ABSTRACT
With the scaling of lateral dimensions in advanced transistors, an increased gate capacitance is desirable both to retain the control of the gate electrode over the channel and to reduce the operating voltage1. This led to a fundamental change in the gate stack in 2008, the incorporation of high-dielectric-constant HfO2 (ref. 2), which remains the material of choice to date. Here we report HfO2-ZrO2 superlattice heterostructures as a gate stack, stabilized with mixed ferroelectric-antiferroelectric order, directly integrated onto Si transistors, and scaled down to approximately 20 ångströms, the same gate oxide thickness required for high-performance transistors. The overall equivalent oxide thickness in metal-oxide-semiconductor capacitors is equivalent to an effective SiO2 thickness of approximately 6.5 ångströms. Such a low effective oxide thickness and the resulting large capacitance cannot be achieved in conventional HfO2-based high-dielectric-constant gate stacks without scavenging the interfacial SiO2, which has adverse effects on the electron transport and gate leakage current3. Accordingly, our gate stacks, which do not require such scavenging, provide substantially lower leakage current and no mobility degradation. This work demonstrates that ultrathin ferroic HfO2-ZrO2 multilayers, stabilized with competing ferroelectric-antiferroelectric order in the two-nanometre-thickness regime, provide a path towards advanced gate oxide stacks in electronic devices beyond conventional HfO2-based high-dielectric-constant materials.
ABSTRACT
An amendment to this paper has been published and can be accessed via a link at the top of the paper.
ABSTRACT
Ultrathin ferroelectric materials could potentially enable low-power perovskite ferroelectric tetragonality logic and nonvolatile memories1,2. As ferroelectric materials are made thinner, however, the ferroelectricity is usually suppressed. Size effects in ferroelectrics have been thoroughly investigated in perovskite oxides-the archetypal ferroelectric system3. Perovskites, however, have so far proved unsuitable for thickness scaling and integration with modern semiconductor processes4. Here we report ferroelectricity in ultrathin doped hafnium oxide (HfO2), a fluorite-structure oxide grown by atomic layer deposition on silicon. We demonstrate the persistence of inversion symmetry breaking and spontaneous, switchable polarization down to a thickness of one nanometre. Our results indicate not only the absence of a ferroelectric critical thickness but also enhanced polar distortions as film thickness is reduced, unlike in perovskite ferroelectrics. This approach to enhancing ferroelectricity in ultrathin layers could provide a route towards polarization-driven memories and ferroelectric-based advanced transistors. This work shifts the search for the fundamental limits of ferroelectricity to simpler transition-metal oxide systems-that is, from perovskite-derived complex oxides to fluorite-structure binary oxides-in which 'reverse' size effects counterintuitively stabilize polar symmetry in the ultrathin regime.
ABSTRACT
Negative capacitance is a newly discovered state of ferroelectric materials that holds promise for electronics applications by exploiting a region of thermodynamic space that is normally not accessible1-14. Although existing reports of negative capacitance substantiate the importance of this phenomenon, they have focused on its macroscale manifestation. These manifestations demonstrate possible uses of steady-state negative capacitance-for example, enhancing the capacitance of a ferroelectric-dielectric heterostructure4,7,14 or improving the subthreshold swing of a transistor8-12. Yet they constitute only indirect measurements of the local state of negative capacitance in which the ferroelectric resides. Spatial mapping of this phenomenon would help its understanding at a microscopic scale and also help to achieve optimal design of devices with potential technological applications. Here we demonstrate a direct measurement of steady-state negative capacitance in a ferroelectric-dielectric heterostructure. We use electron microscopy complemented by phase-field and first-principles-based (second-principles) simulations in SrTiO3/PbTiO3 superlattices to directly determine, with atomic resolution, the local regions in the ferroelectric material where a state of negative capacitance is stabilized. Simultaneous vector mapping of atomic displacements (related to a complex pattern in the polarization field), in conjunction with reconstruction of the local electric field, identify the negative capacitance regions as those with higher energy density and larger polarizability: the domain walls where the polarization is suppressed.
ABSTRACT
In this Letter, the first name of author Bhagwati Prasad was misspelled Bhagawati. This error has been corrected online.
ABSTRACT
Ferroelectric tunnel junction (FTJ) has been considered as a promising candidate for next-generation memory devices due to its non-destructive and low power operations. In this article, we demonstrate the interlayer (IL) engineering in the FTJs to boost device performances. Through the analysis on the material and electrical characteristics of the fabricated FTJs with engineered IL stacks, it is clearly found that the insertion of an Al2O3layer between the SiO2insulator and the pure-HfOxFE improves the read disturbance (2Vc = 2.2 V increased), the endurance characteristics (tenfold improvement), and the cell-to-cell TER variation simultaneously without the degradation of the ferroelectricity (less than 5%) and the polarization switching speeds through grain size modulation. Based on these investigations, the guidelines of IL engineering for low power ferroelectric devices were provided to obtain stable and fast memory operations.
