Ru Single Atom Dispersed on MoS2/MXene for Enhanced Sulfur Reduction Reaction in Lithium-Sulfur Batteries.

The high theoretical energy density (2600 Wh kg-1) and low cost of lithium-sulfur batteries (LSBs) make them an ideal alternative for the next-generation energy storage system. Nevertheless, severe capacity degradation and low sulfur utilization resulting from shuttle effect hinder their commercialization. Herein, Single-atom Ru-doped 1T/2H MoS2 with enriched defects decorates V2C MXene (Ru-MoS2/MXene) produced by a new phase-engineering strategy employed as sulfur host to promote polysulfide adsorption and conversion reaction kinetics. The Ru single atom-doped adjusts the chemical environment of the MoS2/MXene to anchor polysulfide and acts as an efficient center to motivate the redox reaction. In addition, the rich defects of the MoS2 and ternary boundary among 1T/2H MoS2 and V2C accelerate the charge transfer and ion movements for the reaction. As expected, the Ru-MoS2/MXene/S cathode-based cell exhibits a high-rate capability of 684.3 mAh g-1 at 6 C. After 1000 cycles, the Ru-MoS2/MXene/S cell maintains an excellent cycling stability of 696 mAh g-1 at 2 C with a capacity degradation as low as 0.02% per cycle. Despite a high sulfur loading of 9.5 mg cm-2 and a lean electrolyte-to-sulfur ratio of 4.3, the cell achieves a high discharge capacity of 726 mAh g-1.

Triphasic Ni2P-Ni12P5-Ru with Amorphous Interface Engineering Promoted by Co Nano-Surface for Efficient Water Splitting.

This research designs a triphasic Ni2P-Ni12P5-Ru heterostructure with amorphous interface engineering strongly coupled by a cobalt nano-surface (Co@NimPn-Ru) to form a hierarchical 3D interconnected architecture. The Co@NimPn-Ru material promotes unique reactivities toward hydrogen evolution reaction (HER) and oxygen evolution reaction (OER) in alkaline media. The material delivers an overpotential of 30 mV for HER at 10 mA cm-2 and 320 mV for OER at 50 mA cm-2 in freshwater. The electrolyzer cell derived from Co@NimPn-Ru(+,-) requires a small cell voltage of only 1.43 V in alkaline freshwater or 1.44 V in natural seawater to produce 10 mA cm-2 at a working temperature of 80 °C, along with high performance retention after 76 h. The solar energy-powered electrolyzer system also shows a prospective solar-to-hydrogen conversion efficiency and sufficient durability, confirming its good potential for economic and sustainable hydrogen production. The results are ascribed to the synergistic effects by an exclusive combination of multi-phasic crystalline Ni2P, Ni12P5, and Ru clusters in presence of amorphous phosphate interface attached onto cobalt nano-surface, thereby producing rich exposed active sites with optimized free energy and multi open channels for rapid charge transfer and ion diffusion to promote the reaction kinetics.

Manganese-Doped Bimetallic (Co,Ni)2P Integrated CoP in N,S Co-Doped Carbon: Unveiling a Compatible Hybrid Electrocatalyst for Overall Water Splitting.

Rational design of highly efficient noble-metal-unbound electrodes for hydrogen and oxygen production at increased current density is crucial for robust water-splitting. A facile hydrothermal and room-temperature aging method is presented, followed by chemical vapor deposition (CVD), to create a self-sacrificed hybrid heterostructure electrocatalyst. This hybrid material, (Mn-(Co,Ni)2P/CoP/(N,S)-C), comprises manganese-doped cobalt nickel phosphide (Mn-(Co,Ni)2P) nanofeathers and cobalt phosphide (CoP) nanocubes embedded in a nitrogen and sulfur co-doped carbon matrix (N,S)-C on nickel foam. The catalyst exhibits excellent performance in both the hydrogen evolution reaction (HER; η10 = 61 mV) and oxygen evolution reaction (OER; η10 = 213 mV) due to abundant active sites, high porosity, and enhanced hetero-interface interaction between Mn-(Co2P-Ni2P) CoP, and (N,S)-C supported by significant synergistic effects observed among different phases through density functional theory (DFT) calculations. Impressively, (Mn-(Co,Ni)2P/CoP/(N,S)-C (+,-) shows an extra low cell voltage of 1.49 V@10 mA cm-2. Moreover, the catalyst exhibits remarkable stability at 100 and 300 mA cm-2 when operating as a single stack cell electrolyzer. The superior electrochemical activity is attributed to the enhanced electrode-electrolyte interface among the multiple phases of the hybrid structure.

A facile and scalable fabrication method of scrolled graphene/boron nitride-based van der Waals superlattice heterostructure materials for highly stable supercapacitor electrode application.

