Association between hypertension grades and cancer mortality among Japanese men and women.

PURPOSE: We aimed to examine the association between hypertension grades and the risk of total and site-specific cancer mortality among Japanese men and women. METHODS: In the Japan Collaborative Cohort Study, 27,332 participants aged 40-79 years were enrolled and followed up with their mortality until 2009. According to the measured blood pressure (BP) at baseline, we classified the participants into four BP categories based on 2018 European guidelines. The Cox proportional hazard models were used to calculate the multivariable hazard ratios (HRs) with 95% confidence intervals (CIs) of total and site-specific cancer mortality according to the hypertension category. RESULTS: During the 18.5 years of median follow-up, 1,927 cancer deaths were documented. Grade 1 (systolic blood pressure [SBP] 140-159 mmHg or diastolic blood pressure [DBP] 90-99 mmHg) and grade 2-3 hypertension (SBP ≥ 160 mmHg or DBP ≥ 100 mmHg) were associated with an increased risk of total cancer mortality; the multivariable HRs were 1.17 (1.04-1.32) for grade 1, and 1.27 (1.09-1.47) for grade 2-3 hypertension compared to optimal and normal BP (SBP < 130 mmHg and DBP < 85 mmHg). Linear and positive associations were observed between SBP and DBP 10 mmHg increment and the risk of total cancer mortality; HRs were 1.06 (1.03-1.08) for SBP and 1.07 (1.02-1.11) for DBP of 10 mmHg increment. The excess risk was primarily found for esophageal, liver, and pancreatic cancer; the respective multivariable HRs of grade 2-3 hypertension vs optimal and normal BP were 2.57 (1.10-6.04) for esophageal, 1.67 (1.01-2.77) for liver, and 1.95 (1.17-3.23) for pancreatic cancer. CONCLUSION: Hypertension was associated with the increased risk of total cancer mortality, primarily of esophageal, liver, and pancreatic cancer.

Effect of inflow cannula side-hole number on drainage flow characteristics: flow dynamic analysis using numerical simulation.

BACKGROUND: Venous drainage in cardiopulmonary bypass is a very important factor for safe cardiac surgery. However, the ideal shape of venous drainage cannula has not been determined. In the present study, we evaluated the effect of side-hole number under fixed total area and venous drainage flow to elucidate the effect of increasing the side-hole numbers. METHOD: Computed simulation of venous drainage was performed. Cannulas were divided into six models: an end-hole model (EH) and models containing four (4SH), six (6SH), eight (8SH), 10 (10SH) or 12 side-holes (12SH). Total orifice area of the side-holes was fixed to 120 mm2 on each side-hole cannula. The end-hole orifice area was 36.3 mm2. The total area of the side-holes was kept constant when the number of side-holes was increased. RESULT: The mean venous drainage flow rate of the EH, 4SH, 6SH, 8SH, 10SH and 12SH was 2.57, 2.52, 2.51, 2.50, 2.49, 2.41 L/min, respectively. The mean flow rate decreased in accordance with the increased number of side-holes. CONCLUSION: We speculate that flow separation at the most proximal site of the side-hole induces stagnation of flow and induces energy loss. This flow separation may hamper the main stream from the end-hole inlet, which is most effective with low shear stress. The EH cannula was associated with the best flow rate and flow profile. However, by increasing side-hole numbers, flow separation occurs on each side-hole, resulting in more energy loss than the EH cannula and flow rate reduction.