ABSTRACT
A novel green-light-emitting silicon-based oxynitride phosphor Ca4Y3Si7O15N5:Eu2+ with low thermal quenching and ideal pressure sensitivity is reported. The Ca3.99Y3Si7O15N5:0.01Eu2+ phosphor can be efficiently excited by 345 nm ultraviolet light and shows very low thermal quenching (integrated and peak emission intensities at 373 and 423 K were 96.17, 95.86, and 92.73, 90.66% of those at 298 K, respectively). The correlation between high thermal stability and structural rigidity is investigated in detail. The white-light-emitting diode (W-LED) is assembled by depositing the obtained green-light-emitting phosphor Ca3.99Y3Si7O15N5:0.01Eu2+ and commercial phosphors on a ultraviolet (UV)-emitting chip (λ = 365 nm). The CIE color coordinates, color rendering index (Ra), and corrected color temperature (CCT) of the obtained W-LED are (0.3724, 0.4156), 92.9, and 4806 K, respectively. In addition, when subjected to in situ high-pressure fluorescence spectroscopy, the phosphor exhibits an evident red shift of 40 nm with an increase in pressure from 0.2 to 32.1 GPa. The phosphor has the advantage of high-pressure sensitivity (dλ/dP = 1.13 nm GPa-1) and visualization with pressure changes. The possible reasons and mechanisms are deeply discussed in detail. Based on the above advantages, Ca3.99Y3Si7O15N5:0.01Eu2+ phosphor is expected to have potential applications in W-LEDs and optical pressure sensing.
ABSTRACT
This work proposes a new type of Eu2+, Ce3+, Mn2+ codoped strategy that can be adapted to both ultraviolet (UV) and blue chips to achieve high-quality white light illumination. Primarily, the target sample was confirmed by X-ray diffraction (XRD) and Rietveld refinement, and the surface morphology and element distribution were observed by scanning electron microscopy (SEM). Second, the energy transfer behavior and mechanism were determined by studying double-doped samples. Lu2Mg2Al2Si2O12: Eu2+,Ce3+ (LMAS: Eu2+,Ce3+) can realize an emission color adjustment from blue to yellow. The emission color of LMAS: Ce3+,Mn2+ can be adjusted from light yellow to orange yellow. Afterward, the triple-doped sample exhibits full-spectrum emission under the excitation at 365 nm, and yellow emission under the excitation at 450 nm. When combined with a 365 nm chip, the obtained light-emitting diode (LED) devices can achieve warm white light with a color rendering index (Ra) of 96.6, light emission (LE) of 1.79 lm/W, and correlated color temperature (CCT) of 4874 K. When this phosphor was combined with a 460 nm chip, cold white light with Ra = 70, LE = 13.57 lm/W, and CCT = 5782 K can be achieved. Finally, according to the properties of the phosphor, a conceptual diagram of a new type parallel device was designed, which can easily and effectively realize the conversion of cold and warm white light. This work provides a new idea for the design of single-substrate white light phosphor and proposes a new parallel device concept, which is expected to be applied in the field of lighting.
ABSTRACT
Color-tunable phosphors can be obtained through codoping strategies and energy transfer regulation. Ce3+ and Eu2+ are the most common and effective activator ions used in phosphor materials. However, the energy transfer from Eu2+ to Ce3+ is rarely reported. In this work, Y2Mg2Al2Si2O12(YMAS):Eu2+,Ce3+ phosphors were successfully synthesized, which was confirmed by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), Rietveld refinement, scanning electron microscopy (SEM) and element mapping images, and spectral information. The luminescent color of YMAS:Eu2+,Ce3+ phosphors could be tuned from blue to cyan to light green to yellow-green and finally to green-yellow, which was achieved by adjusting the energy transfer between different dopants. The energy transfer from Eu2+ to Ce3+ was confirmed by photoluminescence spectra and fluorescence decay curves. Within the experimental gradient, the energy transfer efficiency could reach up to 48%. At 373 K, the Y1.99Mg1.99Al2Si2O12:0.01Eu2+,0.01Ce3+ (YMAS:0.01Eu2+,0.01Ce3+) phosphor exhibited a total integral emission loss of only 8%, and the emission peak intensity decreased to 95%, indicating the excellent thermal stability. The white light-emitting diode (WLED) fabricated by the YMAS:0.01Eu2+,0.01Ce3+ phosphor has the same level correlated color temperature (CCT = 5841 K), greatly improved color rendering index (Ra = 87.8), and higher quality white light color (CIE = (0.3258, 0.3214)) than the WLED made by the YMAS:0.01Eu2+ phosphor, indicating that the performance of the phosphor was significantly improved by introducing Ce3+. This work provides an effective guide for the design and development of highly efficient color-tunable phosphors involving energy transfer from Eu2+ to Ce3+ in some specific materials, such as garnet structures.
ABSTRACT
Addressing the challenge of efficiently solving multi-objective optimization problems (MOP) and attaining satisfactory optimal solutions has always posed a formidable task. In this paper, based on the chicken swarm optimization algorithm, proposes the non-dominated sorting chicken swarm optimization (NSCSO) algorithm. The proposed approach involves assigning ranks to individuals in the chicken swarm through fast non-dominance sorting and utilizing the crowding distance strategy to sort particles within the same rank. The MOP is tackled based on these two strategies, with the integration of an elite opposition-based learning strategy to facilitate the exploration of optimal solution directions by individual roosters. NSCSO and 6 other excellent algorithms were tested in 15 different benchmark functions for experiments. By comprehensive comparison of the test function results and Friedman test results, the results obtained by using the NSCSO algorithm to solve the MOP problem have better performance. Compares the NSCSO algorithm with other multi-objective optimization algorithms in six different engineering design problems. The results show that NSCSO not only performs well in multi-objective function tests, but also obtains realistic solutions in multi-objective engineering example problems.
ABSTRACT
Excellent luminous performance and high color rendering are the keys to white light-emitting diode (WLED) illumination. This work reports a single-phase full-visible-spectrum Y2Mg2Al2Si2O12(YMAS):Eu2+,Mn2+ phosphor for WLEDs with ultra-high color rendering. The luminescence of a single Mn2+ doped YMAS phosphor is very weak due to the spin-forbidden transition of Mn2+, while it can be dramatically enhanced in the YMAS:Eu2+,Mn2+ system through efficient energy transfer from the sensitizer Eu2+. Meanwhile, the luminescent color of this phosphor can be tuned from cyan to cold white, to warm white, and finally close to the yellow region by controlling the activator concentration and energy transfer process. Its good thermal and chromaticity stability meet the requirements of application in WLEDs. Its stable photochromic performance at different excitation wavelengths (365-395 nm) indicates that it can be used in different ultraviolet chips. The YMAS:0.03Eu2+,0.30Mn2+ phosphor-converted WLED achieves an ultra-high color rendering index (Ra = 93.3), near-standard chromaticity coordinates (CIE = (0.3343, 0.3388)) and a suitable correlated color temperature (CCT = 5417 K).