ABSTRACT
We study a hexagonal oxide KLi6TaO6 (KLTO), proposed as a Li-ion solid electrolyte, by using a recently developed screening method. First-principles calculations predict that KLTO presents a good Li-ion conductivity (σLi) and a low activation energy (Ea). Li migration is enhanced by the presence of excess Li ions in the interstitial region via a kick-out mechanism. Our experimental results demonstrate that Sn-doped KLTO presents a conductivity of 1 × 10-5 S cm-1, a σLi of 6 × 10-6 S cm-1, and a relatively low Ea of 36 kJ mol-1, which confirm the validity of the proposed screening method. Conversely, detailed analyses of the microstructure and X-ray diffraction patterns of KLTO samples indicate that a stable Li-excess condition is not achieved, therefore leaving potential improvement of the performance of KLTO as a Li-ion solid electrolyte by optimizing extrinsic doping and fabrication processes.
ABSTRACT
Photonic approaches can improve the efficiencies of photo-electrochemical devices towards CO2 reduction and fossil fuel-free societies. In a system consisting of stacked dielectric slabs having periodic holes with each slab coated by photocatalyst layers at both sides, immersed in water, we show that an incident electromagnetic field is effectively confined in the photocatalyst layers, resulting in the enhancement of the photocatalytic activities. In addition, the antireflection effect was engineered by adjusting the distances between the photonic crystal slabs. Numerical results reveal an enhancement factor of 3 for the absorption of electromagnetic fields at the operation frequency in the 3rd band of the dispersion diagram, compared to the bulk photocatalyst. Our system has the feature of periodic holes allowing the movement of reaction products. An analytical model is developed using the revised plane wave method and perturbation theory, which captures the trends observed in numerical results.
ABSTRACT
Frequency-domain optical coherence tomography (FD-OCT) is a novel technology which provides high-resolution cross-sectional images of coronary arteries. The aim of this study was to evaluate the inter-scan reproducibility of geometric FD-OCT measurements in the clinical setting. We examined 20 coronary lesions using FD-OCT. Following the FD-OCT image acquisition (1st pullback), and after the disengagement and re-engagement of the guiding catheter, an additional acquisition (2nd pullback) was performed using a new FD-OCT catheter. There was excellent correlation for minimum lumen area (r = 0.99, P < 0.001), lesion length (r = 0.99, P < 0.001) and lumen volume (r = 0.99, P < 0.001) between the 1st pullback and the 2nd pullback. The Bland-Altman test demonstrated good agreement between the 1st pullback and the 2nd pullback: the mean difference for minimum lumen area, lesion length, and lumen volume was 0.05 mm(2), 0.03 mm, and 0.70 mm(3), respectively; and the lower and upper limit of agreement for minimum lumen area, lesion length, and lumen volume was -0.58 and 0.48, -0.36 and 0.42, and -13.4 and 12.1, respectively. FD-OCT showed an excellent inter-scan reproducibility for the geometric coronary artery measurements. Our findings emphasize the value of FD-OCT as a tool for clinical longitudinal studies of coronary artery disease.
