ABSTRACT
Sodium-ion batteries (SIBs) as one of the promising alternatives to lithium-ion batteries have achieved remarkable progress in the past. However, the all-climate performance is still very challenging for SIBs. Herein, 15-Crown-5 (15-C-5) is screened as an electrolyte additive from a number of ether molecules theoretically. The good sodiophilicity, high molecule rigidity, and bulky size enable it to reshape the solvation sheath and promote the anion engagement in the solvated structures by molecule crowding. This change also enhances Na-ion transfer, inhibits side reactions, and leads to a thin and robust solid-electrolyte interphase. Furthermore, the electrochemical stability and operating temperature windows of the electrolyte are extended. These profits improve the electrochemical performance of SIBs in all climates, much better than the case without 15-C-5. This improvement is also adopted to µ-Sn, µ-Bi, hard carbon, and MoS2. This work opens a door to prioritize the potential molecules in theory for advanced electrolytes.
ABSTRACT
Throughout the nuclear power production process, the disposal of radioactive waste has consistently raised concerns about environmental safety. When the metal tanks used for waste disposal are corroded, radionuclides seep into the groundwater environment and eventually into the biosphere, causing significant damage to the environment. Hence, investigating the adsorption behavior of radionuclides on the corrosion products of metal tanks used for waste disposal is an essential component of safety and evaluation protocols at disposal sites. In order to understand the adsorption behavior of important radionuclides 60Co, 59Ni, 90Sr, 135Cs and 129I on α-FeOOH, the influences of different pH values, contact time, temperature and ion concentration on the adsorption rate were studied. The adsorption mechanism was also discussed. It was revealed that the adsorption of key nuclides onto α-FeOOH is significantly influenced by both pH and temperature. This change in surface charge corresponds to alterations in the morphology of nuclide ions within the system, subsequently impacting the adsorption efficiency. Sodium ions (Na+) and chlorate ions (ClO3-) compete for coordination with nuclide ions, thereby exerting an additional influence on the adsorption process. The XPS analysis results demonstrate the formation of an internal coordination bond (Ni-O bond) between Ni2+ and iron oxide, which is adsorbed onto α-FeOOH.
ABSTRACT
UNLABELLED: Over the past decades in China, the number of medical waste incinerators (MWIs) has been rising rapidly, causing emissions of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). In this study, samples of fly ash, ash deposits, and bottom ash from typical MWIs were analyzed for PCDD/Fs and their distribution characteristics. Results showed international toxic equivalent (I-TEQ) values in the range of 6.9-67 ng I-TEQ/g in fly ash and ash deposits, whereas the concentration in bottom ash was extremely low (only 1.33 pg I-TEQ/g), yet the generation of PCDD/Fs was mostly de novo synthesis in fly ash and ash deposits according to the ratio of PCDFs to PCDDs; the major distribution differences of PCDD/Fs in fly ash was manifested by the content of toxic furan 2,3,7,8-TCDF but other toxic PCDD/Fs showed similar distribution. Other findings are that 2,3,4,7,8-PeCDF had the most contribution to TEQ concentration, and that the most abundant toxic furan congener is 1,2,3,4,6,7,8-HpCDF. Correlation analysis showed that there was no significant correlation between PCDD/Fs concentration and several other physical and chemical parameters. IMPLICATIONS: This paper is of interest because it presents the emission performances of PCDD/Fs in ash from medical waste incineration in China. PCDD/F contents in fly ash and ash deposits vary between 6.9 and 67.3 ng I-TEQ/g. However, the concentration in bottom ash was extremely low (only 1.33 x 10(-3) ng I-TEQ/g). The fingerprints of PCDD/Fs in fly ash are almost similar, except for 2,3,7,8-TCDF. There is no marked correlation between PCDD/Fs and other physicochemical properties.
Subject(s)
Benzofurans/analysis , Incineration , Medical Waste Disposal , Particulate Matter/analysis , Polychlorinated Dibenzodioxins/analogs & derivatives , China , Coal Ash/analysis , Dibenzofurans, Polychlorinated , Factor Analysis, Statistical , Medical Waste/analysis , Polychlorinated Dibenzodioxins/analysisABSTRACT
Phytoextraction has become one of the most promising remediation techniques for heavy metal (HM) contaminated soils. However, the technique invariably produces large amounts of HM-enriched hyperaccumulators, which need further safe disposal. In this study, two different thermal treatment methods are investigated as potential options for evaporative separation of HMs from the residues. A horizontal tube furnace and a vertical entrained flow tube furnace were used for testing the disposal of grounded hyperaccumulators. The release characteristics of HMs (Cd, Cu, Pb, and Zn) into flue gas and residues were investigated for thermal treatment of the Cd and Zn hyperaccumulators Sedum plumbizincicola and Sedum alfredii. In a horizontal tube furnace, incineration favors the volatilization of Cu and Cd in contrast to pyrolysis. The percentages of HMs in residues after incineration are lower than those after pyrolysis, especially for Cd, Pb, and Zn. However, in an entrained flow tube furnace, Zn content in flue gas increases with increasing temperature, but Cu and Cd contents are fluctuated. In addition, a higher incineration temperature enhances the Cu content in residues.
