Root canal morphology of anterior permanent teeth in Jordanian population using two classification systems: a cone-beam computed tomography study.

BACKGROUND: Adequate knowledge of root canal morphology and its variation is essential for success of root canal treatment and to overcome treatemnt failure. The aim of this study was to investigate the root and canal morphology of mandibular anterior teeth using 2 classification systems. METHODS: 3342 lower anteriors were evaluated from 557 CBCT scans. The images were examined in sagittal, axial and coronal views using a CS 3D imaging software (V3.10.4, Carestream Dental). Demographic data recorded, the number of roots and canal's morphology were described according to Vertucci and Ahmed classifications. RESULTS: Frequency of Type I configuration was significantly the highest in incisors and canines (76%, N = 2539), followed by Type III (20.6%, N = 687). Type II (1.1%, N = 37), IV (1.1%, N = 37), and V (0.3%, N = 11) were rarely encountered. 0.9% (N = 31) of the teeth could not be classified with the Vertucci System. The frequency of 2 roots (2MA in Ahmed classification) which has no correspondence in the Vertucci classification, was 1.1% (N = 38), it was significantly higher in canines and in females (35 canines and 3 laterals). A moderate correlation in root canal morpology was found between the left and right sides (V > 0.30). 80% (N = 2538) of the teeth did not exhibit any divergence/merging. The bifurcation level occurred mostly in the middle third of the root. CONCLUSIONS: One fourth of anterior teeth had variation from the simple type I canal configuration and therefore requires attention during treatment. The new classification system offers a more accurate and simplified presentation of canal morphology. CLINICAL RELEVANCE: The prevalence and mid root bifurcation of second canal in lower anteriors requires attention to ensure adequate quality root canal treatment without compromising the integrity of teeth.

Attitude and practice of regenerative endodontic procedures among endodontists and paediatric dentists: A multinational survey from 13 countries.

BACKGROUND: Regenerative endodontics (RET) refers to biologically based procedures that aim to restore damaged tooth structures and reinstate the pulp-dentine complex to its normal physiological state. AIM: The purpose of this study was to examine the attitudes and practices of endodontists and paediatric dentists regarding RET. DESIGN: A survey was conducted among endodontists and paediatric dentists from 13 countries. A number of factors were evaluated, including frequency of RET application, followed guidelines, disinfection techniques, intracanal medication type, scaffold type, preferred coronal seal material, and follow-up period. RESULTS: Among the 1394 respondents, 853 (61.2%) and 541 (38.8%) were endodontists and paediatric dentists, respectively. Almost half (43%) of participants have not performed RET yet. The American Association of Endodontics guideline (47.3%) was selected as the primary source for the clinical protocol. The most frequently selected irrigant solution was 1.5%-3% NaOCl at the first (26.1%) and second (13.6%) sessions. A blood clot (68.7%) and MTA (61.9%) were the most frequently selected scaffold type and coronal barrier. Most participants preferred a 6-month follow-up period. CONCLUSION: According to this survey, deviations exist from current RET guidelines regarding all aspects evaluated. Standardizing clinical protocols and adhering to available guidelines would help to ensure more predictable outcomes.

Effectiveness of endodontic complexity assessment tool (E-CAT) on the undergraduate students in an endodontic training program and its predictive capability on complications.

INTRODUCTION: Dental students face a number of challenges when it comes to performing root canal treatments (RCTs). The Endodontic Complexity Assessment Tool (E-CAT) was developed to assist dental practitioners in assessing the complexity of RCTs before beginning treatment. MATERIALS AND METHODS: The E-CAT was filled out independently by both the educator and the student. To allow educators to record scores and complexity classes, they transferred their and students' forms to the website https://www.e-cat.uk/. Students began endodontic treatment after learning about the complexity level of the case. The educators were responsible for recording any complications encountered in every case from the outset to 1 month after treatment. RESULTS: A total of 70 students, 33 in fourth and 37 in fifth-grade, were included in the study. In the cases with higher E-CAT scores, complications such as misdiagnosed, faulty access cavity, furca or coronal third perforation, insufficient root canal instrumentation, working length loss, canal blockage, overpreparation, incomplete root canal filling and overfilling were experienced significantly more often compared to the cases with lower E-CAT scores (p < .05). The number of complications (r = .40, p < .001), treatment sessions (r = .44, p < .001), and teacher support (r = .24, p < .001) positively correlated with E-CAT score (p < .05). CONCLUSION: The E-CAT is an effective tool for assisting dental students in understanding technical challenges, such as complex root canal anatomy and possible complications during treatment. Educators can also use e-CAT to pre-select clinical cases and standardise student training by offering cases of equal complexity.

Caries-related salivary parameters and oral microbial flora in patients with type 1 diabetes: A meta-analysis.