Subject(s)
Coronary Artery Disease/diagnosis , Coronary Vessels/pathology , Tomography, Optical Coherence , Aged , Female , Humans , Male , Middle Aged , Reproducibility of ResultsABSTRACT
BACKGROUND: For the identification of functionally significant coronary artery disease, there have not been any dedicated optical coherence tomography (OCT) studies reported previously, although OCT can clearly detect coronary vessel lumina at higher resolution than intravascular ultrasound (IVUS). METHODS AND RESULTS: OCT and fractional flow reserve (FFR) measurements were performed in 62 intermediate coronary lesions in 59 patients. FFR was calculated as the ratio of distal coronary pressure divided by proximal coronary pressure during maximal hyperemia. FFR <0.75 was used as the threshold for diagnosing functionally significant stenosis. Minimal lumen area (MLA), minimal lumen diameter (MLD) and percent lumen area stenosis were measured by OCT. FFR values correlated significantly with OCT-derived MLA (r=0.75, P<0.01), MLD (r=0.76, P<0.01) and percent lumen area stenosis (r=-0.77, P<0.01). Receiver-operating characteristic curve suggested an OCT-derived MLA <1.91 mm(2) (sensitivity 93.5%, specificity 77.4%), MLD <1.35 mm (sensitivity 90.3%, specificity 80.6%) and percent lumen area stenosis >70.0% (sensitivity 96.8%, specificity 83.9%) as the best cutoff values for a FFR <0.75. CONCLUSIONS: Anatomical measurements of coronary stenosis obtained by OCT show significant correlation with FFR. OCT has the potential to predict functionally significant stenosis, although the present OCT-derived parameters were smaller than those reported in previous IVUS studies.
Subject(s)
Coronary Stenosis/pathology , Coronary Stenosis/physiopathology , Coronary Vessels/pathology , Coronary Vessels/physiopathology , Fractional Flow Reserve, Myocardial , Tomography, Optical Coherence , Aged , Female , Humans , Hyperemia/pathology , Hyperemia/physiopathology , Male , Middle Aged , Ultrasonography, Interventional/methodsABSTRACT
Aims: Vulnerable coronary plaque is characterized by a large lipid core. Although commercially-available optical coherence tomography (OCT) systems use near-infrared light at 1300 nm wavelength, lipid shows characteristic absorption at 1700 nm. Therefore, we developed a novel, short wavelength infra-red, spectroscopic, spectral-domain OCT. The aim of the present study is to evaluate the accuracy of short wavelength (1700 nm) infra-red optical coherence tomography (SWIR-OCT) for identification of lipid tissue within coronary plaques. Methods and results: Twenty-three coronary arteries from 10 cadavers were imaged at physiological pressure with 2.7 Fr SWIR-OCT catheter. When a blood-free image was observed, the SWIR-OCT imaging core was withdrawn at a rate of 20 mm/s using an automatic pullback device. SWIR-OCT images were acquired at 94 frames/s and digitally archived. SWIR-OCT generated grey-scale cross sectional images and colour tissue maps of all of the plaque by using a lipid analysis algorithm. After SWIR-OCT imaging, the arteries were pressure-fixed, sliced by cryostat and stained with Oil Red O, and then corresponding histology was collected in matched images. Regions of interest, selected from histology, were 117 lipidic and 34 fibrotic/calcified regions. SWIR-OCT showed high sensitivity (89%) and specificity (92%) for identifying lipid tissue within coronary plaques. The positive predictive value and negative predictive value were 97% and 74%, respectively. Conclusion: SWIR-OCT accurately identified lipid tissue in coronary autopsy specimens. This new technique may hold promise for identifying histopathological features of coronary plaque at risk for rupture.
Subject(s)
Coronary Artery Disease/diagnostic imaging , Coronary Vessels/diagnostic imaging , Infrared Rays , Plaque, Atherosclerotic/diagnostic imaging , Tomography, Optical Coherence/methods , Aged , Aged, 80 and over , Cadaver , Coronary Artery Disease/pathology , Coronary Vessels/pathology , Cross-Sectional Studies , Female , Humans , Lipids/analysis , Male , Plaque, Atherosclerotic/pathology , Spectrum AnalysisABSTRACT
Phosphate removal from an aquatic environment was investigated using La(III)-, Ce(III)- and Fe(III)-loaded orange waste. The adsorption isotherm, the kinetics of adsorption and the effect of pH on the removal of phosphate have been examined. The % removal of phosphate using La(III)- and Ce(III)-loaded orange waste gel increases with increasing pH within the range of 5-7 but decreases when the pH is increased beyond this range. The equilibrium sorption was observed to be in accordance with Langmuir type adsorption and the maximum adsorption capacity was evaluated as 13.94 mg P/g of dry gel for all the three types of gels. Kinetic studies revealed that 15 h is enough to reach equilibrium in batch experiments. Fixed bed sorption experiments confirmed the continuous phosphate adsorption and elution capability of such simply modified gels. Due to their low cost, availability and significantly high adsorption capability, metal-loaded SOW gels can be effectively employed for the removal of phosphate from water.
