obtained from Construction and Demolition Waste: An Industrial-Scale Validation.

This study aimed to validate that laboratory-scale results could be commercially replicated when manufacturing marketable precast concrete. Construction and demolition waste (CDW) was separated into two (fine and coarse) recycled aggregates (RAs). Precast paver and kerb units were fabricated by partial or total substitution of natural aggregates (NAs) by RAs. The study involved the comprehensive characterisation of raw materials, including particle size distribution, mineral composition, and elemental composition. Paver blocks and kerbs manufactured with up to 50% RAs showed mechanical resistance (T = 3.7 ± 0.2 and B = 5.3 ± 0.6 MPa, respectively), water absorption between 5.3-5.7%, and abrasion resistance (approximately 20.2 mm), which met the standard requirements (UNE-EN 1340:2004 and UNE-EN 1338:2004). Furthermore, industrial-scale precast pavement units demonstrated strength and durability suitable for heavy traffic areas. A reduction of 13% in cement content could maintain the requirements with a partial RA substitution of 25%, offering economic and environmental benefits. Therefore, it is feasible at an industrial level to replace NAs with RAs, promoting durability and technological properties with a positive environmental impact and considerably reducing CO2 emissions by up to 65%. Overall, pavers with RAs manufactured at the laboratory scale met mechanical standards, and the kerb stones showed improvements in abrasion resistance. On an industrial scale, kerb stones and precast blocks with specific substitutions can meet strength, water absorption, and abrasion requirements, allowing a reduction in cement content.

Construction and demolition waste as recycled aggregate for environmentally friendly concrete paving.

Recycled aggregates (RA) from construction and demolition waste (CDW) instead of natural aggregates (NA) were analysed in the manufacture of new eco-friendly concrete. Fine (FRA) and coarse (CRA) recycled aggregates were used in different percentages as substitutes of natural sand and gravel, respectively. The results revealed that the use of RA in percentages of up to 50 wt.% is feasible. Additionally, RA were used to produce paving blocks in accordance with industrial requirements. Thus, values of water absorption lesser than 6.0% and tensile strength upper than 3.6 MPa were obtained, which are similar to those of a reference sample and within the limit values established by the regulations. These results were achieved by reducing the incorporation of cement, thereby saving production costs and minimizing environmental impact.

Residence in an Area with Environmental Exposure to Heavy Metals and Neurobehavioral Performance in Children 9-11 Years Old: An Explorative Study.

We explored the association between residence in an area polluted with metals and neurobehavioral performance in children aged 9 to 11. A cross-sectional study was conducted with thirty boys and thirty girls aged 9 to 11 from public schools in a heavily industrialized area, matched by age (±4 months) and gender with 15 boys and 15 girls from public schools in cities without relevant industrial activity. Neurobehavioral performance was assessed with the Behavioral Assessment and Research System. Linear regression models were used, adjusting for age, sex, social class and multimedia activities to predict each of the neurobehavioral outcome variables. No differences in neurobehavioral performance were found when all children with residence in areas with environmental exposure to metals were classified as exposed and the children from the other provinces as unexposed. However, when we compared children living <1 km from an industrial area with respect to those living more than 1 km away, significant differences were found. Children living <1 km away had lower scores on Finger Tapping (p = 0.03), Symbol-Digit (p = 0.07) and Continuous Performance (p = 0.02) than those living farther away. Our results support the hypothesis that residing close to an area with industrial activity (<1 km) is associated with deficits in neurobehavioral performance among children aged 9 to 11.

Recycled Aggregates from Construction and Demolition Waste in the Manufacture of Urban Pavements.

Construction and Demolition Waste (CDW) is among the largest waste streams in the world. Therefore, within the Circular Economy concept, there is a growing interest in its reuse. The purpose of this work was to study the use of recycled aggregates (RAs) obtained by a specific separation method from CDW, replacing natural aggregates (NAs) in the manufacture of precast concrete elements, such as kerbstones and paver blocks. The physical and technological properties of precast products formulated with RAs were analysed in accordance with current regulations, comparing them with those of commercial products manufactured with NAs. The results indicated that partial or total substitution of NAs by RAs increased the water absorption and apparent porosity values of the precast elements while reducing the bulk density and compressive strength. However, all units manufactured with RAs showed breaking load values higher than the minimum required by EN 1338 and, in some cases, slightly higher average tensile strength values than the reference material. In addition, some of the compositions including RAs gave rise to pieces that, according to their flexural strength, were classified as class 1 and marked S in accordance with EN 1340. According to abrasion resistance, in most cases, the precast elements are classified as Class 4 and I (≤20 mm). Finally, precast concrete produced from RAs satisfies the tolerance requirements for classification as class 3 (≤1.5 kg m-2). Therefore, it could be suitable for use in high pedestrian or traffic areas.