ABSTRACT
Despite benefits such as lower water and working volume requirements, thermophilic high solids anaerobic digestion (THSAD) often fails due to the rapid build-up of volatile fatty acids (VFAs) and the associated drop in pH. Use of conductive materials (CM) can promote THSAD through stimulation of direct interspecies electron transfer (DIET), while the need for their constant dosing due to poor separation from effluent impairs economic feasibility. This study used an approach of spatially separating magnetite and granular activated carbon (GAC) from the organic fraction of municipal solid waste (OFMSW) in a single reactor for THSAD. GAC and magnetite addition could both mitigate the severe inhibition of methanogenesis after VFAs build-up to â¼28-30 g/L, while negligible methane production was observed in the control group. The highest methane yield (286 mL CH4/g volatile solids (VS)) was achieved in magnetite-added reactors, while the highest maximum CH4 production rates (26.38 mL CH4/g VS/d) and lowest lag-phase (2.83 days) were obtained in GAC-added reactors. The enrichment of GAC and magnetite biofilms with various syntrophic and potentially electroactive microbial groups (Ruminiclostridium 1, Clostridia MBA03, Defluviitoga, Lentimicrobiaceae) in different relative abundances indicates the existence of specific preferences of these groups for the nature of CM. According to predicted basic metabolic functions, CM can enhance cellular processes and signals, lipid transport and metabolism, and methane metabolism, resulting in improved methane production. Rearrangement of metabolic pathways, formation of pili-like structures, enrichment of biofilms with electroactive groups and a significant improvement in THSAD performance was attributed to the enhancement of the DIET pathway. Promising results obtained in this work due to the spatial separation of the bulk OFMSW and CM can be useful for modeling larger-scale THSAD systems with better recovery of CM and cost-effectiveness.
Subject(s)
Bioreactors , Methane , Solid Waste , Anaerobiosis , Methane/metabolism , Fatty Acids, Volatile/metabolism , Refuse Disposal/methods , Ferrosoferric Oxide/chemistryABSTRACT
The exponential generation of municipal solid waste (MSW) and landfill disposal without any treatment has increased the continuous generation of landfill leachate. Improper MSW and leachate management are contributing to environmental degradation and water and soil pollution, which must be treated. Numerous works have been conducted on leachate treatments for energy and resource recovery. This review presents a comprehensive study of leachate management in which different treatment methods are discussed to analyze the suitability of processes that can be employed to treat leachate efficiently. Further, the characteristics of leachate are examined as properties of leachate may be varied depending upon the region. Still, several challenges related to leachate management and its treatments are discussed in this study. An integrated system could be a better option for treating leachate because it contains large amounts of organic and inorganic compounds. Proper leachate management would help to recover energy and value-added products (metals).
Subject(s)
Refuse Disposal , Water Pollutants, Chemical , Solid Waste/analysis , Waste Disposal Facilities , Water Pollutants, Chemical/analysis , Water , Refuse Disposal/methodsABSTRACT
In this study, acetic acid bacteria (AAB) are isolated from fruit waste and cow dung on the basis of acetic acid production potential. The AAB were identified based on halo-zones produced in the Glucose-Yeast extract-Calcium carbonate (GYC media) agar plates. In the current study, maximum acetic acid yield is reported to be 4.88 g/100 ml from the bacterial strain isolated from apple waste. With the help of RSM (Response surface methodology) tool, glucose and ethanol concentration and incubation period, as independent variable showed the significant effect of glucose concentration and incubation period and their interaction on the AA yield. A hypothetical model of artificial neural network (ANN) was also used to compare the predicted value from RSM. Acetic acid production through the biological route can be the sustainable and clean approach to utilizing food waste in circular economy approach.
