External gas-assisted mold temperature control and optimization molding parameters for improving weld line strength in polyamide plastics.

In this study, we present a novel approach to injection molding, focusing on the strength of weld lines in polyamide 6 (PA6) composite samples. By implementing a mold temperature significantly higher than the typical molding practice, which rarely exceeds 100°C, we assess the effects of advanced mold temperature management. The research introduces a newly engineered mold structure specifically designed for localized mold heating, distinguishing it as the 'novel cavity.' This innovative design is compared against traditional molding methods to highlight the improvements in weld line strength at elevated mold temperatures. To optimize the molding parameters, we apply an Artificial Neural Network (ANN) in conjunction with a Genetic Algorithm (GA). Our findings reveal that the optimal ultimate tensile strength (UTS) and elongation values are achieved with a filling time of 3.4 seconds, packing time of 0.8 seconds, melt temperature of 246°C, and a novel high mold temperature of 173°C. A specific sample demonstrated the best molding parameters at a filling time of 3.4 seconds, packing time of 0.4 seconds, melt temperature of 244°C, and mold temperature of 173°C, resulting in an elongation value of 582.6% and a UTS of 62.3 MPa. The most influential factor on the PA6 sample's UTS and elongation at the weld line was found to be the melt temperature, while the filling time had the least impact. SEM analysis of the fracture surfaces revealed ductile fractures with rough surfaces and grooves, indicative of the weld line areas' bonding quality. These insights pave the way for significant improvements in injection molding conditions, potentially revolutionizing the manufacturing process by enhancing the structural integrity of the weld lines in molded PA6 samples.

Optimizing the Tensile Strength of Weld Lines in Glass Fiber Composite Injection Molding.

Weld line defects, commonly occurring during the plastic product manufacturing process, are caused by the merging of two opposing streams of molten plastic. The presence of weld lines harms the product's aesthetic appeal and durability. This study uses artificial neural networks to forecast the ultimate tensile strength of a PA6 composite incorporating 30% glass fibers (GFs). Data were collected from tensile strength tests and the technical parameters of injection molding. The packing pressure factor is the one that significantly affects the tensile strength value. The melt temperature has a significant impact on the product's strength as well. In contrast, the filling time factor has less impact than other factors. According to the scanning electron microscope result, the smooth fracture surface indicates the weld line area's high brittleness. Fiber bridging across the weld line area is evident in numerous fractured GF pieces on the fracture surface, which enhances this area. Tensile strength values vary based on the injection parameters, from 65.51 MPa to 73.19 MPa. In addition, the experimental data comprise the outcomes of the artificial neural networks (ANNs), with the maximum relative variation being only 4.63%. The results could improve the PA6 reinforced with 30% GF injection molding procedure with weld lines. In further research, mold temperature improvement should be considered an exemplary method for enhancing the weld line strength.