ABSTRACT
EFA6D (guanine nucleotide exchange factor for ADP-ribosylation factor 6 [Arf6]D) is also known as EFA6R, Psd3, and HCA67. It is the fourth member of the EFA6 family with guanine nucleotide exchange activity for Arf6, a small guanosine triphosphatase (GTPase) that regulates endosomal trafficking and actin cytoskeleton remodeling. We propose a classification and nomenclature of 10 EFA6D variants deposited in the GenBank database as EFA6D1a, 1b, 1c, 1d, 1s, 2a, 2b, 2c, 2d, and 2s based on the combination of N-terminal and C-terminal insertions. Polymerase chain reaction analysis showed the expression of all EFA6D variants except for variants a and d in the adult mouse brain. Immunoblotting analysis with novel variant-specific antibodies showed the endogenous expression of EFA6D1b, EFA6D1c, and EFA6D1s at the protein level, with the highest expression being EFA6D1s, in the brain. Immunoblotting analysis of forebrain subcellular fractions showed the distinct subcellular distribution of EFA6D1b/c and EFA6D1s. The immunohistochemical analysis revealed distinct but overlapping immunoreactive patterns between EFA6D1b/c and EFA6D1s in the mouse brain. In immunoelectron microscopic analyses of the hippocampal CA3 region, EFA6D1b/c was present predominantly in the mossy fiber axons of dentate granule cells, whereas EFA6D1s was present abundantly in the cell bodies, dendritic shafts, and spines of hippocampal pyramidal cells. These results provide the first anatomical evidence suggesting the functional diversity of EFA6D variants, particularly EFA6D1b/c and EFA6D1s, in neurons. J. Comp. Neurol. 524:2531-2552, 2016. © 2016 Wiley Periodicals, Inc.
Subject(s)
ADP-Ribosylation Factors/biosynthesis , Alternative Splicing/physiology , Brain/metabolism , Genetic Variation/physiology , Guanine Nucleotide Exchange Factors/biosynthesis , ADP-Ribosylation Factor 6 , ADP-Ribosylation Factors/analysis , ADP-Ribosylation Factors/genetics , Animals , Brain/cytology , Brain Chemistry/physiology , Guanine Nucleotide Exchange Factors/analysis , Guanine Nucleotide Exchange Factors/genetics , Guinea Pigs , Male , Mice , Mice, Inbred C57BL , Rabbits , Subcellular Fractions/chemistry , Subcellular Fractions/metabolismABSTRACT
Enhancement of the Seebeck coefficient (S ) without reducing the electrical conductivity (sigma) is essential to realize practical thermoelectric materials exhibiting a dimensionless figure of merit (ZT=S2 x sigma x T x kappa-1) exceeding 2, where T is the absolute temperature and kappa is the thermal conductivity. Here, we demonstrate that a high-density two-dimensional electron gas (2DEG) confined within a unit cell layer thickness in SrTiO(3) yields unusually large |S|, approximately five times larger than that of SrTiO(3) bulks, while maintaining a high sigma2DEG. In the best case, we observe |S|=850 microV K-1 and sigma2DEG=1.4 x 10(3) S cm-1. In addition, by using the kappa of bulk single-crystal SrTiO(3) at room temperature, we estimate ZT approximately 2.4 for the 2DEG, corresponding to ZT approximately 0.24 for a complete device having the 2DEG as the active region. The present approach using a 2DEG provides a new route to realize practical thermoelectric materials without the use of toxic heavy elements.