Due to the increasing demand for the development of efficient renewable energy supply systems to reduce the mismatch between energy demand and utilization, supercapacitors have attracted increasing attention in the energy industry. However, the development of energy storage electrode materials to be applied at the industrial level is still challenging due to the unsatisfactory durability and scalable production issues. This study suggested a facile and scalable one-pot fabrication method of using graphene/hexagonal boron nitride (G/BN)-based one-dimensional (1D) van der Waals superlattice heterostructures (vdWSLs) as highly stable electrode materials to enhance the energy storage performance by improving the mesopore volume content, specific surface area, electrical properties, and interfacial interaction between the stacked G/BN layers. The G/BN-based vdWSLs were fabricated by a simple scrolling process through the electromagnetic interaction between the attached magnetic iron oxide nanoparticles (Fe3O4 NPs) on the surface of a G/BN vdW heterostructure (vdWH) and the applied magnetic field. The investigation results demonstrate that the changed morphology of the fabricated G/Fe/BN(NS) strongly affects the fine pore distribution, electrochemical performance, and electrical properties. Consequently, as a synergistic effect of an increased mesopore volume content, specific surface area, and C-B-N heterojunction interfacial area, the fabricated G/Fe/BN(NS) electrode showed a 100% enhancement of specific capacitance (207 F g-1 at 0.5 A g-1) and almost 7 times enhancement of electrical conductivity (800 S cm-1) with a nearly 2.3 times increase of carrier mobility (716 cm2 V-1 s-1) compared to that of the G/Fe/BN electrode. Furthermore, it exhibited outstanding long-term cycling stability with almost 119% capacitance retention even after 100 000 charge-discharge cycles. These results suggest that G/Fe/BN(NS) has tremendous potential as an electrode to fabricate high-performance supercapacitors with excellent cycling stability.

Facile Synthesis of Oxygen-Doped g-C3N4 Mesoporous Nanosheets for Significant Enhancement of Photocatalytic Hydrogen Evolution Performance.

In this work, oxygen-doped g-C3N4 mesoporous nanosheets (O-CNS) were synthesized via a facile recrystallization method with the assistance of H2O2. The crystal phase, chemical composition, morphological structure, optical property, electronic structure and electrochemical property of the prepared O-CNS samples were well investigated. The morphological observation combined with the nitrogen adsorption-desorption results demonstrated that the prepared O-CNS samples possessed nanosheet-like morphology with a porous structure. Doping O into g-C3N4 resulted in the augmentation of the specific surface area, which could provide more active sites for photocatalytic reactions. Simultaneously, the visible light absorption capacity of O-CNS samples was boosted owing to the regulation of O doping. The built energy level induced by the O doping could accelerate the migration rate of photoinduced carriers, and the porous structure was most likely to speed up the release of hydrogen during the photocatalytic hydrogen process. Resultantly, the photocatalytic hydrogen production rate of the optimized oxygen-doped g-C3N4 nanosheets reached up to 2012.9 µmol·h-1·g-1, which was 13.4 times higher than that of bulk g-C3N4. Thus, the significantly improved photocatalytic behavior was imputed to the synergistic effect of the porous structure, the increase in active sites, and the enhancement of visible light absorption and charge separation efficiency. Our research highlights that the synergistic effect caused by element doping will make a great contribution to the remarkable improvement in photocatalytic activity, providing a new inspiration for the construction of novel catalysts.

Realizing the Tailored Catalytic Performances on Atomic Pt-Promoted Transition Metal Moieties Implanted Layered Double Hydroxides for Water Electrolysis.

High-performance production of green hydrogen gas is necessary to develop renewable energy generation technology and to safeguard the living environment. This study reports a controllable engineering approach to tailor the structure of nickel-layered double hydroxides via doped and absorbed platinum single atoms (PtSA) promoted by low electronegative transition metal (Mn, Fe) moieties (PtSA-Mn,Fe-Ni LDHs). We explore that the electron donation from neighboring transition metal moieties results in the well-adjusted d-band center with the low valence states of PtSA(doped) and PtSA(ads.), thus optimizing adsorption energy to effectively accelerate the H2 release. Meanwhile, a tailored local chemical environment on transition metal centers with unique charge redistribution and high valence states functions as the main center for H2O catalytic dissociation into oxygen. Therefore, the PtSA-Mn,Fe-Ni LDH material possesses a small overpotential of 42 and 288 mV to reach 10 mA·cm-2 for hydrogen and oxygen evolution, respectively, superior to most reported LDH-based catalysts. Additionally, the mass activity of PtSA-Mn,Fe-Ni LDHs proves to be 15.45 times higher than that of commercial Pt-C. The anion exchange membrane electrolyzer stack of PtSA-Mn,Fe-Ni LDHs(+,-) delivers a cell voltage of 1.79 V at 0.5 A·cm-2 and excellent durability over 600 h. This study presents a promising electrocatalyst for a practical water splitting process.