OBJECTIVES: This study aimed to conduct a meta-analysis by synthesising the outcomes of studies that investigated the relationship between type 1 diabetes (T1D) and salivary flow rate (SFR), salivary pH (SpH), salivary buffer capacity (SBC), streptococcus Mutans (SM), and lactobacillus (LB) counts. MATERIAL AND METHODS: The PRISMA statement guide was followed for the meta-analysis. Electronic databases were searched, and study selection and data collection processes were performed. The risks of bias in individual studies and across studies were assessed. Mean differences (MD) and Odds Ratio (OR) were used to measure the effect estimates in the comparisons. RESULTS: 29 studies were included in the qualitative and quantitative syntheses. Significantly higher SFR (MD = -0.22, CI: -0.26, -0.18; p < 0.001) and SpH (MD = -0.59, CI: -0.81, -0.36; p < 0.001) were observed in the healthy individuals than T1D individuals. No significant difference was observed among groups in terms of SBC (MD = 0.10, CI: -0.46,0.66; p = 0.73). An increased odds ratio of SM counts were observed regarding the T1D (OR = 3.09, 95% CI: 1.16, 8.20; p = 0.02). No association was found between LB counts and T1D (OR = 2.15, 95% CI: 0.38, 11.98; p = 0.38). CONCLUSIONS: Subjects with T1D have a significantly lesser SFR and SpH than healthy individuals. But no significant difference is available in terms of SBC. Lower SM counts were observed in individuals with T1D, while no association was observed regarding LB counts. The tendency to dental caries is more likely in subjects with T1D due to lower SFR, SpH, and higher SM.

Comparison of mandibular morphometric parameters in digital panoramic radiography in gender determination using machine learning.

OBJECTIVE: This study aimed to evaluate the usability of morphometric features obtained from mandibular panoramic radiographs in gender determination using machine learning algorithms. MATERIALS AND METHODS: High-resolution radiographs of 200 patients aged 20-77 (41.0 ± 12.7) were included in the study. Twelve different morphometric measurements were extracted from each digital panoramic radiography included in the study. These measurements were used as features in the machine learning phase in which six different machine learning algorithms were used (k-nearest neighbor, decision trees, support vector machines, naive Bayes, linear discrimination analysis, and neural networks). To evaluate the reliability, we have performed tenfold cross-validation and we repeated this 10 times for every classification process. This process enhances the reliability of the results for other datasets. RESULTS: When all 12 features are used together, the accuracy rate is found to be 82.6 ± 0.5%. The classification accuracies are also compared using each feature alone. Three features that give the highest accuracy are coronoid height (80.9 ± 0.9%), condyle height (78.2 ± 0.5%), and ramus height (77.2 ± 0.4%), respectively. When compared to the classification algorithms, the highest accuracy was obtained with the naive Bayes algorithm with a rate of 84.0 ± 0.4%. CONCLUSION: Machine learning techniques can accurately determine gender by analyzing mandibular morphometric structures from digital panoramic radiographs. The most precise results are achieved by evaluating the structures in combination, using attributes obtained from applying the MRMR algorithm to all features.

Repair versus replacement of defective direct dental restorations: A multinational cross-sectional study with meta-analysis.

OBJECTIVES: When dental practitioners encounter a defective restoration, they are faced with a crucial decision whether to repair or replace it. This study aims to explore international preferences for repair procedures and the clinical steps taken during the repair process. METHOD: An 11-question survey was distributed to dentists across 21 countries via different platforms. The survey comprised two sections: the first included five questions aimed at gathering demographic information, while the second consisted of six questions focusing on participants' practices related to the repair of composite or amalgam restorations A meta-analysis was employed to ascertain the pooled odds ratio of repairing versus replacement. The statistical analysis was carried out using the RevMan 5.3 program and forest plots were generated using the same program to visualize the results. RESULTS: The survey was completed by 3680 dental practitioners. The results indicated a strong tendency to repair defective composite restorations (OR: 14.23; 95 % CI: 7.40, 27.35, p < 0.001). In terms of amalgam, there was a significant tendency to replace the restorations (OR: 0.19; 95 % CI: 0.12, 0.30, p < 0.001). When repairing restorations, the most common protocols were etching with orthophosphoric acid and creating an enamel bevel, regardless of the restorative material used. CONCLUSION: The findings of this study indicate that there exists a knowledge gap among dental practitioners regarding restoration repair. It is imperative that dental practitioners receive proper education and training on restoration repair, to ensure the usage of adequate protocols and restoration survival. CLINICAL SIGNIFICANCE: A significant portion of dental practitioners lack the necessary knowledge and education required for the repair of restorations. Therefore, it is imperative to establish guidelines aimed at enhancing the management of defective restorations, along with protocols for clinical interventions. This includes the incorporation of proper courses in undergraduate, graduate, and continuing education programs.