Subject(s)
Gases/analysis , Incineration , Metals, Heavy/analysis , Sedum/metabolism , Biodegradation, Environmental , Hot Temperature , Metals, Heavy/metabolismABSTRACT
The distribution of polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDD/Fs), in brief dioxins, has seldom been addressed systematically in fly ash from municipal solid waste incinerators (MSWIs). This study shows the amount and fingerprint of PCDD/Fs in fly ash from four different Chinese MSWIs, that is, three mechanical grate units and one circulating fluidized bed unit. In these fly ash samples, dioxins-related parameters (international toxic equivalent quantity, total amount of PCDD/Fs, individual isomer classes, and 17 toxic 2,3,7,8-substituted congeners) all tend to increase with decreasing particle size for mechanical grate incinerators, yet only for the finest fraction for fluidized bed units. Moreover, the fluidized bed incinerator seems superior to grate incineration in controlling dioxins, yet a comparison is hampered by internal differences in the sample, for example, the fluidized bed fly ash has much lower carbon and chlorine contents. In addition, the presence of sulfur from mixing coal as supplemental fuel to the MSW may poison the catalytic steps in dioxins formation and thus suppress the formation of dioxins. With more residual carbon and chlorine in the fly ash, it is easier to form dioxins during cooling. Nevertheless, there is no apparent relation between Fe, Cu, and Zn contents and that of dioxins in fly ash.
Subject(s)
Air Pollutants/chemistry , Coal Ash/chemistry , Dioxins/chemistry , Incineration , China , Particle SizeABSTRACT
The heterogeneous reaction between formic acid and mineral dust play an important role in tropospheric chemistry. However, the molecular mechanism on formic acid uptake on mineral dust is not yet to be fully understood. In our work, a comprehensive and multiscale theoretical study (include density functional theory, DFT calculations and reactive molecular dynamics, RMD simulations) has been provided to investigate this heterogeneous reaction at molecular level. The results of DFT calculations show that the SiO2 and TiO2 particles have a strong tendency to adsorb formic acid to its surface, and the attractive part of the binding energy was dominated by electrostatic component. RMD simulations show that the uptake of formic acid and water on TiO2 particles would modified TiO2 particles, which formed Ti-OH and Ti-OCHO on particle surface. Besides, the formic acid coordination surface modes were dominated by the monodentate formate mode rather than bidentate formate mode. The molecular level study is helpful for understanding the accumulation of formic acid on mineral dust particles and global balance of atmospheric formic acid.
Subject(s)
Oxides , Silicon Dioxide , Formates , MineralsABSTRACT
Experiments were conducted to investigate and control pollutant emission from incineration of Sedum plumbizincicola plants on a laboratory scale using an entrained flow tube furnace. Without control technologies, the flue gas contained 0.101 mg Nm(-3) of Cd, 46.4 mg Nm(-3) of Zn, 553 mg Nm(-3) of NOx, 131 pg Nm(-3) of polychlorinated dibenzo-p-dioxin and polychlorinated dibenzofuran (PCDD/Fs) and 35.4 mg Nm(-3) of polycyclic aromatic hydrocarbons (PAHs). In pollutants control experiments. Al2O3, CaO, and kaolin were compared as adsorbents and activated carbon was used as an end-of-pipe method for the capture of pollutants. Kaolin, the most effective of the three adsorbents, removed 91.2% of the Cd in flue gas. While 97.6% of the Cd and 99.6% of the PAHs were removed by activated carbon. Incineration may therefore be regarded as a viable option for the safe disposal of the biomass of the zinc and cadmium hyperaccumulator species S. plumbizincicola.
Subject(s)
Air Pollution/prevention & control , Gases/chemistry , Incineration/instrumentation , Metals, Heavy/chemistry , Sedum/chemistry , Air Pollutants/chemistry , Aluminum Oxide/chemistry , Benzofurans/chemistry , Biodegradation, Environmental , Biomass , Cadmium/metabolism , Calcium Compounds/chemistry , Charcoal/chemistry , Coal Ash/chemistry , Dibenzofurans, Polychlorinated , Hot Temperature , Incineration/methods , Kaolin/chemistry , Metals, Heavy/metabolism , Nitrogen Oxides/chemistry , Oxides/chemistry , Polychlorinated Dibenzodioxins/analogs & derivatives , Polychlorinated Dibenzodioxins/chemistry , Polycyclic Aromatic Hydrocarbons/chemistry , Sedum/metabolism , Soil Pollutants/metabolism , Zinc/metabolismABSTRACT
In this study, the contamination of soil by PCDD/Fs and other dioxin-like chemicals in the vicinity of Municipal Solid Waste Incinerators (MSWIs) and Hazardous Waste Incinerators (HWIs) is estimated by the XDS-CALUX bioassay. The resulting CALUX-TEQ value is compared with the WHO-TEQ value obtained from HRGC/HRMS analysis, in order to validate the CALUX bioassay as suitable screening method for PCDD/Fs determination of soil samples. The results show that the CALUX-TEQ and the WHO-TEQ values are significantly correlated (R = 0.87). The WHO-TEQ and CALUX-TEQ of soil samples collected from four waste incineration plants in China were in the range from 1.72 to 31.4 pg-TEQ/g and 1.71 to 44.2 pg-TEQ/g respectively, with a mean value of 6.09 pg-TEQ/g and 11.0 pg-TEQ/g. Considering the homologue patterns, a principal component analysis (PCA) and a hierarchical cluster analysis (HCA) of the PCDD/Fs in the soil samples, the emissions of MSWIs and HWIs were probably not the only source of PCDD/Fs.