Engineering the Interface of Carbon Electrocatalysts at the Triple Point for Enhanced Oxygen Reduction Reaction.

The aqueous oxygen reduction reaction (ORR) has recently received increased attention due to its critical role in clean and sustainable energy-generation technologies, such as proton exchange membranes (PEM) fuel cells, alkaline fuel cells and Zn-air batteries. The sluggish kinetics associated with ORR result from multistep electron-transfer process. The slow kinetics are partially related to the O2 adsorption process onto the catalyst, which happens at the triple-phase boundary (TPB) of the electrocatalyst-electrolyte-oxygen interface. Hence, tremendous efforts have been devoted to improving the intrinsic properties of electrocatalysts such as active sites, electrical conductivity and porosity. Engineering the electrocatalyst's interfacial properties is another critical issue in ORR, however less described in the literature. The surface of the catalyst provides the microenvironment for the triple boundary interface reaction, which directly influences its electrocatalytic activity and the kinetics. This Minireview is a summary of the existing literature on manipulating the interfacial surface of non-precious metal catalysts at the triple point between the solid catalyst, the aqueous electrolyte and the O2 gas with the aim of improving the ORR efficiency. Various approaches towards improving the wettability and nanostructuring the catalyst surface to boost the activity of the surface-active sites and provide improved stability are discussed.

Carbon-Dot-Enhanced Graphene Field-Effect Transistors for Ultrasensitive Detection of Exosomes.

Graphene field-effect transistors (GFETs) are suitable building blocks for high-performance electrical biosensors, because graphene inherently exhibits a strong response to charged biomolecules on its surface. However, achieving ultralow limit-of-detection (LoD) is limited by sensor response time and screening effect. Herein, we demonstrate that the detection limit of GFET biosensors can be improved significantly by decorating the uncovered graphene sensor area with carbon dots (CDs). The developed CDs-GFET biosensors used for exosome detection exhibited higher sensitivity, faster response, and three orders of magnitude improvements in the LoD compared with nondecorated GFET biosensors. A LoD down to 100 particles/µL was achieved with CDs-GFET sensor for exosome detection with the capability for further improvements. The results were further supported by atomic force microscopy (AFM) and fluorescent microscopy measurements. The high-performance CDs-GFET biosensors will aid the development of an ultrahigh sensitivity biosensing platform based on graphene for rapid and early diagnosis of diseases.

Preparation, fabrication and biocompatibility of novel injectable temperature-sensitive chitosan/glycerophosphate/collagen hydrogels.

This paper introduces a novel type of injectable temperature-sensitive chitosan/glycerophosphate/collagen (C/GP/Co) hydrogel that possesses great biocompatibility for the culture of adipose tissue-derived stem cells. The C/GP/Co hydrogel is prepared by mixing 2.2% (v/v) chitosan with 50% (w/w) ß-glycerophosphate at different proportions and afterwards adding 2 mg/ml of collagen. The gelation time of the prepared solution at 37°C was found to be of around 12 min. The inner structure of the hydrogel presented a porous spongy structure, as observed by scanning electron microscopy. Moreover, the osmolality of the medium in contact with the hydrogel was in the range of 310-330 mmol kg(-1). These analyses have shown that the C/GP/Co hydrogels are structurally feasible for cell culture, while their biocompatibility was further examined. Human adipose tissue-derived stem cells (ADSCs) were seeded into the developed C/GP and C/GP/Co hydrogels (The ratios of C/GP and C/GP/Co were 5:1 and 5:1:6, respectively), and the cellular growth was periodically observed under an inverted microscope. The proliferation of ADSCs was detected using cck-8 kits, while cell apoptosis was determined by a Live/Dead Viability/Cytotoxicity kit. After 7 days of culture, cells within the C/GP/Co hydrogels displayed a typical adherent cell morphology and good proliferation with very high cellular viability. It was thus demonstrated that the novel C/GP/Co hydrogel herein described possess excellent cellular compatibility, representing a new alternative as a scaffold for tissue engineering, with the added advantage of being a gel at the body's temperature that turns liquid at room temperature.