Subject(s)
Acetic Acid , Refuse Disposal , Neural Networks, Computer , Glucose , FruitABSTRACT
The performance and kinetics response of thermophilic semi-continuous dark fermentation (DF) of simulated complex carbohydrate-rich waste was investigated at various hydraulic retention times (HRT) (2, 2.5, and 3 d) and compared with data obtained from biochemical hydrogen potential assay (BHP). A culture of Thermoanaerobacterium thermosaccharolyticum was used as the inoculum and dominated both in BHP and semi-continuous reactor. Both the modified Gompertz and first-order models described the DF kinetics well (R2 = 0.97-1.00). HRT of 2.5 d was found to be optimal in terms of maximum hydrogen production rate and hydrogen potential, which were 3.97 and 1.26 times higher, respectively, than in BHP. The hydrolysis constant was highest at HRT of 3 d and was closest to the value obtained in the BHP. Overall, BHP has been shown to be a useful tool for predicting H2 potential and the hydrolysis constant, while the maximum H2 production rate is greatly underestimated.
Subject(s)
Bioreactors , Hydrogen , Fermentation , Kinetics , ClostridiumABSTRACT
Fungal pre-treatment using Pleurotus ostreatus (PO) was carried out on individual and combinations of agro-waste wheat straw (WS), rice straw (RS), and pearl millet straw (PMS) with the addition of biochar (5%,7.5% and 10%) to reduce the pre-treatment duration. Further remaining substrate known as spent mushroom substrate (SMS) was used in anaerobic digestor (AD) for estimation enhanced biomethane yield. Equal ratios of RS + WS, WS + PMS, PMS + RS, and RS + PMS + WS and biochar addition were taken for enhancing pre-treatment, PO growth and AD process. The extent of pre-treatment was recorded with the maximum lignin removal of 40.4% for RS + PMS + WS as compared to untreated counterparts and 0.5%, 2.2%, and 3.3% times more lignin removal from individual PMS, RS, and WS respectively. Addition of biochar to the substrates reduced the total pre-treatment duration by days as compared to the non-biochar substrates. Biological efficiency (BE) used for the analysis of mushroom growth varied from 51-92%. Further, the average bio-methane yield was 187 ml/gVS for SMS of PMS + WS + RS with 10% biochar indicating an increment of 83.33% from untreated SMS of PMS + WS + RS. This, higher biomethane yield was 9.35%, 22.22% and 57.14% times higher than individual SMS of PMS, RS, and WS respectively. The current study shows that biochar not only enhances the bio-methane yield but also reduces the biological pre-treatment duration and removes the dependency on one lignocellulosic biomass for energy (bio-methane) and food (mushroom) production.
ABSTRACT
The activation of direct interspecies electron transfer (DIET) by the supplementation of conductive materials is one of the effective and available methods to enhance anaerobic digestion (AD). Microorganisms that colonize the surface of these materials form biofilms, the study of which could provide new insights into the character of the DIET process and its effect on AD. The present study focused on AD performance, microbial community, as well as morphological and topological features of biofilms on various materials used to promote DIET during AD of low-concentration swine manure. The best AD characteristics were observed in stainless steel mesh (SM)/digested cow manure (CM) and polyester felt (PF)/digested sewage sludge (SS) combinations used as material/inoculum, respectively. Thus, potential methane yields in CM-SM and SS-PF were up to 26.4% and 26.2% higher compared to the corresponding controls. Microbial analysis of biofilms revealed the dominance of putatively syntrophic bacteria of the MBA03 group of the Limnochordia class in CM inoculated reactors, and syntrophic proteolytic bacteria of the genus Coprothermobacter and acetogenic Clostridium sensu stricto 1, known for their ability to carry out DIET, in SS inoculated reactors. Biofilms on non-conductive materials contained pili-like structures, which were observed only in SS inoculated reactors. Polyester felt tended to biofoul better than carbon felt, resulting in up to 2.8, 3.2 and 1.8 higher nucleic acid, extracellular polymeric substances, and total biomass content, respectively, depending on the inoculum. These results provide new insights into the different types of DIET that can occur in low-loaded AD systems with attached growth.