Prediction of root canal lengths and pulp volume of the maxillary permanent first molar based on stature, crown diameters, and facial morphometry.

This study purposed to develop statistical models to predict palatal (PRL), mesial (MRL), and distal (DRL) root canal length and pulp volume (PV) of the maxillary first permanent molar using stature, gender, mesiodistal (MD), and buccopalatal (BP) crown diameters and some facial morphometries. 57 individuals were included in the study. Cone beam computed tomography was used to measure root canal lengths and PV. The PV calculation was carried out using the software ITK-SNAP 3.4.0. PRL was positively correlated with BP, stature, middle facial height, interalar distance, and bicommissural distance (BCD) (p < 0.05). DRL was positively correlated with BP, MD, and stature (p < 0.05). MRL was positively correlated with BP, MD, stature, lower face height, bizygomatic distance, and BCD (p < 0.05). PV was negatively correlated with age and BCD (p < 0.05). Although all models have significant predictive power for the root lengths and PV, no model could explain variances greater than 30%. The highest and lowest predictive ability was obtained for PRL and DRL, respectively. While the most significant predictor was BP for PRL and DRL, it was the age for PV.

Factors Affecting the Decision-making of Direct Pulp Capping Procedures among Dental Practitioners: A Multinational Survey from 16 Countries with Meta-analysis.

INTRODUCTION: Direct pulp capping (DPC) procedures require the placement of a bioactive material over an exposure site without selective pulp tissue removal. This web-based multicentered survey had 3 purposes: (1) to investigate the factors that affect clinicians' decisions in DPC cases, (2) to determine which method of caries removal is preferred, and (3) to evaluate the preferred capping material for DPC. METHODS: The questionnaire comprised 3 sections. The first part comprised questions regarding demographic features. The second part comprised questions on how treatment plans change according to factors such as nature, location, number and size of the pulp exposure, and patients' age. The third part composed of questions on the common materials and techniques used in DPC. To estimate the effect size, the risk ratio (RR) and 95% confidence interval (CI) were calculated using a meta-analysis software. RESULTS: A tendency toward more invasive treatment was observed for the clinical scenario with carious-exposed pulp (RR = 2.86, 95% CI: 2.46, 2.32; P < .001) as opposed to the clinical scenario with 2 pulp exposures (RR = 1.38, 95% CI: 1.24, 1.53; P < .001). Complete caries removal was significantly preferred to selective caries removal (RR = 4.59, 95% CI: 3.70, 5.69; P < .001). Among the capping materials, calcium silicate-based materials were preferred over calcium hydroxide-based materials (RR = 0.58, 95% CI: 0.44, 0.76; P < .05). CONCLUSIONS: While carious-exposed pulp is the most important factor in clinical decisions regarding DPC, the number of exposures has the least impact. Overall, complete caries removal was preferred over selective caries removal. In addition, the use of calcium silicate-based materials appears to have replaced calcium hydroxide-based materials.

Assessment of the Prevalence of Radix Entomolaris and Distolingual Canal in Mandibular First Molars in 15 Countries: A Multinational Cross-sectional Study with Meta-analysis.

AIM: The aim of this study was two-folded: i) to assess the prevalence of Distolingual Canal (DLC) and Radix Entomolaris (RE) in Mandibular First Molars (M1Ms), using Cone Beam Computed Tomography (CBCT) images and ii) to assess the impact of sociodemographic factors on the prevalence of these conditions worldwide. METHODS: CBCT images were scanned retrospectively and the ones including bilateral M1Ms were included in the study. The evaluation was performed by 1 researcher in each country, trained with CBCT technology. A written and video instruction program explaining the protocol to be followed step-by-step was provided to all observers to calibrate them. The CBCT imaging screening procedure consisted of evaluating axial sections from coronal to apical. The presence of DLC and RE in M1Ms (yes/no) was identified and recorded. RESULTS: Six thousand three hundred four CBCTs, representing 12,608 M1Ms, were evaluated. A significant difference was found between countries regarding the prevalence of both RE and DLC (P < .05). The prevalence of DLC ranged from 3% to 50%, and the overall prevalence was 22% (95% CI: 15%-29%). RE prevalence ranged from 0% to 12%, and the overall prevalence was 3% (95% CI: 2%-5%). There were no significant differences between left and right M1Ms or between genders for either DLC or RE (P > .05). CONCLUSION: The overall prevalence of RE and DLC in M1Ms was 3% and 22%. Additionally, both RE and DLC showed substantial bilaterally. These variations should be considered by endodontic clinicians during endodontic procedures in order to avoid potential complications.