Boosting the Oxygen Reduction Electrocatalytic Performance of Nonprecious Metal Nanocarbons via Triple Boundary Engineering Using Protic Ionic Liquids.

The oxygen reduction reaction (ORR) in aqueous media plays a critical role in sustainable and clean energy technologies such as polymer electrolyte membrane and alkaline fuel cells. In this work, we present a new concept to improve the ORR performance by engineering the interface reaction at the electrocatalyst/electrolyte/oxygen triple-phase boundary using a protic and hydrophobic ionic liquid and demonstrate the wide and general applicability of this concept to several Pt-free catalysts. Two catalysts, Fe-N codoped and metal-free N-doped carbon electrocatalysts, are used as a proof of concept. The ionic liquid layer grafted at the nanocarbon surface creates a water-equilibrated secondary reaction medium with a higher O2 affinity toward oxygen adsorption, promoting the diffusion toward the catalytic active site, while its protic character provides sufficient H+/H3O+ conductivity, and the hydrophobic nature prevents the resulting reaction product water from accumulating and blocking the interface. Our strategy brings obvious improvements in the ORR performance in both acid and alkaline electrolytes, while the catalytic activity of FeNC-nanocarbon outperforms commercial Pt-C in alkaline electrolytes. We believe that this research will pave new routes toward the development of high-performance ORR catalysts free of noble metals via careful interface engineering at the triple point.

S, N-Co-Doped Graphene-Nickel Cobalt Sulfide Aerogel: Improved Energy Storage and Electrocatalytic Performance.

Metal sulfides are commonly used in energy storage and electrocatalysts due to their redox centers and active sites. Most literature reports show that their performance decreases significantly caused by oxidation in alkaline electrolyte during electrochemical testing. Herein, S and N co-doped graphene-based nickel cobalt sulfide aerogels are synthesized for use as rechargeable alkaline battery electrodes and oxygen reduction reaction (ORR) catalysts. Notably, this system shows improved cyclability due to the stabilization effect of the S and N co-doped graphene aerogel (SNGA). This reduces the rate of oxidation and the decay of electronic conductivity of the metal sulfides materials in alkaline electrolyte, i.e., the capacity decrease of CoNi2S4/SNGA is 4.2% for 10 000 cycles in a three-electrode test; the current retention of 88.6% for Co-S/SNGA after 12 000 s current-time chronoamperometric response in the ORR test is higher than corresponding Co-S nanoparticles and Co-S/non-doped graphene aerogels. Importantly, the results here confirm that the Ni-Co-S ternary materials behave as an electrode for rechargeable alkaline batteries rather than supercapacitors electrodes in three-electrode test as commonly described and accepted in the literature. Furthermore, formulas to evaluate the performance of hybrid battery devices are specified.

Investigation of the effective action distance between hematopoietic stem/progenitor cells and human adipose-derived stem cells during their in vitro co-culture.

The in vitro suitable action distance between umbilical cord blood-derived hematopoietic stem/progenitor cells and its feeder cell, human adipose-derived stem cells, during their co-culture, was investigated through a novel transwell co-culture protocol, in which the distance between the two culture chambers where each cell type is growing can be adjusted from 10 to 450 µm. The total cell number was determined with a hemacytometer, and the cell morphology was observed under an inverted microscope each day. After 7 days of co-culture, the fold-expansion, surface antigen expression of CD34(+) and CFU-GM assay of the hematopoietic mononuclear cells (MNCs) were analyzed. The results showed that there was an optimal communication distance at around 350 µm between both types of stem cells during their in vitro co-culture. By using this distance, the UCB-MNCs and CD34(+) cells were expanded by 15.1 ± 0.2 and 5.0 ± 0.1-fold, respectively. It can therefore be concluded that the optimal action distance between stem cells and their supportive cells, when cultured together for 7 days, is of around 350 µm.