ABSTRACT
As the computing paradigm has shifted toward edge computing, improving the security of edge devices is attracting significant attention. However, because edge devices have limited resources in terms of power and area, it is difficult to apply a conventional cryptography system to protect them. On the other hand, as a simple security application, a physical unclonable function (PUF) can be implemented without power and area problems because it provides a security key by utilizing process variations without additional external circuits. Ferroelectric tunnel junctions (FTJs) are 2-terminal devices that store information by changing the resistance of a ferroelectric material, where the resistance is determined by the polarization states of the ferroelectric domains. Because polycrystalline ferroelectric materials have a multi-domain nature, domain variation can also be used as a randomness source to induce cell-to-cell variations along with process variations. In this paper, we demonstrate PUF operations of a low-power, small area 16 × 16 hafnium oxide (pure-HfOx)-based FTJ array using certain metrics. It is clear that the proposed array consisting of scaled FTJs has adequate randomness for security applications such that the array-level PUF operations are robust against model-based machine learning attacks.
ABSTRACT
We experimentally demonstrate the concept of combination-encoding content-addressable memory (CECAM) that offers much higher content density than any other content-addressable memory devices proposed to date. In this work, CECAM was fabricated and validated with a hafnium-zirconium oxide (HZO) ferroelectric tunnel junction (FTJ) crossbar array. The new CAM structure, which utilizes nonvolatile memory devices, offers numerous advantages including low-current operation (FTJ), standby power reduction (ferroelectric HZO), and increased content density. Multibit data are encoded and stored in multi-switch CECAM. Perfect-match searching in CECAM with a reasonable match current (lower than nA) for different sizes of CECAM has been validated from a novel CAM device. We demonstrate N-CECAM (with keys encoded into 2N-long binary arrays) for N = 3 (using 6 FTJs) and 4 (using 8 FTJs), leading to content densities of 0.667 and 0.75 bits per switch, which highlight 33% and 50% increase in content density compared to that of the conventional TCAM (0.5 bits per switch).
ABSTRACT
Hardware neuromorphic systems are crucial for the energy-efficient processing of massive amounts of data. Among various candidates, hafnium oxide ferroelectric tunnel junctions (FTJs) are highly promising for artificial synaptic devices. However, FTJs exhibit non-ideal characteristics that introduce variations in synaptic weights, presenting a considerable challenge in achieving high-performance neuromorphic systems. The primary objective of this study is to analyze the origin and impact of these variations in neuromorphic systems. The analysis reveals that the major bottleneck in achieving a high-performance neuromorphic system is the dynamic variation, primarily caused by the intrinsic 1/f noise of the device. As the device area is reduced and the read bias (VRead ) is lowered, the intrinsic noise of the FTJs increases, presenting an inherent limitation for implementing area- and power-efficient neuromorphic systems. To overcome this limitation, an adaptive read-biasing (ARB) scheme is proposed that applies a different VRead to each layer of the neuromorphic system. By exploiting the different noise sensitivities of each layer, the ARB method demonstrates significant power savings of 61.3% and a scaling effect of 91.9% compared with conventional biasing methods. These findings contribute significantly to the development of more accurate, efficient, and scalable neuromorphic systems.
ABSTRACT
PURPOSE: The posterior lumbar interbody fusion (PLIF) and transforaminal lumbar interbody fusion (TLIF) techniques are commonly used surgical methods for wide indications such as degeneration or trauma. Although they are rarely required for lumbar disk disease in younger patients, there are a few children and adolescents who are indicated for PLIF or TLIF for other reasons, such as congenital severe stenosis with or without lumbar instability that requires wide decompression or severe bony spur that need to be removed. In such cases, different pathophysiology and outcomes are expected compared with adult patients. METHODS: We retrospectively reviewed data of 23 patients who underwent PLIF or TLIF surgery when less than 20 years old. Clinical and radiographic outcomes were assessed during a mean of 36.4 months follow-up period. The indications of lumbar interbody fusion, success of fusion, complications, and visual analog scale (VAS) were analyzed. RESULTS: Radiographs of all patients taken 6 months after the surgery showed fusion. Clinical outcome was also satisfactory, with improvement of VAS score from 7.7 preoperatively to 2.3 at 6 months after surgery. Only one patient had reoperation due to adjacent segment disease. CONCLUSIONS: For adolescent patients with severe bony spur, massive central disk rupture, or severe spondylolisthesis, lumbar interbody fusion surgery has good surgical outcome with few complications.
