ABSTRACT
BACKGROUND: Physiologically based kinetic models facilitate the safety assessment of inhaled engineered nanomaterials (ENMs). To develop these models, high quality datasets on well-characterized ENMs are needed. However, there are at present, several data gaps in the systemic availability of poorly soluble particles after inhalation. The aim of the present study was therefore to acquire two comparable datasets to parametrize a physiologically-based kinetic model. METHOD: Rats were exposed to cerium dioxide (CeO2, 28.4 ± 10.4 nm) and titanium dioxide (TiO2, 21.6 ± 1.5 nm) ENMs in a single nose-only exposure to 20 mg/m3 or a repeated exposure of 2 × 5 days to 5 mg/m3. Different dose levels were obtained by varying the exposure time for 30 min, 2 or 6 h per day. The content of cerium or titanium in three compartments of the lung (tissue, epithelial lining fluid and freely moving cells), mediastinal lymph nodes, liver, spleen, kidney, blood and excreta was measured by Inductively Coupled Plasma-Mass Spectrometry (ICP-MS) at various time points post-exposure. As biodistribution is best studied at sub-toxic dose levels, lactate dehydrogenase (LDH), total protein, total cell numbers and differential cell counts were determined in bronchoalveolar lavage fluid (BALF). RESULTS: Although similar lung deposited doses were obtained for both materials, exposure to CeO2 induced persistent inflammation indicated by neutrophil granulocytes influx and exhibited an increased lung elimination half-time, while exposure to TiO2 did not. The lavaged lung tissue contained the highest metal concentration compared to the lavage fluid and cells in the lavage fluid for both materials. Increased cerium concentrations above control levels in secondary organs such as lymph nodes, liver, spleen, kidney, urine and faeces were detected, while for titanium this was found in lymph nodes and liver after repeated exposure and in blood and faeces after a single exposure. CONCLUSION: We have provided insight in the distribution kinetics of these two ENMs based on experimental data and modelling. The study design allows extrapolation at different dose-levels and study durations. Despite equal dose levels of both ENMs, we observed different distribution patterns, that, in part may be explained by subtle differences in biological responses in the lung.
Subject(s)
Bronchoalveolar Lavage Fluid , Cerium , Inhalation Exposure , Lung , Titanium , Animals , Titanium/toxicity , Titanium/pharmacokinetics , Cerium/toxicity , Cerium/pharmacokinetics , Tissue Distribution , Male , Lung/metabolism , Lung/drug effects , Bronchoalveolar Lavage Fluid/chemistry , Bronchoalveolar Lavage Fluid/cytology , Rats , Nanostructures/toxicity , Administration, Inhalation , Rats, Wistar , Models, Biological , Particle Size , Metal Nanoparticles/toxicityABSTRACT
Freshwater ecosystems are at significant risk of contamination by potentially toxic elements (PTEs) due to their high inherent toxicity, their persistence in the environment and their tendency to bioaccumulate in sediments and living organisms. We investigated aquatic macrophyte communities and the concentrations of As, Cu, Cd, Cr, Pb, Zn, Ni and Fe in water and sediment samples to identify a pollution pattern along the Sava River and to investigate the potential impact of these PTEs on the diversity and structure of macrophyte communities. The study, which covered 945 km of the Sava River, showed a downstream increase in sediment concentrations of the analyzed elements. Both species richness and alpha diversity of macrophyte communities also generally increase downstream. Ordinary and partial Mantel tests indicate that macrophyte communities are significantly correlated with sediment chemistry, but only weakly correlated with water chemistry. In the lowland regions (downstream), beta diversity decreases successively, which can be attributed to an increasing similarity of environmental conditions at downstream sites. Species richness is relatively low at sites with low concentrations of Cr, Cd, Fe, and Cu in the sediment. However, species richness increases to a certain extent with increasing element concentrations; as element concentrations increase further, species richness decreases, probably as a result of increased toxicity. Some species that are generally more tolerant to high concentrations of PTEs are: Ceratophyllum demersum, Iris pseudacorus, Najas marina, Butomus umbellatus, Vallisneria spiralis, Potamogeton gramineus and Bolboschoenus maritimus maritimus. Potamogeton perfoliatus and the moss species Cinclidotus fontinaloides and Fontinalis antipyretica have narrow ecological amplitudes in relation to the concentrations of PTEs in the sediment.
ABSTRACT
In healthcare facilities, infections caused by Staphylococcus aureus (S. aureus) from textile materials are a cause for concern, and nanomaterials are one of the solutions; however, their impact on safety and biocompatibility with the human body must not be neglected. This study aimed to develop a novel multilayer coating with poly(allylamine hydrochloride) (PAH) and immobilized ZnO nanoparticles (ZnO NPs) to make efficient antibacterial and biocompatible cotton, polyester, and nylon textiles. For this purpose, the coated textiles were characterized with profilometry, contact angles, and electrokinetic analyzer measurements. The ZnO NPs on the textiles were analyzed by scanning electron microscopy and inductively coupled plasma mass spectrometry. The antibacterial tests were conducted with S. aureus and biocompatibility with immortalized human keratinocyte cells. The results demonstrated successful PAH/ZnO coating formation on the textiles, demonstrating weak hydrophobic properties. Furthermore, PAH multilayers caused complete ZnO NP immobilization on the coated textiles. All coated textiles showed strong growth inhibition (2-3-log reduction) in planktonic and adhered S. aureus cells. The bacterial viability was reduced by more than 99%. Cotton, due to its better ZnO NP adherence, demonstrated a slightly higher antibacterial performance than polyester and nylon. The coating procedure enables the binding of ZnO NPs in an amount (<30 µg cm-2) that, after complete dissolution, is significantly below the concentration causing cytotoxicity (10 µg mL-1).
ABSTRACT
Prosthetic liners are mainly used as an interface between residual limbs and prosthetic sockets to minimize physical and biological damage to soft tissue. However, the closed and moist conditions within liners and the amputee's skin provide a suitable environment for bacterial growth to cause infections. This study aimed to coat a comprehensive variant material with copper oxide nanoparticles (CuO NPs) and compare their surface analysis and antibacterial properties. These materials were covered with CuO NPs solution at a concentration of 70 µg mL-1 to achieve this purpose. After drying, their surface characteristics were analyzed by measuring zeta potential, contact angle, surface roughness, and fiber arrangement. Cu-released concentration from the coatings into the acetate buffer solution by inductively coupled plasma mass spectrometry indicated that lycra and nylon quickly released Cu ions to concentrations up to â¼0.2 µg mL-1 after 24 h, causing low metabolic activity of human bone-marrow mesenchymal stem cells (bMSC) in the indirect assay. Antibacterial activity of the coated specimens was evaluated by infecting their surfaces with the Gram-positive bacteria Staphylococcus epidermidis, reporting a significant â¼40 % reduction of metabolic activity for x-dry after 24 h; in addition, the number of viable bacterial colonies adhered to the surface of this material was reduced by â¼23 times in comparison with non-treated x-dry that were visually confirmed by scanning electron microscope. In conclusion, CuO NPs x-dry shows optimistic results to pursue further experiments due to its slow speed of Cu release and prolonged antibacterial activity, as well as its compatibility with human cells.