Subject(s)
Decompression, Surgical/methods , Intervertebral Disc Degeneration/surgery , Intervertebral Disc Displacement/surgery , Spinal Fusion/methods , Adolescent , Child , Female , Humans , Intervertebral Disc Degeneration/pathology , Intervertebral Disc Displacement/pathology , Lumbar Vertebrae/diagnostic imaging , Lumbar Vertebrae/surgery , Magnetic Resonance Imaging , Male , Pain Measurement , Postoperative Complications , Retrospective Studies , Tomography, X-Ray Computed , Treatment Outcome , Young AdultABSTRACT
With the recently increasing prevalence of deep learning, both academia and industry exhibit substantial interest in neuromorphic computing, which mimics the functional and structural features of the human brain. To realize neuromorphic computing, an energy-efficient and reliable artificial synapse must be developed. In this study, the synaptic ferroelectric field-effect-transistor (FeFET) array is fabricated as a component of a neuromorphic convolutional neural network. Beyond the single transistor level, the long-term potentiation and depression of synaptic weights are achieved at the array level, and a successful program-inhibiting operation is demonstrated in the synaptic array, achieving a learning accuracy of 79.84% on the Canadian Institute for Advanced Research (CIFAR)-10 dataset. Furthermore, an efficient self-curing method is proposed to improve the endurance of the FeFET array by tenfold, utilizing the punch-through current inherent to the device. Low-frequency noise spectroscopy is employed to quantitatively evaluate the curing efficiency of the proposed self-curing method. The results of this study provide a method to fabricate and operate reliable synaptic FeFET arrays, thereby paving the way for further development of ferroelectric-based neuromorphic computing.
ABSTRACT
Recently, ferroelectric tunnel junctions (FTJs) have gained extensive attention as possible candidates for emerging memory and synaptic devices for neuromorphic computing. However, the working principles of FTJs remain controversial despite the importance of understanding them. In this study, we demonstrate a comprehensive and accurate analysis of the working principles of a metal-ferroelectric-dielectric-semiconductor stacked FTJ using low-frequency noise (LFN) spectroscopy. In contrast to resistive random access memory, the 1/f noise of the FTJ in the low-resistance state (LRS) is approximately two orders of magnitude larger than that in the high-resistance state (HRS), indicating that the conduction mechanism in each state differs significantly. Furthermore, the factors determining the conduction of the FTJ in each state are revealed through a systematic investigation under various conditions, such as varying the electrical bias, temperature, and bias stress. In addition, we propose an efficient method to decrease the LFN of the FTJ in both the LRS and HRS using high-pressure forming gas annealing.
ABSTRACT
Gaseous pollutants, including nitrogen oxides, pose a severe threat to ecosystems and human health; therefore, developing reliable gas-sensing systems to detect them is becoming increasingly important. Among the various options, metal-oxide-based gas sensors have attracted attention due to their capability for real-time monitoring and large response. In particular, in the field of materials science, there has been extensive research into controlling the morphological properties of metal oxides. However, these approaches have limitations in terms of controlling the response, sensitivity, and selectivity after the sensing material is deposited. In this study, we propose a novel method to improve the gas-sensing performance by utilizing the remnant polarization of ferroelectric thin-film transistor (FeTFT) gas sensors. The proposed FeTFT gas sensor has IGZO and HZO as the conducting channel and ferroelectric layer, respectively. It is demonstrated that the response and sensitivity of FeTFT gas sensors can be modulated by engineering the polarization of the ferroelectric layer. The amount of reaction sites in IGZO, including electrons and oxygen vacancy-induced negatively charged oxygen, is changed depending on upward and downward polarization. The results of this study provide an essential foundation for further development of gas sensors with tunable sensing properties.
Subject(s)
Ecosystem , Environmental Pollutants , Gases/analysis , Humans , Oxides , OxygenABSTRACT
The effects of the grain size of Pt bottom electrodes on the ferroelectricity of hafnium zirconium oxide (HZO) were studied in terms of the orthorhombic phase transformation. HZO thin films were deposited by chemical solution deposition on the Pt bottom electrodes with various grain sizes which had been deposited by direct current sputtering. All the samples were crystallized by rapid thermal annealing at 700 °C to allow a phase transformation. The crystallographic phases were determined by grazing incidence X-ray diffraction, which showed that the bottom electrode with smaller Pt grains resulted in a larger orthorhombic phase composition in the HZO film. As a result, capacitors with smaller Pt grains for the bottom electrode showed greater ferroelectric polarization. The smaller grains produced larger in-plane stress which led to more orthorhombic phase transformation and higher ferroelectric polarization.